lumbar support CADILLAC DEVILLE 2002 8.G Owners Manual

1-2
Seats and Seat Controls
This section tells you about the power seats -- how to
adjust them, and also about the reclining front seatbacks,
memory seats, lumbar adjustments and heated seats.
Power Seats
The power seat controls
are located on the
outboard sides of the
front seat cushions.

Move the front of the seat control up or down to
adjust the front portion of the cushion.

Move the rear of the seat control up or down to
adjust the rear portion of the cushion.

Lift up or push down on the center of the seat control
to move the entire seat up or down.

To move the seat forward or rearward, slide the seat
control forward or rearward.
Four-Way Power Lumbar Control
(If Equipped)
If your vehicle has this
feature, the driver's and
passenger's seatback
lumbar support controls are
located on the outboard
sides of the seats.
Use the power seat controls first to get the proper
position, then continue with the lumbar adjustment.
To reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. Press the control up or down to raise or lower
the support mechanism.
Keep in mind that as your seating position changes, as it
may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.

1-3 Massaging Lumbar (If Equipped)
This control is located
on the outboard sides of
the front seats. With the
ignition on, briefly press
the top of the control where
it is marked AUTO to
activate the massaging
lumbar feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by briefly pressing
the bottom of the control. The lumbar support can be
adjusted during the massage cycle by moving the control
forward to increase support and rearward to decrease
support. The massage cycle will continue to run even if
the ignition is turned to OFF, unless interrupted.
Four-Way Rear Power Lumbar
(If Equipped)
Four-way lumbar support, without the massage feature,
is also available for the outboard rear seating positions.
If your vehicle has this
feature, the rear lumbar
support controls are located
on the rear door trim panels.
To activate the rear lumbar support feature, push
forward on the control to increase support or rearward to
decrease support. The lumbar control can also be moved
up and down to adjust the location of the support.

1-4 Adaptive Seat Control (Option)
The adaptive seat control is
located on the outboard side
of each front seat. It is
marked AUTO.
With the ignition in ON, first use the power seat control
to get the proper position. Then press the top of the
control where it is marked AUTO. The system will
inflate the cushion and take a reading, then
automatically deflate the cushion to a suggested level of
comfort, by distributing the pressure evenly. The
seatback and cushion will inflate to adjust to the driver's
body positioning in two to four
-minute cycles.You may still wish to further adjust the overall firmness
or softness of the seat cushion. To get to your desired
level of comfort, hold the control up to increase the
firmness, or down for less firmness. When you let go of
the control, the seat will then automatically readjust to
your desired level of comfort.
To reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. The lumbar will then automatically adjust to
your body's positioning for the duration of the trip in
two to four
-minute cycles.
If you exit the vehicle after the system has been
activated and the seat is left unoccupied for more than
two minutes, the system will deflate. You will then
need to readjust the lumbar support upon returning to
your vehicle.
To turn off the adaptive seat feature, briefly press the
bottom of the control. The seat will deflate when the
adaptive seat control or the ignition is turned off.
If your vehicle has this option, the massaging lumbar
feature is not available for your vehicle.