lumbar support CADILLAC DTS 2010 1.G Owners Manual

Power Lumbar Adjustment
The control is located on the outboard side of the seat.
Press the front or rear of the control to increase ordecrease lumbar support.
SeePower Lumbar on page 2-4.
Heated and Ventilated Seats
On vehicles with heated and ventilated seats, thecontrols are located on the front doors and the ignitionmust be on to use the feature.
z:Press to heat the seat and seatback.
+:Press to heat the seatback.
H:Press to cool the seat and seatback.
For more information seeHeated and Ventilated Seatson page 2-5.
Head Restraint Adjustment
The vehicle’s front seats have adjustable head restraintsin the outboard seating positions.
Do not drive until the head restraints for all occupantsare installed and adjusted properly.
For more information seeHead Restraints on page 2-2.
1-8

Power Lumbar
The power lumbar controlsare located on the outboardside of the front seats.
Press the front or rear of the lumbar control to increaseor decrease support. Press the top or bottom of thecontrol to raise or lower the support mechanism.
Massaging Lumbar
On vehicles with thisfeature, the switch islocated on the outboardside of the front seatsbehind the lumbar switch.
Press the switch to turn the massaging lumbar featureon. The ignition must be on for this feature to work. Themassage cycle will run for up to 10 minutes. To stopmassage, press the massaging lumbar switch again orpress the power lumbar switch.
2-4

Rear Seat Pass-Through Door
Your vehicle has a pass-through door that providesaccess to the trunk from the rear seats. See “Rear SeatPass-Through Door” underTrunk on page 3-12.
Power Lumbar
Your vehicle may be equipped with four-way lumbarsupport, without the massage feature, for the outboardrear seat positions.
The rear lumbar supportcontrols are located on therear doors in front of theheated seat buttons.
To turn on the lumbar support feature, press the front ofthe control to increase support or rearward to decreasesupport. The lumbar control can also be moved upand down to adjust the location of the support.
2-11