clock CADILLAC ELDORADO 1994 10.G User Guide

Downloaded from www.Manualslib.com manuals search engine r
i-
I- !
r
r
While.-refueling, hang
the cap inside the fuel
door.
To take off the cap, turn it slowly to the left (counterclockwise).
,. . .. . .. . .. . ..
When you put the cap back on, turn it to the right until you hear a
clicking noise.
NOTICE:
If you need a new cap, be sure to get the right type. Your dealer
can get one
for you. If you get the wrong type, it may not fit and
your he1 tank and emissions system might be damaged.
249

Downloaded from www.Manualslib.com manuals search engine To remove, turn the oil fill cap counterclockwise.
Just fill it enough to put the level. somewhere in the proper operating
range. Push the dipstick all the way back in when you’re through.
What Kind of Oil to Use
Beginning midyear 1993, oils of the proper quality for your vehicle will be
identified with this new “starburst” symbol. The “starburst” symbol
indicates that the oil has been certified by the American Petroleum
Institute (API), and is suitable for use in your gasoline engine.
You should look for this on the front of the oil container, and use only
oils that display this new symbol.

Downloaded from www.Manualslib.com manuals search engine r
r i.
Then,. without shutting off the eyine. .. .follow . . these steps;
Tbm cap
counterclockwise
unlock cap. to
1. Pull out the
dipstick and wipe it with a clean rag or paper towel.
2. Push it back in all the way, wait three seconds and then pull it back out
again.
3. Check both sides of the dipstick, and read the lower level. The fluid
level must be in the cross-hatched area.
4. If the fluid level is in the acceptable range, push the dipstick back in
all the way.
r 1.
261

Downloaded from www.Manualslib.com manuals search engine r
f i
r
r
*;,. -
5. Press the bulb
housing lever,
rotate the housing
counterclockwise and remove it. Push
and rotatethe bu-lb.
counterclockwise
to
remove bulb.
Once you have replaced the burned out bulb, just reverse the \
steps
to
reassemble the taillight.
281

Downloaded from www.Manualslib.com manuals search engine CENTER HIGH MOUNTED STOP LAlMP
BULB REPUCEMENT
2. Twist the socket
(counterclockwise)
and remove the
socket and bulb
from the housing.
3. Replace the bulb.
Reverse the steps
to reassemble the stop lamp assembly.
282