clock CADILLAC ESCALADE EXT 2004 2.G Owner's Manual

Front Tire Flat:If the ¯at tire is on a front tire of
the vehicle, you'll need to use the jack handle (C)
and only one jack handle extension (D). Attach
the wheel wrench to the jack handle extension.
Attach the jack handle to the jack. Position the jack
on the frame behind the ¯at tire where the frame
sections overlap. Turn the wheel wrench clockwise
to raise the vehicle. Raise the vehicle far enough
off the ground so there is enough room for the spare
tire to clear the ground.Rear Tire Flat:If the ¯at
tire is on a rear tire of the
vehicle, you'll need to
use the jack handle (C)
and both jack handle
extensions (D). Attach the
wheel wrench to the
jack handle extensions.
Attach the jack handle to
the jack. Use the
jacking pad provided on
the rear axle.
Turn the wheel wrench clockwise to raise the
vehicle. Raise the vehicle far enough off the ground
so there is enough room for the spare tire to
clear the ground. Front Position
Rear Position
5-91

6. After mounting the
spare, put the wheel
nuts back on with the
rounded end of the nuts
toward the wheel.
Tighten each wheel nut
by hand. Then use the
wheel wrench to tighten
the wheel nuts until the
wheel is held against
the hub.
7. Turn the wheel wrench counterclockwise to lower
the vehicle. Lower the jack completely.
8. Tighten the nuts ®rmly
in a crisscross
sequence as shown by
turning the wheel
wrench clockwise.
{CAUTION:
Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to come loose
and even come off. This could lead to an
accident. Be sure to use the correct wheel
nuts. If you have to replace them, be sure to
get new GM original equipment wheel nuts.
Stop somewhere as soon as you can and have
the nuts tightened with a torque wrench to the
proper torque speci®cation. See ªCapacities
and Speci®cationsº in the Index for wheel nut
torque speci®cation.
5-93

3. Attach the wheel wrench (H) and extensions (I)
together.4. Insert the hoist end (F)
through the hole (G) in
the rear bumper
and into the hoist
shaft.
5. Raise the tire partway upward. Make sure the
retainer is seated in the wheel opening.
6. Raise the tire fully against the underside of the
vehicle by turning the wheel wrench clockwise
until you hear two clicks or feel it skip twice. The
cable cannot be overtightened.
5-96

Secondary Latch System
Your vehicle has an underbody mounted tire hoist
assembly equipped with a secondary latch system. It's
designed to stop the spare tire from suddenly falling
off your vehicle. For the secondary latch to work,
the spare must be installed with the valve stem pointing
down. See ªStoring a Flat or Spare Tire, Jack and
Toolsº earlier in this section.
{CAUTION:
Before beginning this procedure read all the
instructions. Failure to read and follow the
instructions could damage the hoist assembly
and you and others could get hurt. Read and
follow the instructions listed below.
To release the spare tire from the secondary latch do
the following:1. Check under the vehicle to see if the cable end is
visible.
2. If the cable is not visible proceed to Step 6.
If it is visible, ®rst try to tighten the cable by turning
the wheel wrench clockwise until you hear two
clicks or feel it skip twice. You cannot overtighten
the cable.
5-98

3. Loosen the cable by turning the wrench
counterclockwise three or four turns.
4. Repeat this procedure at least two times. If the
spare tire lowers to the ground, continue with
Step 5 of ªRemoving the Spare Tire and Toolsº
earlier in this section.
5. Turn the wrench counterclockwise until
approximately six inches (15 cm) of cable is
exposed.6. Stand the wheel blocks
on their shortest ends,
with the backs
facing each other.
7. Place the bottom edge of the jack on the wheel
blocks, separating them so that the jack is
balanced securely.
5-99

8. Attach the jack handle, extension, and wheel
wrench to the jack and place it (with the wheel
blocks) under the vehicle towards the front of the
rear bumper. Position the center lift point of the jack
under the center of the spare tire.
9. Turn the wrench clockwise to raise the jack until it
lifts the end ®tting.
10. Continue raising the jack until the spare tire stops
moving upward and is held ®rmly in place. The
secondary latch has released and the spare tire is
balancing on the jack.
5-100

11. Lower the jack by turning the wheel wrench
counterclockwise. Keep lowering the jack until the
spare tire slides off the jack or is hanging by
the cable.
{CAUTION:
Someone standing too close during the
procedure could be injured by the jack. If the
spare tire does not slide off the jack
completely, make sure no one is behind you or
on either side of you as you pull the jack out
from the spare.
12. Disconnect the jack handle from the jack and
carefully remove the jack. Use one hand to push
against the spare while ®rmly pulling the jack out
from under the spare tire with the other hand.
If the spare tire is hanging from the cable, insert the
hoist handle, extension and wheel wrench into
the hoist shaft hole in the bumper and turn
the wheel wrench counterclockwise to lower the
spare the rest of the way.13. Tilt the retainer at the
end of the cable and
pull it through the
wheel opening. Pull the
tire out from under
the vehicle.
14. If the cable is hanging under the vehicle, turn
the wheel wrench clockwise to raise the cable
back up.
Have the hoist assembly inspected as soon as you can.
You will not be able to store a spare or ¯at tire using
the hoist assembly until it has been replaced.
To continue changing the ¯at tire, see ªRemoving the
Flat Tire and Installing the Spare Tireº earlier in
this section.
5-101

A
Accessory Power Outlets.................................3-23
Adding Washer Fluid.......................................5-37
Additional Program Information........................... 7-8
Additives, Fuel................................................. 5-5
Add-On Electrical Equipment...........................5-111
Add-On Equipment..........................................4-53
Adjustable Throttle and Brake Pedal..................2-32
Adjusting the Speakers (Balance/Fade)..............3-72
After Off-Road Driving.....................................4-30
Air Bag
Passenger Status Indicator...........................3-36
Readiness Light..........................................3-36
Air Bag Systems.............................................1-48
Adding Equipment to Your Air Bag-Equipped
Vehicle...................................................1-60
How Does an Air Bag Restrain?....................1-54
Passenger Sensing System...........................1-56
Servicing Your Air Bag-Equipped Vehicle.........1-60
What Makes an Air Bag In¯ate?....................1-53
What Will You See After an Air Bag
In¯ates?..................................................1-54
When Should an Air Bag In¯ate?...................1-52
Where Are the Air Bags?..............................1-50Air Cleaner/Filter, Engine.................................5-16
Air Conditioning..............................................3-29
Airbag Sensing and Diagnostic Module (SDM)...... 7-8
All-Wheel Drive...............................................5-48
All-Wheel Drive (AWD) System.........................2-36
AM .............................................................3-100
Analog Clock..................................................3-24
Antenna, Fixed Mast......................................3-102
Antenna, XMŸ Satellite Radio Antenna
System.....................................................3-102
Anti-lock Brake System..................................... 4-7
Anti-Lock Brake System Warning Light...............3-41
Appearance Care..........................................5-102
Care of Safety Belts...................................5-105
Chemical Paint Spotting..............................5-108
Cleaning the Inside of Your Vehicle..............5-103
Cleaning the Outside of Your Vehicle............5-105
Finish Damage..........................................5-108
Sheet Metal Damage..................................5-108
Underbody Maintenance.............................5-108
Vehicle Care/Appearance Materials...............5-109
Weatherstrips............................................5-105
Approaching a Hill..........................................4-22
Ashtrays........................................................3-23
Audio Output..................................................3-91
1

Child Restraints
Child Restraint Systems...............................1-34
Infants and Young Children...........................1-30
Lower Anchorages and Top Tethers for
Children (LATCH System)..........................1-40
Older Children.............................................1-28
Securing a Child Restraint Designed for the
LATCH System........................................1-42
Securing a Child Restraint in a Rear Seat
Position..................................................1-42
Securing a Child Restraint in the Right Front
Seat Position...........................................1-44
Top Strap...................................................1-38
Top Strap Anchor Location............................1-39
Where to Put the Restraint...........................1-37
Chime Level Adjustment.................................3-102
Cigarette Lighter.............................................3-23
Cleaning
Inside of Your Vehicle.................................5-103
Outside of Your Vehicle..............................5-105
Underbody Maintenance.............................5-108
Video Screen............................................3-102
Weatherstrips............................................5-105
Cleaning Aluminum or Chrome-Plated
Wheels.....................................................5-107
Cleaning Exterior Lamps/Lenses......................5-106
Cleaning Fabric/Carpet...................................5-103
Cleaning Glass Surfaces................................5-104Cleaning Interior Plastic Components...............5-104
Cleaning Leather...........................................5-103
Cleaning the Mirror.........................................2-45
Cleaning the Speaker Covers..........................5-104
Cleaning the Top of the Instrument Panel.........5-104
Cleaning the Windshield and Wiper Blades.......5-107
Cleaning Tires..............................................5-108
Cleaning Vinyl..............................................5-103
Cleaning Wood Panels...................................5-104
Climate Control System
Automatic...................................................3-24
Climate Controls Personalization....................3-32
Outlet Adjustment........................................3-32
Clock............................................................3-24
Compass Calibration.......................................2-45
Compass Variance..........................................2-44
Content Theft-Deferrent....................................2-27
Control of a Vehicle.......................................... 4-5
Coolant
Engine Temperature Gage............................3-42
Heater, Engine............................................2-32
Surge Tank Pressure Cap.............................5-25
Cooling System..............................................5-28
Cruise Control................................................3-11
Cruise Control Light........................................3-47
Cupholder(s)..................................................2-54
Current and Past Model Order Forms................7-12
4