lock CADILLAC ESCALADE EXT 2008 3.G Workshop Manual
[x] Cancel search | Manufacturer: CADILLAC, Model Year: 2008, Model line: ESCALADE EXT, Model: CADILLAC ESCALADE EXT 2008 3.GPages: 496, PDF Size: 7.02 MB
Page 148 of 496

To remove a cargo panel(s), do the following:
1. Lower the tailgate. SeeTailgate on page 2-23
for more information on the tailgate.
Before removing the cargo panel(s), notice the
numbers embossed on the upper center portion
of each panel. The panels are labeled 1, 2 and 3.
Corresponding numbered labels are also on
the bottom of the panels. These numbers on the
top and bottom of the panels will be used as
reference in the steps for removing, storing and
reinstalling the panels.2. Remove cargo panel 3 by pulling the left and right
cargo panel latches, located on the bottom of
each cargo panel, toward you to unlock the cargo
panel latches.
3. Pull the cargo panel up and then out from the side
rails and set it aside. You only need to remove
as many cargo panels as needed for your cargo
carrying needs.
2-70
Page 150 of 496

Cargo Panel Storage System
The three cargo panels can be stored in the cargo area
using the storage strap system. To store the panels,
do the following:1. Secure the storage
strap system in the
cargo storage area
by attaching the
six clips on the cargo
strap system to
the tie down locations
on either side of
the storage area.
Always use the storage strap system to store the
cargo panels during driving.
Before storing the cargo panels, be sure that their
latches are in the locked position. The latches are
in the locked position when they are parallel to
the front and back edge of the panel.
2-72
Page 154 of 496

7. Close both cross locks at the center of the strap
system to secure tightly.
Panels 3, 2, 1 Loaded
2-76
Page 155 of 496

Reinstalling the Cargo Cover Panels
To reinstall a cargo panel do the following.
1. You can either leave the strap system attached
to the side of the cargo area while it is not in
use, or you can store it inside the top box
storage compartment. SeeTop-Box Storage
on page 2-86for more information.
2. Starting with cargo panel 1, place the latches in
the unlocked position. Place cargo panel 1 on
the cargo area rails while holding the back of
the cargo panel up.Push the panel forward until it is snug against
the Midgate
®and then let the back of the
panel down being sure that the pegs align with
the receivers.
Left Side Shown, Right Side Similar
2-77
Page 156 of 496

3. Push both left latches away from you to lock the
latches. Remember that there are four latches
total for panel 1. You should hear a click when
each latch locks correctly. Lock the remaining
two right latches on panel 1.
The left latch on the cargo covers must be locked
in place before you can lock the right latch. If you
do not follow this exactly, the cargo cover panels
may not lock in place correctly.4. Install cargo cover 2 next. Place the latches in
the unlocked position. Place the cargo cover
panel on the cargo area rails while holding the
back of the cargo panel up.
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-78
Page 157 of 496

5. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks correctly.
6. Install cargo cover 3 next. Place the latches in
the unlocked position. Place the cargo cover
panel on the cargo area rails while holding the
back of the cargo panel up.Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-79
Page 158 of 496

7. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks correctly.
Folding and Storage of Straps
To store the folding straps inside the top box storage
compartment, do the following:
1. Extend the six strap ends on a at surface.
2-80
Page 161 of 496

Maintenance and Cleaning
To ensure that the water management system performs
properly, be sure that the Midgate®, tailgate and
cover system are fully closed and that all parts
are clean and not blocked with debris. Follow the
instructions given next in this section for the proper
procedures on cleaning each item.
Top Drain Grates – Removal and
Cleaning
The top drain grates are located near the rear glass on
both sides of the vehicle. Clean the grates and drains
if there is a blockage.To remove each drain grate, do the following:
1. Remove the cargo panels. SeeCargo Cover Panels
on page 2-69for more information.
2. Grasp the edges of the grate and pull it out from
the vehicle. Flush the drain with clean water.
2-83