automatic transmission CADILLAC ESCALADE HYBRID 2012 User Guide

Black plate (6,1)Cadillac Escalade Hybrid - 2012
10-6 Vehicle Care How to Check Automatic
Transmission Fluid Notice: Too much or too
little fluid can damage the
transmission. Too much can
mean that some of the fluid could
come out and fall on hot engine
parts or exhaust system parts,
starting a fire. Too little fluid
could cause the transmission to
overheat. Be sure to get an
accurate reading if checking the
transmission fluid.
Before checking the fluid level,
prepare the vehicle as follows:
1. Start the engine and park the
vehicle on a level surface. Keep
the engine running.
2. Apply the parking brake and
place the shift lever in P (Park).
3. With your foot on the brake
pedal, move the shift lever
through each gear range,
pausing for about three seconds
in each range. Then, move the
shift lever back to P (Park). 4. Allow the engine to idle
(500 – 800 RPM) for at least
one minute. Slowly release the
brake pedal.
5. Keep the engine running and
press the Trip/Fuel button or
trip odometer reset stem until
TRANS TEMP (Transmission
Temperature) displays on the
Driver Information Center (DIC).
6. Using the TRANS TEMP
reading, determine and perform
the appropriate check
procedure. If the TRANS TEMP
reading is not within the required
temperature ranges, allow the
vehicle to cool, or operate the
vehicle until the appropriate
transmission fluid temperature is
reached. Cold Check Procedure
Use this procedure only as a
reference to determine if the
transmission has enough fluid
to be operated safely until a hot
check procedure can be made.
The hot check procedure is the
most accurate method to check the
fluid level. Perform the hot check
procedure at the first opportunity.
Use this cold check procedure
to check fluid level when the
transmission temperature is
between 24°C and 34°C
(75°F and 93°F).
1. Locate the transmission dipstick
at the rear of the engine
compartment, on the passenger
side of the vehicle.

Black plate (30,1)Cadillac Escalade Hybrid - 2012
10-30 Vehicle Care If the vehicle's 12 ‐ volt battery has
run down, you may want to use
another vehicle and some jumper
cables to start your vehicle. Use the
following steps to do it safely.
{ WARNINGBatteries can hurt you. They can
be dangerous because: .
They contain acid that can
burn you. .
They contain gas that can
explode or ignite. .
They contain enough
electricity to burn you.
If you do not follow these steps
exactly, some or all of these
things can hurt you.
Notice: Ignoring these steps
could result in costly damage to
the vehicle that would not be
covered by the warranty. Trying to start the vehicle by
pushing or pulling it will not
work, and it could damage the
vehicle.
1. Check the other vehicle. It must
have a 12 ‐ volt battery with a
negative ground system.
Notice: Only use a vehicle that
has a 12-volt system with a
negative ground for jump
starting. If the other vehicle does
not have a 12-volt system with a
negative ground, both vehicles
can be damaged.
2. Get the vehicles close enough
so the jumper cables can reach,
but be sure the vehicles are not
touching each other. It could
cause a ground connection you
do not want. You would not be
able to start your vehicle, and
the bad grounding could damage
the electrical systems.
To avoid the possibility of the
vehicles rolling, set the parking
brake firmly on both vehicles
involved in the jump start procedure. Put the automatic
transmission in P (Park) or
a manual transmission in
N (Neutral) before setting the
parking brake. If you have a
four-wheel-drive vehicle, be sure
the transfer case is in a drive
gear, not in N (Neutral).
Notice: If any accessories are left
on or plugged in during the jump
starting procedure, they could be
damaged. The repairs would
not be covered by the vehicle
warranty. Whenever possible,
turn off or unplug all accessories
on either vehicle when jump
starting the vehicle.
3. Turn off the ignition on both
vehicles. Unplug unnecessary
accessories plugged into the
cigarette lighter or the accessory
power outlets. Turn off the radio
and all the lamps that are not
needed.
This avoids sparks and helps
save both batteries. It could
save the radio!

Black plate (2,1)Cadillac Escalade Hybrid - 2012
12-2 Technical Data
Vehicle Data Capacities and Specifications Application Capacities
Metric English
Automatic Transmission* (Pan Removal and Filter
Replacement) 10.9 L 11.5 qt
Cooling System
Drive Motor Generator Control Module Cooling System 2.7 L 2.9 qt
6.0L V8 Engine Cooling System 17.3 L 18.3 qt
Fuel Tank 92.7 L 24.5 gal
Transfer Case Fluid 1.5 L 1.6 qt
*Transmission fluid capacity is approximate. See Automatic Transmission Fluid on page 10 ‑ 5 for information on
checking fluid level.
All capacities are approximate. Recheck fluid level after filling.
Engine Specifications
Engine VIN Code Transmission Spark Plug Gap
6.0L V8 J Automatic 1.02 mm (0.040 in)

Black plate (1,1)Cadillac Escalade Hybrid - 2012
INDEX i-1
AAppearance Care
Exterior . . . . . . . . . . . . . . . . . . . . . 10-37
Automatic Transmission . . . . . . . . 9-7
Fluid . . . . . . . . . . . . . . . . . . . . . . . . . . 10-5
Manual Mode . . . . . . . . . . . . . . . . . 9-10
BBattery . . . . . . . . . . . . . . . . . . . . . . . 10-11
Jump Starting . . . . . . . . . . . . . . . 10-29
Voltage and Charging
Messages . . . . . . . . . . . . . . . . . . . . 5-6
Brakes
Regenerative Braking . . . . . . . . . 9-15
System Messages . . . . . . . . . . . . . 5-6 C Canadian Vehicle Owners . . . . . . . . . ii
Capacities and
Specifications . . . . . . . . . . . . . . . . 12-2
Charging System Light . . . . . . . . . 5-4
Circuit Breakers . . . . . . . . . . . . . . 10-13
Cleaning
Exterior Care . . . . . . . . . . . . . . . 10-37
Climate Control Systems . . . . . . . 8-1
Air Conditioning . . . . . . . . . . . . . . . 8-1
Heating . . . . . . . . . . . . . . . . . . . . . . . . 8-1
Cluster, Instrument . . . . . . . . . . . . . 5-2
Compressor Kit, Tire
Sealant . . . . . . . . . . . . . . . . . . . . . . 10-22
Coolant Surge Tank
Pressure Cap, (DMCM) . . . . . . 10-8
Cooling System, (DMCM) . . . . . . 10-8 D Door
Ajar Messages . . . . . . . . . . . . . . . . 5-6
Drive Belt Routing, Engine . . . . . 12-3
Drive Motor/Generator
Control Module (DMCM)
Coolant Surge Tank
Pressure Cap . . . . . . . . . . . . . . . . 10-8
Drive Motor/Generator
Control Module (DMCM)
Cooling System . . . . . . . . . . . . . . 10-8
Driver Information
Center (DIC) . . . . . . . . . . . . . . . . . . 5-5

Black plate (2,1)Cadillac Escalade Hybrid - 2012
i-2 INDEX
EElectrical System
Engine Compartment
Fuse Block . . . . . . . . . . . . . . . . 10-14
Fuses and Circuit
Breakers . . . . . . . . . . . . . . . . . . 10-13
Engine
Compartment Overview . . . . . . . 10-4
Coolant Heater . . . . . . . . . . . . . . . . 9-4
Drive Belt Routing . . . . . . . . . . . . 12-3
Pressure Light . . . . . . . . . . . . . . . . . 5-4
Running While Parked . . . . . . . . . 9-7
Engine Oil
Messages . . . . . . . . . . . . . . . . . . . . . 5-7
Equipment, Towing . . . . . . . . . . . . 9-17 F Flat Tire . . . . . . . . . . . . . . . . . . . . . . 10-20
Fluid
Automatic Transmission . . . . . . 10-5
Four-Wheel Drive
Transfer Case . . . . . . . . . . . . . . . 9-11
Four-Wheel Drive . . . . . . . 9-11, 10-12
Fuel Economy Gauge . . . . . . . . . . 5-3
Fuses
Engine Compartment
Fuse Block . . . . . . . . . . . . . . . . 10-14
Fuses and Circuit
Breakers . . . . . . . . . . . . . . . . . . 10-13
G Gauges
Fuel Economy . . . . . . . . . . . . . . . . . 5-3
Tachometer . . . . . . . . . . . . . . . . . . . . 5-3 H Heater
Engine Coolant . . . . . . . . . . . . . . . . 9-4
Heating and Air Conditioning . . . 8-1
High Voltage Devices and
Wiring . . . . . . . . . . . . . . . . . . . . . . . 10-13
I Infotainment . . . . . . . . . . . . . . . . . . . . 7-1
Instrument Cluster . . . . . . . . . . . . . . 5-2
Introduction . . . . . . . . . . . . . . . . . . . . . . . . ii
J Jump Starting . . . . . . . . . . . . . . . . . 10-29
L Lights
Charging System . . . . . . . . . . . . . . 5-4
Engine Oil Pressure . . . . . . . . . . . 5-4

Black plate (4,1)Cadillac Escalade Hybrid - 2012
i-4 INDEX
TTachometer . . . . . . . . . . . . . . . . . . . . . 5-3
Tires
If a Tire Goes Flat . . . . . . . . . . 10-20
Inflation Monitor System . . . . 10-17
Rotation . . . . . . . . . . . . . . . . . . . . 10-20
Sealant and
Compressor Kit . . . . . . . . . . . 10-22
Sealant and Compressor
Kit, Storing . . . . . . . . . . . . . . . . 10-29
Towing
Equipment . . . . . . . . . . . . . . . . . . . . 9-17
Recreational Vehicle . . . . . . . . 10-33
Trailer . . . . . . . . . . . . . . . . . . . . . . . . 9-16
Trailer Towing . . . . . . . . . . . . . . . . . 9-16
Transfer Case . . . . . . . . . . . . . . . . . 9-11
Transmission
Automatic . . . . . . . . . . . . . . . . . . . . . . 9-7
Fluid, Automatic . . . . . . . . . . . . . . 10-5
Messages . . . . . . . . . . . . . . . . . . . . . 5-7 U Using This Supplement . . . . . . . . . . . . ii
V Vehicle
Canadian Owners . . . . . . . . . . . . . . . ii
Messages . . . . . . . . . . . . . . . . . . . . . 5-5
Starting . . . . . . . . . . . . . . . . . . . . . . . . 9-2
Vehicle Care
Storing the Tire Sealant
and Compressor Kit . . . . . . . 10-29
Tire Pressure . . . . . . . . . . . . . . . 10-16
Voltage Devices and
Wiring . . . . . . . . . . . . . . . . . . . . . . . 10-13
W Wiring, High Voltage
Devices . . . . . . . . . . . . . . . . . . . . . 10-13