lights CADILLAC FLEETWOOD 1993 2.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine These symbols have to do with your lights:
-
'I a-
i
TURN SIGNALS I
MASTER LIGHTING
SWITCH
u
PARKING LIGHTS
A $0
n
r
HAZARD WARNING FLASHER
I FOG LAMPS
These symbols are on some of your controls:
(j
0W#W
I
WINDSHIELD
WASHER
w
n
I I
WINDSHIELD
WIPER &WASHER WINDSHIELD
DEFROSTER
r VENTILATING FAN
REAR
WINDOW
DEFOGGER I
HEADLAMP
WASHER/WIPER
4

Downloaded from www.Manualslib.com manuals search engine These symbols are used on warning and indicator lights:
I- I
I I BRAKE I
ENGINE COOLANT
TEMPERATURE I
RADIATOR COOLANT
CHARGING
I ANTILOCK BRAKE I FUEL J ENGINE OIL
PRESSURE ENGINE OIL
TEMPERATURE
Here are some other symbols you may see:
I
r RADIO SELECTOR 1 FUSE I RADIO VOLUME AIR
CONDITIONING I
-I
t
In1
TRUNK'HATCHBACK RELEASE SPEAKER
I LIGHTER
5

Downloaded from www.Manualslib.com manuals search engine SAFLlTYBELTS: THEY’RE FOR EVERYONE
This part of the manual tells you how to use safety belts properly. It also
tells you some things you should not
do with safety belts.
And it explains the Supplemental Inflatable Restraint, or “air
bag”
system.
A CAUTION:
Don’t let anyone ride where they can’t wear a safety belt
properly.
If you are in a crash and you’re not wearing a safety
belt, your injuries can be much worse.
You can hit things inside
the vehicle or be ejected from it.
You can be seriously injured or
killed. In the same crash, you might not be if you are buckled
up. Always fasten your safety belt, and check that your
passengers’ belts are fastened properly too.
1’1
-!
L
This figure lights up when you turn the key to “Run” or “Start” when
your safety belt isn’t buckled, and you’ll hear a chime, too. It’s the
reminder to buckle up.
In many states and Canadian provinces, the law says to wear safety belts.
Here’s why: They work.
You never know if you’ll be in a crash. If you do have a crash, you don’t
know if it will be a bad one.
I
n
*-
r
4’
c_
\:
12

Downloaded from www.Manualslib.com manuals search engine _m_ Power Door Locks
r
-1
Push the lower part
of the switch marked
“LOCK’ to lock all
doors at once. Push
the upper part of
the switch marked
“UNLOCK’ to unlock
all the doors.
The switch on each rear door
will lock all the doors. It won’t unlock all of
the doors
-- that’s a safety feature.
Automatic Door Locks (Option)
Just close your doors, turn on the ignition. Every time you move your
shift lever out of “P” (Park) all of the doors
will lock. And, every time you
_- stop and move your shift lever into “P” (Park), your doors will unlock. If
someone needs to get out while you’re not in “P” (Park), have that person
use the manual
or power lock. When the door is closed again, it will not
lock automatically. Just use the manual or power lock to lock the door
again.
~-
Central Door Unlocking Feature (Option)
You can unlock the doors from either front outside door lock. Hold the
key
in the turned position for a few seconds.
I__ .-
Illuminated Entry System
When you lift the door handle, the lights inside your Cadillac will go on.
.- They’ll go off when you start your engine, or when 30 seconds have
67

Downloaded from www.Manualslib.com manuals search engine r
c
r
Operation
Press this symbol to
unlock the driver's
door. Press it again
within
5 seconds to
unlock the other
doors. Pressing this
button will also
disarm the Theft
Deterrent System
and turn on the
interior lights.
Press this symbol to
lock your doors.
This also arms the
Theft Deterrent
System.
Press this symbol to
open the trunk.
0 Press this button to
turn on the interior
lights only.
Matching Transmitter(@ To Your 'Vehicle
I_ Each key chain transmitter is coded to prevent another transmitter from
unlocking your vehicle.
If a transmitter is lost or stolen, a replacement
can be purchased through your dealer. Remember to bring the remaining
transmitter with you when you go to your dealer. When the dealer
matches the replacement transmitter to your vehicle, the remaining
transmitter must also be matched.
~
71

Downloaded from www.Manualslib.com manuals search engine THEFT DETERRENT (OPTION)
If your Cadillac has this
option,
it has a theft
deterrent alarm system.
With this system, the
“SECURITY
SYSTEM” light
will
flash as you open the
door
(if your ignition is
off).
Y
h . . w . ---I.
L
This light reminds you to arm the theft deterrent system. Here’s how to
do it:
1. Open the door.
2. Lock the door with the power door lock switch or Keyless Entry
System. The “SECURITY SYSTEM” light should come on and stay
on.
3. Close all doors. The “SECURITY SYSTEM” light should go off.
If a door or the trunk is opened without the key, the alarm will go off. It I
will also go off if a door lock or the trunk lock is damaged. Your vehicle’s ,
lights will flash and the horn will sound.
Remember, the theft deterrent system won’t arm
if you lock the doors r
with a key or manual door lock. It arms only if you use a power door lock A
switch or Keyless Entry System.
Here’s how
to avoid setting off the alarm by accident:
If you don’t want to arm the theft deterrent system, the vehicle should
Always unlock a door with a key or Keyless Entry System. Unlocking a
be
locked after the doors are closed.
7
door any other way will set off the alarm.
Yi
If you set off the alarm by accident, unlock any door with your key or
Keyless Entry System. - II Y
76

Downloaded from www.Manualslib.com manuals search engine r The alarm won’t stop if you try to unlock a door any other way.
How to Test The Alarm
Roll down your window and lock your vehicle using the power door
Reach in and unlock the door using the manual lock, and open the
lock.
door. The horn will sound and your headlights will flash.
If the alarm does not sound when it should, check to see
if the horn
- works. The horn fuse may be blown. To replace the fuse, see “Fuses and
Circuit Breakers” in the Index.
To reduce the possibility of theft, always arm the theft deterrent system
- when leaving your vehicle.
PASS-KEY IIm
- Your vehicle is equipped with the PASS-Key I1 TM (Personalized
- different to arm or disarm the system. It works when you insert or remove
Automotive Security System)
theft deterrent system. PASS-Key
I1 is a
passive theft deterrent system. This means you don’t have to do anything
the
key from the ignition. PASS-Key TM uses a resistor pellet in the
ignition key that matches a decoder in your vehicle.
key, it shuts down the vehicle’s starter and fuel systems. For about three
minutes, the starter won’t work and fuel won’t go to the engine. If
__ someone tries to start your vehicle again or uses another key during this
time, the vehicle will not start. This discourages someone from randomly
trying different keys with different resistor pellets in an attempt to make
a
match.
The ignition key must be clean and dry before it’s inserted in the ignition
or the engine may not start.
If the engine does not start and and the
the ignition off.
Clean and dry the key. Wait about three minutes and try again. The
work, and the key appears to be clean and dry, wait about three minutes
and try the other ignition key. At this time, you may also want to check
- When the PASS-Key I1 TM system senses that someone is using the wrong
I_
- “PASS KEY FAULT” light comes on, the key may be dirty or wet. Turn
__ security light will remain on during this time. If the starter still won’t
77

Downloaded from www.Manualslib.com manuals search engine A green arrow on the
instrument panel will
flash in the direction of
the turn or lane
change.
If the turn signal remains on after you have driven about .5 mile (.8 km),
a reminder chime will sound until you turn the turn signal off.
To signal a lane change, just raise or lower the lever until the green arrow
starts to flash. Hold it there until you complete your lane change. The
lever will return by itself when you release it.
AS you signal a turn or a lane change, if the arrows don’t flash but just
stay on, a signal bulb may be burned out and other drivers won’t see your
turn signal.
If a bulb is burned out, replace it to help avoid an accident. If the green
arrows don’t go on at all when you signal a turn, check the fuse (see
“Fuses” in the Index) and for burned-out bulbs.
If you have a trailer towing option with added wiring for the trailer lights,
a different turn signal flasher is used. With this flasher installed, the
signal indicator will flash even if a turn signal bulb is burned out. Check
the front and rear turn signal lights regularly to make sure they are
working.
Operation of Lights
Although your vehicle’s lighting system (headlights, parking lights, side
marker lights and taillights) meet all applicable federal lighting
requirements, certain states and provinces may apply their own lighting
regulations that may require special attention before you operate these
lights. For example, some jurisdictions may require that headlights be
turned on whenever you must use your windshield wipers. In addition,

Downloaded from www.Manualslib.com manuals search engine most jurisdictions prohibit driving solely with parking lights, especially at
dawn or dusk. It is recommended that you check with
you own state or
provincial highway authority for applicable lighting regulations.
Headlight High-Low Beam
Windshield Wipers
To change the
headlights from low
beam to high or high to
low, pull the turn signal
lever all the way toward
you. Then release it.
When the high beams
are on, this blue light
on the instrument
panel also will be on.
WIPER To control the wipers, turn the band on the multifunction lever.
MIST: Turn the band to “MIST” and then release it for a single wipe
cycle. For more cycles, hold the band on MIST longer.
1 :I, U
100

Downloaded from www.Manualslib.com manuals search engine Move the Cruise
switch to
“OFF.”
(The “CRUISE”
light
will go out.)
~ ~. ..
-:
To Erase Speed Memory
When you turn off the Cruise Control or the igni
Control set speed memory is erased.
LIGHTS
I
tion, your Cruise
You’ll find the control
here.