service interval CADILLAC SEVILLE 1994 4.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine CHANGE TRANS FLUID - 47
This message will appear when it is time to replace the transaxle fluid.
See your maintenance booklet for the proper fluid and change intervals.
CHECK BRAKE FLUID - 37
This message is displayed to inform the driver that the brake reservoir fluid
level is low. Check the brake reservoir level and add as needed. Have the
brake system serviced by a Cadillac technician as soon as possible. If the
brake warning light is on, follow the directions in that section.
CHECK COOLANT LEVEL - 04
This message will appear when there is a low level of engine coolant.
Have the cooling system serviced by a Cadillac technician as soon as
possible.
CHECK FUEL GAGE - 39
This message will appear when your fuel supply is less than 4 gallons and
your display
is turned off.
CHECK OIL LEVEL - 36
This message will appear when your engine oil is approximately a quart
low.
If this message is displayed, check the oil and add as needed.
CHECK WASHER FLUID - 25
This message will appear for a few seconds indicating that you need
washer solvent.
CHANGE OIL SOON - 40
This message will appear when your engine oil is less than 10 percent or
the mileage since the last oil change is more than
6750 miles.
CHANGE ENGINE OIL - 82
This means that the life of your engine oil has expired and it should be
changed immediately. See engine oil and filter recommendations
in the
Maintenance Schedule. After an oil change, the Oil
Life Index must be
reset.
See “Oil Life Indicator” in the index on how to reset it.
CRUISE ENGAGED - 43
This message will appear for a few seconds when you select a speed to
cruise at.
146
7

Downloaded from www.Manualslib.com manuals search engine The Northstar engine is designed to minimize the need for routine
maintenance while incorporating systems to remind the driver when
service is required.
An oil life index indicator monitors ongoing operating
conditions and reminds the driver when an oil change is needed.
A low
coolant warning message keeps track of the level of this vital fluid. Direct
acting hydraulic tappets provide maintenance free zero lash operation of
the
32 valves from idle to the 6500 rpm redline. The camshafts are driven
by a
two stage roller chain assembly which is designed to provide quiet
maintenance free operation. Platinum tipped spark plugs increase the
replacement interval to
100,OO miles.
The four valves per cylinder design provides more efficient engine
breathing, resulting in higher power than comparable
two valve engines.
The induction system uses smooth thermoplastic tubes
to channel air into
the cylinders. These smooth tubes simulate the elaborate port polishing
methods used on racing engines. The shape and length
of the tubes
boosts horsepower by using sonic pressure waves created by the motion of
the inlet valves to increase the amount
of air entering each cylinder. Once
the intake charge has entered the cylinder, the centrally located spark
plug ensures fast and efficient burning of the fuel/air mixture.
This engine is designed to be very durable. The aluminum block has
cast-in-place iron cylinder liners for greater wear resistance. High
strength connecting rods support the
free floating piston pins in bronze
bushings for superior high speed performance.
The fillets of the nodular
iron crankshaft undergo a high pressure compression rolling operation to
improve their resistance to fatigue.
Quiet operation is enhanced by the use
of special materials and designs.
The front cover of the engine is stamped from laminated steel which
damps out noise. Special cam cover gasket seals isolate va1v.e train
operation. The fuel injectors are placed inside the induction system
housing to eliminate the clicking noise which
is common to other fuel
injected engines.
The Northstar engine is designed to provide years
of efficient, reliable,
satisfying operation.
319