lumbar support CADILLAC SEVILLE 2000 5.G Owners Manual

1-2
Seats and Seat Controls
This section tells you about the power seats -- how to
adjust them, and also about reclining front seatbacks,
lumbar adjustments, heated seats and head restraints.
Power Seats
The power seat controls are
located on the outboard side
of the front seat cushions.

Move the front of the seat control up or down to
adjust the front portion of the cushion.

Move the rear of the seat control up or down to
adjust the rear portion of the cushion.

Lift up or push down on center of the seat control to
move the entire seat up or down.

To move the seat forward or rearward, slide the seat
control forward or rearward.
Four Way Power Lumbar Control
(If Equipped)
If you have this feature,
the driver's and passenger's
seatback lumbar support
can be adjusted four ways
by moving a single switch
located on the side of
the seat.
To increase or decrease support, hold the switch forward
or rearward. To move the lumbar up or down, hold the
switch up or down.
Keep in mind that as your seating position changes,
as it may during long trips, so should the position of
your lumbar support. Adjust the seat as needed.

1-3 Massaging Lumbar (If Equipped)
Push or tap the lumbar control, where it is marked
AUTO, located on the outboard side of each front seat,
up for half a second to activate the massage feature.
The massage cycle will run for 10 minutes and can be
turned off by pushing the lumbar control down briefly.
The lumbar support can be adjusted during the massage
cycle by moving the switch forward to increase support
and rearward to decrease support. The massage cycle
will continue to run even if the ignition is turned to OFF,
unless interrupted.
Adaptive Seat Control (If Equipped)
The adaptive seat control is
located on the outboard side
of each front seat. Use the
power seat control first to
get the proper position.When the ignition is turned to ON, and a driver or
passenger is in the equipped seat, the adaptive seat
feature will automatically activate. The seatback and
cushion will inflate to adjust to your body's positioning
for the duration of the trip in four
-minute cycles.
To reshape the lower seatback, press the lumbar
control forward to increase support and rearward to
decrease support.
To turn off the adaptive seat feature, press the control
down. The seat will deflate when the adaptive seat
control or the ignition is turned off.
Adaptive Massage (If Equipped)
Push the lumbar control, where it is marked AUTO,
located on the outboard side of each front seat, up for
half a second to activate the massage feature. The
massage cycle will run for 5 minutes and can be turned
off by pushing the lumbar control down briefly. The
lumbar support can be adjusted during the massage
cycle by moving the switch forward to increase support
and rearward to decrease support.