center console CHEVROLET AVEO 2002 Service Owner's Manual

Removal Procedure
Fig. 22: View of Rear Rocker Trim Panel and Screw
Courtesy of GENERAL MOTORS CORP.
1. Disconnect the negative battery cable.
2. Remove the left and the right rear rocker trim panels.
Refer to Door Sill Plate Replacement
- Rear .
3. Remove the bolts and the left and the right lower front seat belt anchors from the lower/center pillar.
4. Remove the left and the right lower B-pillar trim panels. Refer to Door Sill Plate Replacement
- Rear .
5. Remove the front seats. Refer to Seat Replacement
- Front Bucket in Seats.
6. Pry off the left and the right front rocker trim panels.
7. Remove the floor console. Refer to Console Replacement
- Front Floor in Instrument Panel, Gages and
Console.
8. Remove the floor carpet.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

2005 Chevrolet Aveo
2005 ACCESSORIES & EQUIPMENT Interior Trim - Aveo
Microsoft
Friday, July 31, 2009 1:08:27 PMPage 23 © 2005 Mitchell Repair Information Company, LLC.

Installation Procedure
Fig. 23: View of Rear Rocker Trim Panel and Screw
Courtesy of GENERAL MOTORS CORP.
1. Install the floor carpet.
2. Install the floor console. Refer to Console Replacement
- Front Floor in Instrument Panel, Gages and
Console.
3. Install the left and the right front rocker, trim panels.
4. Install the front seats. Refer to Seat Replacement
- Front Bucket in Seats.
5. Install the left and the right lower B-pillar trim panels. Refer to Trim Panel Replacement
- Lower
Center Pillar .
6. Install the left and the right lower front seat belt anchors to the lower/center pillar with the bolts.
Tighten: Tighten the seat belt anchor bolts to 35 N.m (26 lb ft).
7. Install the rear seatback. Refer to Seat Back Replacement
- Rear .
8. Install the left and the ri
ght rear rocker trim panels. Refer to Door Sill Plate Replacement - Rear.
NOTE: Refer to Fastener Notice in Cautions and Notices.

2005 Chevrolet Aveo
2005 ACCESSORIES & EQUIPMENT Interior Trim - Aveo
Microsoft
Friday, July 31, 2009 1:08:27 PMPage 24 © 2005 Mitchell Repair Information Company, LLC.

Fig. 59: View of Deck Lid Sill Plate Cover
Courtesy of GENERAL MOTORS CORP.
1. Install the rear deck lid sill plate cover with the plastic retaining clips.
2. Install the rear seatback. Refer to Seat Back Replacement
- Rear in Seats.
DESCRIPTION AND OPERATION
INTERIOR TRIM PANEL DESCRIPTION AND OPERATION
The interior trim panels are molded plastic and fasten with screws or plastic clips.
Pressure Relief Vent
When all the windows are closed and the ventilations system is ON, the addition of outside air to the interior of
the vehicle causes a positive pressure within the vehicle. In order to relieve the pressure, air is released through
2 pressure relief vents. The pressure relief vents are located at the rear quarter of the vehicle, behind the bumper
fascia.
Floor Console
The floor console fits over the tunnel in the floor of the vehicle and extends from under the center of the
instrument panel to the rear seat area. The front portion of the console contains the cigar lighter and the
transaxle shift lever. The rear portion of the console contains the parking brake lever, the power window
switches, if equipped, and a cupholder.
The sensin
g and diagnostic module (SDM) for the air bag system is located under the front part of the console.

2005 Chevrolet Aveo
2005 ACCESSORIES & EQUIPMENT Interior Trim - Aveo
Microsoft
Friday, July 31, 2009 1:08:28 PMPage 59 © 2005 Mitchell Repair Information Company, LLC.