brake sensor CHEVROLET CAMARO 1994 4.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine Features and Controls
vlain Light Control
’he main light control is a knob that
vorks these lights:
b Headlights
b Taillights
Parking lights
b License lights
1 Sidemarker lights
b Instrument panel lights
rurn the knob to -w- to turn on your
leadlights and ot&?operating lights.
rurn the knob to
pg to turn on your
larking lights without your headlights.
rurn the knob to
“OFF’ to turn off the
ights.
Brightness Control
This switch controls the brightness of
your instrument panel lights. Turn the
switch to brighten or dim the lights. If yo1
turn the switch all the way up to
0w,
your courtesy lights will come on.
Lights On Reminder
If you turn the ignition “Off” and leave
the lights on, you will hear a chime when
you open the driver’s door.
Daytime Running Lights (Canada)
The Canadian Federal Government has
decided that “Daytime Running Lights”
(DRL) are
a useful feature, in that DRL
can make your vehicle more visible to
pedestrians and other drivers during
daylight hours.
DRL are required on new
vehicles sold in Canada.
Your DRL work with a light sensor on top
of the instrument panel. Don’t cover it up.
The front turn signal lights will come
on
in daylight when:
The ignition is on
The headlight switch is off, and
The parking brake is released.
At dusk, the exterior lights will come
on
automatically and the front turn signal
lights will go out. At dawn, the exterior
lights will go out and the front
turn signal
lights will come on (if the headlight
switch is off).
Of course,
you may still turn on the
headlights any time you need
to.
To idle your vehicle with the DRL off, set
the parking brake while the ignition is in
the
“Off” or “LOCK’ position. Then start
the vehicle. The DRL will stay
off until
you release the parking brake.

Downloaded from www.Manualslib.com manuals search engine NOTICE:
Do not tow with sling-type equip-
ment or fascia/fog light damage
will
occur.
Use wheel
lift or car carrier equip-
ment. Additional ramping may be
required for car carrier equipment.
Use safety chains and wheel straps. Attach
a separate safety chain around
outboard end
of each lower control arm.
I
NOTICE:
I
Take care not to damage the brake
pipes and hoses or the ABS sensor
and wiring.
NOTICE:
Towing a vehicle over rough surfaces
could damage a vehicle. Damage
can occur from vehicle-to-ground
or vehicle-to-wheel-lift-equipment
contact. To help avoid damage,
install a towing dolly and raise
vehicle
until adequate clearance is
obtained between the ground and/or
wheel-lift equipment.
155 ...

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
E
F
D C B
G H J
Jnderhood Electrical Center
'uses
1 - Electronic Brake Control Module
2 - Fog Lamps (20 Amp.)
3 - Not Used
4 - Not Used
5 - Anti-Lock Brake System (5 Amp.)
6 - Coolant Fan Relays; EVAP
(5 Amp.)
Canister Purge Solenoid; Exhaust
Gas Recirculation; Low Coolant
Relay; Reverse Lockout Solenoid
( 10 Amp.)
. .230
7 - Air Injection Pump Assembly;
8 - Not Used
9 - Fuel Injectors (7.5 Amp.)
lo - Fuel Injectors (7.5 Amp.)
11 - VIN Engine Code S: Camshaft
Air Pump Relay
(20 Amp.)
Position Sensor; Crankshaft
Position Sensor; Electronic
Ignition Module
(10 Amp.)
VIN Engine Code P: Ignition
Coil; Ignition Coil Driver
(10 Amp.)
12 - Air Conditioning Compressor
Relay; Cruise Control Switches
and Module
(20 Amp.)
Relays
B - Air Conditioning Compressor
C - Anti-Lock Brake System
D - Primary Coolant Fan (Driver Side)
E - Air Pump
F - Secondary Coolant Fan
(Passenger Side)
G - ASR
H - Fog Lamps
J - Not Used