reset CHEVROLET CORVAIR 1960 1.G Owners Manual

STARTING
1. POWERGLIDE-Place control lever in N position. The
engine will not start in any other position.
THREE-SPEED-Place gearshift control lever in Neu­
tral.
2. INITIAL START -Depress accelerator to floor and
release. This presets the automatic choke.
ENGINE WARM-Hold accelerator pedal about half
open.
3. Turn ignition switch to START and release as soon
as
engine starts.
4.
"FLOODED" ENGINE-Depress accelerator to floor
and hold while cranking engine. Never "pump"
accelerator.
3 WARM-UP
Never race the engine or drive at high speeds until
the engine has had a chance to warm up. Always let
the engine idle for a minute or two after starting and
drive at moderate speeds for several
miles, especially in
cold weather. Failure to allow sufficient warm-up time
causes much unnecessary wear to the engine. Also,
excessive speeds before axle and transmission lubricant
becomes warmed up can cause harm to these parts.
DRIVING FOR ECONOMY
Proper maintenance and wise operation will com­
bine to help you achieve maximum fuel economy with
your Corvair. Your Authorized Chevrolet Dealer can
properly tune and maintain your car but wise operation
is your responsibility. Give the car sufficient warm-up
time, do not make "jack rabbit" starts or skidding stops,
and drive at reasonable speeds and as steady as traffic
permits to gain the benefits of all the economy built into
yourCorvair.