battery location CHEVROLET IMPALA 2000 8.G Owners Manual

yellowblue
2-7
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use this equipment.
At times you may notice a decrease in range. This is
normal for any remote keyless entry system. If the
transmitter does not work or if you have to stand closer
to your vehicle for the transmitter to work, try this:

Check to determine if battery replacement is
necessary. See the instructions that follow.

Check the distance. You may be too far from your
vehicle. You may need to stand closer during rainy
or snowy weather.

Check the location. Other vehicles or objects may be
blocking the signal. Take a few steps to the left or
right, hold the transmitter higher, and try again.

If you're still having trouble, see your dealer or a
qualified technician for service.Operation
Press UNLOCK once to unlock the driver's door and to
turn on the interior lamps. (See ªIllumination on Remote
Activationº in the Index for more details.).
Press UNLOCK again within five seconds to unlock the
passengers' doors. To lock all doors, press LOCK. To
release the trunk, press the trunk symbol on the remote
keyless entry (RKE) transmitter. The trunk will only
release if your transaxle is in PARK (P).
Operating the RKE transmitter may interact with the
Content Theft
-Deterrent System (if your vehicle is
equipped with this feature). See ªContent
Theft
-Deterrent Systemº in the Index.

yellowblue
2-9 Battery Replacement
Under normal use, the battery in your remote keyless
entry transmitter should last about three years.
You can tell the battery is weak if the transmitter won't
work at the normal range in any location. If you have to
get close to your vehicle before the transmitter works,
it's probably time to change the battery.
To replace your battery:
1. Insert a flat object like a dime into the slot on the
back of the transmitter. Gently pry apart the front
and back.
2. Gently pry the battery out of the transmitter. Do not
use a metal object.
3. Put the new battery into the transmitter as shown on the
transmitter (use type CR2032 battery or equivalent).
4. Put the two halves back together. Make sure the
halves are together tightly so water won't get in.
5. Resynchronize and then test the transmitter.
NOTICE:
When replacing the battery, use care not to touch any
of the circuitry. Static from your body transferred to
these surfaces may damage the transmitter.