engine CHEVROLET MALIBU 2020 Get To Know Guide

2
Memory Seat ButtonsF
Instrument Panel Illumination Control/Exterior Lamps Control
Driver Information Center
Voice Recognition Buttons/Driver Information Center Controls
Windshield Wipers Lever
Audio Next/Previous Favorite Station Controls (behind steering wheel)
Turn Signal Lever/IntelliBeam ControlF
Heated Steering WheelF/Cruise Control/Forward Collision AlertF/Lane Keep AssistF Buttons
Power Mirror/Window Switches
INSTRUMENT PANEL
Keyless (Pushbutton) Start
Audio Volume Controls (behind steering wheel)
Steering Wheel Adjustment Lever
Low Fuel
Traction Control Off
Brake System
Cruise Control
StabiliTrak Active
StabiliTrak Off
Security
Electric Parking Brake
Service Electric Parking Brake
Lights On Reminder
Airbag Readiness
Engine Oil Pressure
Check Engine
Lane Keep Assist
SYMBOLS

4
KEYLESS ACCESS SYSTEM
The Keyless Access System enables operation of the doors and trunk witho\
ut removing the Remote Keyless Entry transmitter from a pocket or purse. The transmi\
tter must be within 3 feet of a front door or within 3 feet of the trunk.
KEYLESS UNLOCKING
With the transmitter within range:
Press the button on the driver’s door han-dle to unlock the driver’s door; press it again within 5 seconds to unlock all doors.
Press the button on the front passenger’s door handle to unlock all doors.
Press the touchpad above the license plate to open the trunk.
KEYLESS LOCKING
With the ignition off, the transmitter out of the vehicle, and all doors\
closed:
Press the button on either front door handle to lock all doors immediate\
ly.
If Passive Locking is turned on, all doors will lock automatically after\
a short delay once all doors are closed.
Note: To change the door lock and unlock settings, go to Settings > Vehicle > Remote Lock, Unlock, Start.
See Keys, Doors and Windows in your Owner’s Manual.
Remote Vehicle StartF
Press and release the Lock button and then press and hold the button until the turn signal lamps flash to start the engine from outside the vehicle. After entering the vehicle, turn on the ignition.
• During a remote start, the engine will run for 15 minutes.
• Press and hold the button until the parking lamps turn off to cancel a remote start.
On hybrid models, the engine will start only if needed for warming the cabin or for high-voltage battery charging.
Lock
Press to lock all doors.
Unlock
Press to unlock the driver’s door.
Press again to unlock all doors.
Trunk
Press twice quickly to open the trunk.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle. The exterior lamps flash and the horn chirps 3 times.
Press and hold to activate the alarm. Press again to cancel the alarm.
REMOTE KEYLESS ENTRY TRANSMITTER
F Optional equipment
Note: To change the remote lock, unlock, and remote start settings, go to Settings > Vehicle > Remote Lock, Unlock, Start.
See Keys, Doors and Windows in your Owner’s Manual.

5
KEYLESS (PUSHBUTTON) START
AUTO ENGINE STOP/START OPERATION
(NON-HYBRID MODEL)
The Remote Keyless Entry (RKE) transmitter must be in the vehicle to turn on the ignition.
STARTING THE ENGINE
With the transmission in Park or Neutral, press the brake pedal and then press the ENGINE START/STOP button. The button indicator will be green.
On hybrid models, the illuminated Vehicle Ready light indicates the vehicle is ready to drive.
Note: If the RKE transmitter battery is weak, place the transmitter in the pocket in the center console to enable the engine to start. Replace the transmitter battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and press the ENGINE START/STOP button.
ACCESSORY MODE
With the engine off and the brake pedal not depressed, press the ENGINE START/STOP button. The button indicator will be amber.
See Driving and Operating in your Owner’s Manual.
A fuel-saving stop/start system has been integrated with the 1.5L four-c\
ylinder engine. While driving, when the brake is applied and the vehicle is at a complet\
e stop, the auto-matic engine stop/start system may turn off the engine, referred to as a\
n Auto Stop. In Auto Stop mode, the tachometer gauge will read AUTO STOP. The audio syst\
em, climate controls and other accessories will continue to operate. Upon releasing \
the brake pedal or applying the accelerator pedal, the engine will restart. After parkin\
g the vehicle and turning off the engine, the tachometer gauge will read OFF.
The engine may remain running or restart when the vehicle is stopped if:\
• A minimum vehicle speed is not reached.
• The engine or transmission is not at the required operating temperature.\
• The outside temperature is not in the required operating range.
• The shift lever is in any gear other than Drive (D).
• The battery charge is low.
• The climate control system requires the engine to run based on the curre\
nt settings.
• The Auto Stop has reached the maximum allowed time.
See Driving and Operating in your Owner’s Manual.

14
HYBRID OVERVIEW (IF EQUIPPED)
HYBRID FEATURES
The Malibu Hybrid has an electric drive unit integrated with the highly \
efficient 1.8-liter four-cylinder engine. This blending of electric and gasoline propulsion \
maximizes fuel economy. The system continuously adjusts the operation of the engine, hi\
gh-powered electric drive unit and trunk-mounted lithium-ion battery to provide out\
standing
performance while using significantly less fuel than a conventionally \
powered vehicle.
HYBRID OPERATION
While driving, the gasoline engine will seamlessly turn on when necessar\
y to provide power. It will turn off when not needed to save fuel.
The engine may remain running while driving when:
• Accelerating or driving up hills.
• Vehicle speed is greater than 55 mph (88 kph).
• Charging the high-voltage battery.
• Cabin warming is requested based on the climate control settings.
The engine and electric drive unit work together to provide the required\
propulsion power at the highest efficiency. This may result in higher engine spee\
ds than expected.
See Driving and Operating in your Owner’s Manual.
VEHICLE STARTING With the vehicle in Park or Neutral, press the brake pedal and then pres\
s the ENGINE START/STOP button.
The Vehicle Ready indicator will illuminate when the vehicle is ready to be \
driven. The engine will start only if required to charge the high-voltage battery or\
to warm the cabin.
In temperatures below 32°F/0°C, the engine start will be delayed w\
hile the hybrid system is initializing. The “Initializing – Wait To Shift” message wil\
l be displayed on the Driver Information Center. Wait to shift the vehicle from Park until the messag\
e is no longer displayed and the Vehicle Ready indicator is illuminated.
REGENERATIVE BRAKING
Regenerative braking captures some of the kinetic energy from the moving\
vehicle and stores it in the high-voltage battery, contributing to increased energy \
efficiency. Braking less aggressively allows for more energy recovery.
See Driving and Operating in your Owner’s Manual.

15
HYBRID LOW GEAR
Operating in Low Gear provides the ability to slow without using the bra\
kes. Vehicle operation during acceleration and cruising is not changed.
L2 (Low 2) – increased regenerative braking as the accelerator pedal is released\
.
L1 (Low 1) – maximum regenerative braking to slow the vehicle.
L (Low) – should be used when descending steep grades or in stop-and-go traffi\
c.
See Driving and Operating in your Owner’s Manual.
HYBRID DISPLAYS
Power Gauge – When accelerating or driving, the Power gauge on the instrument
cluster shows the amount of power provided by the propulsion system to propel the vehicle. When coasting or braking, it shows the amount of power provided\
by the
regenerative braking system or the conventional brakes to slow the vehic\
le. Operating the vehicle close to the zero power position during acceleration and braking will result in higher efficiency.
Efficiency Gauge – The Efficiency gauge on the instrument cluster is a guide to driving in an efficient manner. Keeping the indicator in the center of the gau\
ge indicates higher efficiency.
Drive Cycle Info – This screen on the Driver Information Center (DIC) displays the d\
is-tance traveled and average fuel economy for the current trip. The screen\
also is shown when the vehicle is turned off, displaying the information for the compl\
eted trip.
Total Power – This DIC screen provides a numeric representation of the total power being used to propel or stop the vehicle. It shows the power being provi\
ded by the high-voltage battery or charging the high-voltage battery as well as the power provided by the engine.
EV Operation – This DIC screen displays a bar that moves from left to right as th\
e driver requests more power from the propulsion system. While in electric vehicle (EV) mode, maintaining the bar in the green zone maximizes electric operation.
Power Flow – This display on the infotainment screen indicates the current hybri\
d
operating mode, the energy flow direction and the high-voltage battery\
charge level. The operating modes include Engine Power, Battery Power, Hybrid Power, and R\
egen Power Recovery.
Consumption History – This display on the infotainment screen shows the average fuel economy in 5-mile increments over the last 50 miles.
See Instruments and Controls in your Owner’s Manual.
CLIMATE CONTROL SETTINGS
The climate control settings affect the efficiency of the vehicle. To \
maximize efficiency in warm weather, operate the climate controls in the Automatic mode at t\
he highest
comfortable temperature setting or turn off the air conditioning system \
when climate conditions allow.See Climate Controls in your Owner’s Manual.
HYBRID FEATURES

16
ROADSIDE ASSISTANCE
1-800-CHEV-USA (1-800-243-8872) TTY Users: 1-888-889-2438
As the owner of a new Chevrolet, you are automatically enrolled in the C\
hevrolet Roadside Assistance program for up to 5 years/60,000 miles, whichever oc\
curs first, at no expense to you. Chevrolet’s Roadside Assistance toll-free numbe\
r is staffed by a team of trained advisors who are available 24 hours a day, 365 days a ye\
ar, to contact a
service provider for light services (fuel delivery, jump-starts, flat\
tire and lock-outs) or make arrangements to tow your vehicle to the nearest Chevrolet dealer fo\
r any repairs.
OnStar Roadside Assistance
If you have a current OnStar Safety & Security plan, push the blue OnStar button or red Emergency button to get the help you need. An OnStar advisor will use GPS technol\
ogy to pinpoint your vehicle location and contact the nearest service provid\
er.
To learn more about OnStar services, press the blue OnStar button, visit onstar.com, call 1-888-4-ONSTAR (1-888-466-7827), or refer to your Owner’s Manual.
CHEVROLET OWNER CENTER
MYCHEVROLET MOBILE APP
Get to know your vehicle inside and out with the Chevrolet Owner Center.\
Check out personalized information, including an online Owner’s Manual and help\
ful how-to videos, track your service history and warranty status, manage your OnStar and C\
onnected Services vehicle plans, review your current Vehicle Diagnostics report (\
active service required) and more. Create an account today at my.chevrolet.com.
!84313273=A!
Certain restrictions, precautions and safety procedures apply to your ve\
hicle. Please read your Owner’s Manual for complete instructions. All information contained in this guide is ba\
sed on the latest information available at the time of printing and is subject to change without notice. Copyright \
2019 General Motors. All rights reserved.
We recommend always using ACDelco or genuine GM service parts.
Download the myChevrolet app to your compatible smartphone (or device)\
and, if your vehicle is properly equipped, you can start or turn off your engine, loc\
k or unlock your doors, view key diagnostic information, set parking information and more\
.
The app is available on select Apple and Android devices. Service availa\
bility, features and functionality vary by vehicle, device and data plan. Device data con\
nection required. Visit onstar.com for more details. Download the mobile app from your compatible mobile device’s app store.
84313273 A