child seat CHEVROLET PRIZM 1998 3.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine a Section 1 Seats and Restraint Systems
Here you’ll find information about the seats in your Chevrolet and how to use your safety belts properly. You can also
learn about some things you should
not do with air bags and safety belts.
1-2 1-7
1-12
1-13
1-13
1-20
1-21
1-21 Seats
and Seat Controls
Safety Belts: They’re for Everyone
Here Are Questions Many People Ask About
Safety Belts
-- and the Answers
How to Wear Safety Belts Properly
Driver Position
Safety Belt Use During Pregnancy
Right Front Passenger Position
Air Bag Systems 1-30
1-33
1-36 1-48
1-58
1-61
1-61
1-62 Rear
Seat Passengers
Children
Built-in Child Restraint (Option)
Child Restraints
Larger Children
Safety Belt Extender
Checking Your Restraint Systems
Replacing Restraint System Parts After
a Crash

Downloaded from www.Manualslib.com manuals search engine Rear Head Restraint Removal
To remove the rear head restraints:
1. Press the release button located under the left side
of the head restraint.
2. Lift the head restraint upward.
3. Secure the head restraints in the trunk using the
tie-down straps located
on each side of the
trunk floor.
To reinstall the rear head restraints:
1. Remove the head restraints from the trunk.
2. Press and hold the release button on the seat back
while inserting the head restraint.
3. Push the head restraint down. After releasing
the button, pull on the head restraint to make sure
it is secure.
Rear Folding Seatback (If Equipped)
You can fold either side of the seatback down in your
vehicle for more cargo space. On vehicles with
a built-in
child restraint system, only the driver’s side rear
passenger seatback can be folded down. Make sure the
front seat isn’t reclined. If it is, the rear seatback won’t
fold down all the way.
A safety belt that is twisted or not properly
attached won’t provide the protection needed
in a crash.
A person wearing a twisted or not
properly attached belt could be seriously injured.
After raising the rear seatback, always check to
be sure that the safety belt is not twisted and is
properly attached.
1-5

Downloaded from www.Manualslib.com manuals search engine To fold either seatback down:
1. Remove the head restraints. See “Rear Head
Restraint Removal” earlier in this section.
2. Remove the rear center lap-shoulder belt latch by
using a key to press the release button.
3. Pull the release on the
driver’s side in the
trunk. (Repeat the
procedure for the other
side if
you do not have a
built-in child restraint.)
4. Fold the seatback down.

Downloaded from www.Manualslib.com manuals search engine How to Wear Safety Belts Properly
Adults
This part is only for people of adult size.
Be aware that there are special things to know about
safety belts and children. And there
are different
rules for smaller children and babies. If a child will
be riding in your vehicle, see the part
of this
manual called “Children.” Follow those rules for
everyone’s protection.
First, you’ll want to know which restraint systems
your vehicle has.
We’ll start with the driver position.
Driver Position
This part describes the driver’s restraint system.
Lap-Shoulder Belt
The driver has a lap-shoulder belt. Here’s how to
wear it properly.
1. Close and lock the door.
2. Adjust the seat (to see how, see “Seats” in the
Index)
so you can sit up straight.
I
3. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted.
The shoulder belt may lock if you pull the belt across
you very quickly. If this happens, let the belt go back
slightly to unlock it. Then pull the belt across you
more slowly.
4. Push the latch plate into the buckle until it clicks.
Pull
up on the latch plate to make sure it is secure.
If the belt isn’t long enough, see “Safety Belt
Extender” at the end
of this section.
1-13

Downloaded from www.Manualslib.com manuals search engine The best way to protect the fetus is to protect the
mother. When a safety belt is worn properly, it’s more
likely that the fetus won’t be hurt
in a crash. For
pregnant women, as for anyone, the key to making
safety belts effective is wearing them properly.
Right Front Passenger Positi(- -I
To learn how to wear the right front passenger’s
safety belt properly, see “Driver Position” earlier in
this section.
The right front passenger’s safety belt works the same
way as the driver’s safety belt
-- except for one thing. If
you ever pull the shoulder portion of the belt out all the
way,
you will engage the child restraint locking feature.
If this happens, just let the belt
go back all the way and
start again.
Air Bag Systems
This part explains the frontal and side impact air
bag systems.
Your vehicle has air bags
-- a “Next Generation”
reduced-force frontal air bag for
the driver and another
“Next Generation” reduced-force frontal air bag for the
right front passenger. Reduced-force frontal air bags are designed
to help reduce the risk of injury from the force
of an inflating frontal air bag. But even these air bags
must inflate
very quickly if they are to do their job and
comply with federal regulations. Your vehicle may also
have side impact air bags
-- a side impact air bag for the
driver and another side impact air bag for the right
front passenger.
If your vehicle has side impact air bags, it will say
SRS
- SIDE AIRBAG on a label on the side of the
driver’s and right front passenger’s seat closest to
the door.
1-21

Downloaded from www.Manualslib.com manuals search engine Built-in Child Restraint (Option)
If your vehicle has this option, there’s a built-in child
restraint in the right rear seat position. This child
restraint system conforms to all applicable Federal
Motor Vehicle Safety Standards. This
child restraint is designed for use only by children
who weigh between
22 and 66 pounds (10 and 30 kg)
and whose height is between 33.5 and 50 inches
(850 and
1270 mm) and who are capable of sitting
upright alone.
The child should also be
at least one year old. It is
important to use
a rear-facing infant restraint until
the child
is about a year old. A rear-facing restraint
gives the infant’s head, neck and body the support they
would need
in a crash. See “Child Restraints” later in
this section for more information.
1-36

Downloaded from www.Manualslib.com manuals search engine Q: What if the top of my child’s shoulders is above
the shoulder belt slots for the five-point child
restraint harness system?
A: A child whose shoulders are above the shoulder
belt slots for the five-point child restraint harness
system shouldn’t use this child restraint. Instead,
the child should sit on the vehicle’s seat cushion
and use the vehicle’s adult safety belts.
-
A CAUTION:
I
BEFORE YOU USE THIS CHILD RESTRAINT,
BE SURE THE TOP
OF THE CHILD’S
SHOULDERS IS BELOW THE SLOTS
THAT THE HARNESS GOES THROUGH.
A CHILD WHOSE SHOULDERS ARE
ABOVE THOSE SLOTS COULD BE
IN JURED
DURING
A SUDDEN STOP OR CRASH. IF
THE TOP OF THE CHILD’S SHOULDERS
IS ABOVE THE SLOTS, DON’T USE THIS
CHILD RESTRAINT WHILE THE VEHICLE
IS IN MOTION.
Securing a Child in the Built-in
Child Restraint
1. Remove the head restraint.
1-37

Downloaded from www.Manualslib.com manuals search engine 2. Pull the flap away from the fastener strip on the top
of the seatback and lower the child restraint cushion.
If a head restraint is not installed on the seatback
properly, it could be thrown about the vehicle in
a crash or sudden maneuver. People in the vehicle
CAUTION: (Continued)
1-38

Downloaded from www.Manualslib.com manuals search engine could be injured. Be sure the head restraint is
properly installed when using the built-in
child restraint.
3. Install the head restraint so that the front side faces
the rear
of the vehicle. Lower the head restraint so
that it touches the top of the seatback. Make sure
there is no gap between the lower edge
of the head
restraint and the top of the seatback.
1
You’ll be using the child restraint’s harness (A) to secure
your child. Don’t use the vehicle’s safety belts.
1-39

Downloaded from www.Manualslib.com manuals search engine Using the vehicle’s regular safety belts on a child
seated on the child restraint cushion can cause
serious injury to the child in
a sudden stop or
crash.
If a child is the proper size for the built-in
child restraint, secure the child using the child
~ restraint’s harness. But children who are too
~ large for the built-in child restraint should sit on
~ the vehicle’s regular seat and use the vehicle’s
adult safety belts.
WARNING! FAILURE TO FOLLOW THE
MANUFACTURER’S INSTRUCTIONS ON THE
USE
OF THIS CHILD RESTRAINT SYSTEM
CAN RESULT IN YOUR CHILD STRIKING THE
VEHICLE’S INTERIOR DURING A SUDDEN
STOP OR CRASH.
SNUGLY ADJUST
THE BELTS PROVIDED
WITH THIS CHILD RESTRAINT AROUND
YOUR CHILD.
4. Before placing the child in the child restraint, add
slack to the shoulder harness. Pull the black shoulder
harness release strap firmly.
At the same time, pull
both shoulder harness straps through the slots in the
seatback as
shown.
1-40