ABS CHEVROLET S10 1998 Owners Manual

Anti-L0c.k Brakes (ABS)
Your vehicle has anti-lock bfakes..(ABS). ABS is an
advanced. electronic braking
system that :will help
prevent a braking: skid.
When you start your engine. and begin to drive away;
yaw anti-lock brake syxiem. will check itself. You may
he’& a-momentary motor or c1icking noise whikthis test;
is goi on. This is-nomal.
I€,there.’s a problem with the
mti-lock
brake system, this
warfiing light -will :stay 13wr.
System. Warning Light’%
the
Index.
I See. “Anti-Lo-ckBrake
ProCarManuals.com

I
Here's how anti-lock works. Let's say the road is wet.
You're driving: safely. Suddenly an animal jumps out in
You slam on the brakes. Here's what happens .with ABS.
A computer-senses that wheels are slowing down. If'one,
of the wheels is about to stop. r.olling,. the-compter will
separately work the brakes. at .each- front wheel and at
both. rear -wheels.
front
of you.
_.. .
The anti-lock system can change.the brake pressure faster
than any driver could. The .computer is-programmed to
make the most o€'mailable tire .mil road conditions.
You can steer around the obstacle while braking hard,
AS you brake, your computer keeps receiving updates on
wheel speed and ~ontrols braking pressur.e accordingly.
t
ProCarManuals.com

1. Remove the headlamp assembly as-shown under
“Two-Pie-ce Composite Headlamp System” ,earlier in
this section,
2. Lacate the locking tabs
-on the assembly.
Squeeze the
tabs
together and push.that
end
of the-assembly out
while
holding the tabs.
-The assembly will
.swing .out.
3. Unplug the electrical conne-czw. 6.
7.
6-38
4.
5.
Turn the harness bulb socket to the left to remove it.
Push the new b.ulb into the socket until it. snaps
into place.
Put the new bulb
into the headlamp. lens- assembly
and turn it to the right until it is. tight.
To replace the .assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in ,and snap it into place.
ProCarManuals.com