start stop button CHEVROLET TRACKER 1993 Owners Manual

The rear seats have lap-shoulder belts.
Here’s how to wear one properly.
1. Pick up the latch plate and pull it
across you. Don’t let it get twisted.
2. Push the latch plate into the buckle
until it clicks.
When the shoulder belt
is pulled out all
the way,
it will lock. If it does, let it go
back all the way and start again.
If the belt is not long enough, see
“Safety Belt Extender” at the end
of
this section.
Make sure
the release button on the
buckle faces upward or outward so you
would be able to unbuckle
it quickly if
you ever had to.
3. To make the lap part tight, pull down
on
the buckle end of the belt as you
pull up on the shoulder part.
1
The lap part of the belt should be worn
low and snug on
the hips, just touching
the thighs. In a crash, this applies force
to the strong pelvic bones. And you’d be
less likely to slide under the lap belt. If
you slid under it, the belt would apply
force
at your abdomen. This could cause
serious or even fatal injuries. The
shoulder belt should
go over the
shoulder and across the chest. These
parts
of the body are best able to take
belt restraining forces.
The safety belt locks only
if there’s a
sudden stop or a crash, or
if you pull it
very quickly out of the retractor.
ProCarManuals.com