wheel bolts CHEVROLET TRACKER 1995 Owners Manual

11. Remove all the wheel
nuts and take off the
flat tire.
12. Remove any rust or dirt from the wheel bolts,
mounting surfaces and spare wheel. Place
the spare
on the wheel mounting surface.
ProCarManuals.com

Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted
or corroded.
If wheel nuts keep coming loose, the wheel,
wheel bolts, and wheel nuts should be replaced.
If the
wheel leaks air, replace it (except some aluminum
wheels, which can sometimes be repaired). See your
Chevrolet/Geo dealer
if any of these conditions exist.
Your dealer will know the kind of wheel you need.
Each new wheel should have the same load carrying
capacity, diameter, width, offset, and be mounted the
same way as the one it replaces.
If you need to replace any of your wheels, wheel bolts,
or wheel nuts, replace them only with new
GM original
equipment parts. This way, you will be sure to have the
right wheel, wheel bolts,
and wheel nuts for your Geo
model. I NOTICE:
The wrong wheel can also cause problems
with bearing life, brake cooling,
speedometer/odometer calibration, headlamp aim, bumper height, vehicle ground clearance,
and tire or tire chain clearance to the body and
chassis.
ProCarManuals.com

I Maintenance Schedule TI I
15,000 Miles (25 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever occurs
first).
0 Rotate tires. See “Tire Inspection and
Rotation” in the Index for proper rotation
pattern and additional information.
0 Inspect the loclung front hubs (if equipped)
for correct operation (or ever
3 months,
whichever occurs first). Repair or replace if
necessary.
0 Inspect the valve lash and adjust if
necessary.
An Emission Control Service.
0 Check engine idle speed and adjust it to
underhood label specifications.
An Emission
Control
Service.
0 Inspect propeller shafts and u-joints for
looseness and damage (or every
15 months,
whichever occurs first). Inspect more
frequently if used off-road or for pulling a
trailer. Tighten u-joint flange bolts
if
necessary.
DATE ACTUAL MILEAGE SERVICED BY:
7-34
ProCarManuals.com

I Maintenance Schedule I1
45,000 Miles (75 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever occurs
first).
0 Rotate tires. See “Tire Inspection and
Rotation” in the Index for proper rotation
pattern and additional information.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair
or replace if
necessary.
0 Inspect the valve lash and adjust if
necessary. An Emission Control Service.
0 Check engine idle speed and adjust it to
underhood label specifications.
An Emission
Control Sewice.
0 Inspect propeller shafts and u-joints for
looseness and damage (or every 15 months,
whichever occurs first). Inspect more
frequently
if used off-road or for pulling a
trailer. Tighten u-joint flange bolts if
necessary.
I I I 1
1
ACTUAL MILEAGE SERVICED BY
7-38
ProCarManuals.com

I Maintenance Schedule I1
75,000 Miles (125 000 km)
0 Change engine oil and filter (or every
7.5 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever occurs
first).
0 Rotate tires. See “Tire Inspection and
Rotation’’ in the Index for proper rotation
pattern and additional information.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every 3 months,
whichever occurs first). Repair or replace if
necessary.
0 Inspect the valve lash and adjust if
necessary.
An Emission Control Service.
0 Check engine idle speed and adjust it to
underhood label specifications.
An Emission
Control Service.
0 Inspect propeller shafts and u-joints for
looseness and damage (or every
15 months,
whichever occurs first). Inspect more
frequently if used off-road or for pulling a
trailer. Tighten u-joint flange bolts if
necessary.
I DATE I ACTUALMILEAGE ISERVICED BY:^
ProCarManuals.com