engine oil CHEVROLET TRACKER 1996 User Guide
[x] Cancel search | Manufacturer: CHEVROLET, Model Year: 1996, Model line: TRACKER, Model: CHEVROLET TRACKER 1996Pages: 387, PDF Size: 18.54 MB
Page 246 of 387

Before closing the hood, be sure all the filler
caps are on.
Then lift the hood to relieve pressure on the hood prop.
Remove the hood prop from the slot in the hood and
return the prop
to its retainer. Then let the hood down
and close
it firmly.
Engine Oil
If the engine oil
pressure light on the
instrument panel comes
on, it means
you need
to check
your engine oil level
right away.
For more information,
see “Engine Oil Pressure Light”
in the Index. You should check your engine oil level
regularly; this is an added reminder. It’s a good
idea
to check your engine oil every time you
get fuel.
In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
Turn off the engine and
give the oil a few minutes
drain back into the oil
pan. If you don’t, the oil
dipstick might not show
the actual level.
to
6-9
ProCarManuals.com
Page 247 of 387

Checking Engine Oil
Pull out the dipstick and clean it with a paper towel or
iApBrh, then push it back in all the way. Remove it again,
keeping the tip down, and check the level.
When to Add Oil
If the oil is at or below the ADD mark, then you’ll need
to
add some oil. But you must use the right kind. This
part explains what kind of oil to use. For crankcase
capacity, see “Capacities
and Specifications” in the Index.
NOTICE:
Don’t add too much oil. If your engine has so
much oil that the oil level gets above the upper
mark that shows the proper operating range,
your engine could be damaged.
Just fill it enough to put the level somewhere in the
proper operating range. Push the dipstick all the way
back in when you’re through.
ProCarManuals.com
Page 248 of 387

What Kind of Oil to Use
Oils recommended for your vehicle can be identified by
looking for the “Starburst” symbol. This symbol
indicates that the oil has been certified by the American
Petroleum Institute (API).
Do not use any oil which
does not carry this Starburst symbol.
If you change your own
oil, be sure you use oil that
has the Starburst symbol on the front
of the oil
container. If you have
your
oil changed for you,
be sure the oil put into
your engine
is American
Petroleum Institute certified
for gasoline en~es.
I I U v
You should also use the proper viscosity oil for your
vehicle, as shown
in the following chart:
RECOMMENDED SAE VISCOSITY GRADE ENGINE OILS
FOR BEST FUEL ECONOMY AND COLD STARTING, SELECT THE LOWEST
SAE VISCOSITY GRADE OIL
FOR THE EXPECTED TEMPERATURE RANGE.
HOT
WEATHER
’m)
LOOK
FOR MIS
SYMBOL
+loo- - +38
+EO- - +27
+60- - +16
+40- - +4
+20---7
0---18
I- --I SAE 1OW-30
SAE 5W-30 PREFERRED
/
caul
WEATHER
DO NOT USE SAE 2OW-50 OR ANY OTHER GRADE OIL NOT RECOMMENDED
6-11
ProCarManuals.com
Page 249 of 387

As shown in the chart, SAE 5W-30 is best for your
vehicle. However, you can use SAE
1OW-30 if it’s going
to be 0°F (-1 8 “C) or above. These numbers on an oil
container
show its viscosity, or thickness. Do not use
other viscosity oils, such
as SAE 20W-50.
NOTICE:
Use only engine oil with the American Petroleum
Institute Certified For Gasoline Engines
“Starburst”
symbol. Failure to use the
recommended oil can result in engine damage
not covered by your warranty.
GM Goodwrench@ oil meets all the requirements for
your vehicle.
Engine Oil Additives
Don’t add anything to your oil. Your Geo dealer is ready
to advise if
you think something should‘be added.
When to Change Engine Oil
See if any one of these is true for you:
0
e
e
0
e
Most trips are less than 5 to 10 miles (8 to 16 km).
This is particularly important when outside
temperatures are below freezing.
Most trips include extensive idling (such as frequent
driving in stop-and-go traffic).
You operate your vehicle in dusty areas or
off-road frequently.
You frequently tow a trailer or use a carrier on top of
your vehicle.
The vehicle is used for delivery service, police, taxi
or other commercial application.
Driving under these conditions causes engine
oil to
break down sooner.
If any one of these is true for your
vehicle, then you need to change your
oil and filter
every
3,000 miles (5 000 km) or 3 months -- whichever
occurs first.
If none of them is true, change oil and filter every
7,500 miles (12 500 km) or 7.5 months -- whichever
occurs first.
Driving a vehicle with a fully warned
engine under highway conditions causes engine oil to
break down slower.
6-12
ProCarManuals.com
Page 250 of 387

What to Do with Used Oil
Did you know that used engine oil contains certain
elements that may be unhealthy for your skin and could
even cause cancer? Don’t let used oil
stay on your skin
for very long. Clean your skin and nails with soap and
water, or a good hand cleaner. Wash or properly throw
away clothing or rags containing used engine oil. (See
the manufacturer’s warnings about the use and disposal
of oil products.)
Used oil can be a real threat to the environment. If you
change your own oil, be sure to drain all free-flowing oil
from the filter before disposal. Don’t ever dispose
of oil
by putting it in the trash, pouring it on the ground, into
sewers, or into streams or bodies of water. Instead,
recycle
it by taking it to a place that collects used oil. If
you have a problem properly disposing of your used oil,
ask your dealer, a service station or a local recycling
center for help.
Air Cleaner
Refer to the Maintenance Schedule to determine when to
replace the air filter and the crankcase ventilation filter.
See “Scheduled Maintenance Services” in the Index.
6-13
ProCarManuals.com
Page 252 of 387

3. Pull out the filter.
Automatic Transmission Fluid
When to Check and Change
A good time to check your automatic transmission fluid
level is when the engine oil is changed.
Change both the fluid and filter every
50,000 miles
(83 000 km) if the vehicle is mainly driven under one or
more of these conditions:
0 In heavy city traffic where the outside temperature
regularly reaches
90°F (32” C) or higher.
In hilly or mountainous terrain.
When doing frequent trailer towing.
Uses such as found in taxi, police or delivery service.
If you do not use your vehicle under any of these
conditions, the fluid and filter do not
require changing.
See “Scheduled Maintenance Services” in the Index.
6-15
ProCarManuals.com
Page 256 of 387

Manual Transmission Fluid
When to Check and Change
A good time to have it checked is when the engine
oil is changed. Refer to the Maintenance Schedule to
determine when to change your transmission fluid.
See “Scheduled Maintenance Services” in the Index.
How to Check
Because this operation can be a little difficult, you
may choose to have this done at your Geo dealership
Service Department.
If you do it yourself, be sure to follow all the
instructions
here, or you could get a false reading.
NOTICE:
Too much or too little fluid can damage your
transmission.
Too much can mean that some of
the fluid could come out and fall on hot engine parts or exhaust system parts, starting
a fire. Be
sure to get an accurate reading if
you check your
transmission fluid.
Check the fluid level only when your engine is off, the
vehicle is parked on a level place and the transmission is
cool enough for
you to rest your fingers on the
transmission case.
6-19
ProCarManuals.com
Page 261 of 387

What to Use
Refer to the Maintenance Schedule to determine what
W of lubricant to use. See “Recommended Fluids and
Lubricants”
in the Index.
Engine Coolant
The following explains your cooling system and how
to add coolant when
it is low. If you have a problem
with engine overheating, see “Engine Overheating” in
the Index.
A 50/50 mixture of water and the proper coolant for
your Geo will:
Give freezing protection down to -33 “F (-36°C).
0 Give boiling protection up to 258°F (125°C).
Protect against rust and corrosion.
Help keep the proper engine temperature,
Let the warning lights and gages work as
they should.
What to Use
Use a mixture of one-half clean water (preferably
distilled) and one-half antifreeze that meets
GM
Specification 1825-M, which won’t damage aluminum
parts. You can also use a recycled coolant conforming
to
GM Specification 1825-M with a complete coolant flush
and refill. If you use this mixture, you don’t need to add
anything else.
/i CAUTTON:
Adding only plain water to your cooling system
can be dangerous. Plain water, or some other
liquid like alcohol, can boil before the proper
coolant mix
will. Your vehicle’s coolant warning
system is set for the proper coolant
mix. With
plain water
or the wrong mix, your engine could
get too hot
but you wouldn’t get the overheat
warning. Your engine could catch
fire and you or
others could be burned. Use a 50/50 mix of clean
water and the proper antifreeze.
6-24
ProCarManuals.com
Page 268 of 387

What to Add
When you do need brake fluid, use only DOT-3 brake
fluid
-- such as Delco Supreme 11 @ (GM Part
No. 1052535). Use new brake fluid from a sealed
container only, and alvir-ays clean the brake fluid
reservoir cap before removing
it.
I d!L CAUTION:
1
With the wrong kind of fluid in your brake
system, your brakes may not work well, or they
may not even work at all. This could cause
a
crash. Always use the proper brake fluid.
NOTICE:
e Using the wrong fluid can badly damage
brake system parts. For example, just
a few
drops of mineral-based oil, such as engine
oil, in your brake system can damage brake
system parts
so badly that they’ll have to be
replaced. Don’t let someone put in the
wrong kind of fluid.
If you spill brake fluid on your vehicle’s
painted surfaces, the paint finish can be
damaged. Be careful not to spill brake fluid
on your vehicle. If you do, wash it off
immediately. See “Appearance Care” in
the Index.
6-31
ProCarManuals.com
Page 299 of 387

Capacities and Specifications
Engine
Type ....................... . . L4
Compression Ratio ........ . . 9.5:l
Firing Order .......................... 1-3-4-2
Horsepower
.............................. 95
Fuel Delivery .................... Fuel Injection
Piston Displacement
............... 97 CID (I .6L)
Valve Arrangement ............ ~n-~ead T? Type
AC Belt Tension ....... Deflect Belt 0.24-0.3 inch
(6-9 mm) @ 22 lbs. (10 kg) Pressure
Fan Belt Tension
Inspection
........... Deflect Belt 0.24-0.32 inch
Replacement
.......... Deflect Belt 0.20-0.28 inch
(4-8 mm)'@ 22 lbs. (10 kg) Pressure
(5-7 mm) @ 22 lbs. (10 kg) Pressure
Specification
........... , . 180°F (82°C)
Thermostat Temperature,
Replacement Parts
Air Cleaner Filter ................. 13780-58B20
GM Part No. 96068629 or equivalent
Engine Oil Filter
.......... GM Part No. 25014441
GM Part No. 96058022 or equivalent
PCV Valve .... GM Part No. 96058079 or equivalent
Radiator Pressure Cap
............ 13 psi (90 kPa)
0.028-0.032 inch gap
(0.7 to 9.8 mm)
Battery ............................. 26R-50s
Fuel Filter
..................... AC Type GF571
Spark Plug ................... AC Type R43XLS
ProCarManuals.com