wheel CHEVROLET TRACKER 1996 Workshop Manual

Towing Your Vehicle
Try to have a Chevrolet/Geo dealer or a professional
towing service tow your Geo. See “Roadside
Assistance” in the Index.
If your vehicle has been changed or modified since it
was factory-new by adding aftermarket items like fog
lamps, aero skirting, or special tires and wheels, these
instructions may not
be correct.
Before you do anything, turn on the hazard
warning flashers.
When you call, tell the towing service:
That your vehicle has rear-wheel drive, or that it has
the four-wheel-drive option.
The make, model and year of your vehicle.
Whether you can still move the shift lever for’the
transmission and transfer case,
if you have one.
0 If there was an accident, what was damaged.
When the towing service arrives, let the tow operator
know that this manual contains detailed towing
instructions
and illustrations. The operator may want to
see them.
I a CAUTION:
To help avoid injury to you or others:
Never let passengers ride in a vehicle that is
Never tow faster than safe or posted speeds.
Never tow with damaged parts not
Never get under your vehicle after it has
Always use separate safety chains on each
Never use T-hooks. Use J-hooks instead.
being towed.
fully
secured.
been lifted by the tow truck.
side when towing
a vehicle.
5-7
ProCarManuals.com

U‘l’lOR’
A vehicle can fall from a car carrier if it isn’t
adequately secured. This can cause
a collision, ‘
serious personal injury and vehicle damage. The
vehicle should be tightly secured with chains or
steel cables before
it is transported.
Don’t
use substitutes (ropes, leather straps,
canvas webbing,
etc.) that can be cut by sharp
edges underneath the towed vehicle.
When your vehicle is being towed, have the ignition key
turned to the OFF position. The steering wheel should
be clamped in a straight-ahead position, with a clamping
device designed for towing service. Do not use the
vehicle’s steering column lock for this.
The transmission
and
transfer case, if you have one, should be in
NEUTRAL (N) and the parking brake released.
Don’t have your vehicle towed
on the drive wheels
unless
you must. If the vehicle &ust be towed on the
drive wheels, be sure to follow any speed and distance
restrictions later
in this section, or your transmission
will be damaged. If these limitations must be exceeded,
then the drive wheels have to be supported on a dolly.
5-8
ProCarManuals.com

A towing dolly must be used under the drive wheels
when towing
from the fvont.
Attach J-hook chains on both sides to the rear of lower
control arms inboard
of the spring. Position
a 4” x 4” wood
beam across the sling chains
and against
the lower control arm front attachment
brackets. Position the lower sling crossbar in front and
against the
4” x 4” wood beam.
- 5-9
ProCarManuals.com

Attach a separate safety chain around the outboard end
of each lower control arm.
Rear Towing
If your vehicle has four-wheel drive, don't have it towed
on the front wheels unless you must. If a vehicle with
four-wheel drive must
be towed on the front wheels, set
your manual, freewheeling
hubs to FREE or unlock your
automatic freewheeling
hubs, and set your transfer case
to two-wheel drive. If your vehicle must be towed on
the-front wheels, don't go more'than 55 mph (90 kmh).
A towing dolly must be used under the front wheels
when towing from the reur.
r
Attach J-hooks around the axle tube.
I NOTICE:
Take care not to damage the brake pipes on the
axle tubes.
5-10
ProCarManuals.com

If a Tire Goes Plat
It’s unusual for a tire to “blow out” while you’re driving,
especiaIIy
if you maintain your tires properly. If air goes
out
of a tire, it’s much more likely to leak put slowly.
But if you should ever have a “blowout,” here are a few
tips about
what to expect and what to do:
If a front tire fails, the flat tire will create a drag that
pulls the vehicle toward that side. Take your foot
off the
accelerator pedal
and grip the steering wheel firmly.
Steer to maintain lane position, and then gently brake to
a stop well out
of the traffic lane.
A rear blowout, particularly on a curve, acts much like a
skid and may require the same correction you’d use in a
skid. In any rear blowout, remove your foot from the
accelerator pedal. Get the vehicle under control by
steering the way you want the vehicle to go.
It may be
very
bumpy and noisy, but you can still steer. Gently
brake to a stop
-- well off the road if possible.
If a tire goes flat, the next part shows how to use your
jacking equipment to change a flat tire safely.
Changing a Flat Tire
If a tire goes flat, avoid further tire and wheel damage
by driving slowly
to a level place. Turn on your hazard
warning flashers.
I
’ A CAUTION:
Changing a tire can cause an injury. The vehicle
can slip
off the jack and roll over you or other
people.
You and they could be badly injured.
Find
a level place to change your tire. To help
prevent the vehicle
from moving:
1. Set the parking brake firmly.
2. Put an automatic transmission shift
lever in PARK (P) or shift a manual
transmission to FIRST (1) or
REVERSE
(R).
3. If you have a four-wheel-drive vehicle,
be sure the transfer case is in
a drive
gear
-- not in NEUTRAL (N).
4. Turn off the engine.
To be even more certain the vehicle won’t move,
you can put blocks at the front and rear of the
tire farthest away from the one being changed.
That would be the tire on the other side of the
vehicle,
at the opposite end.
~~
5-22
ProCarManuals.com

The following steps will tell you how to use the jack and
change a tire.
RemovinL re Tire and 7
The jack and
wheel wrench are under the front
passenger’s seat.
5-23
ProCarManuals.com

The jack handle is under the driver’s seat. The tools you’ll be using include the jack (A), jack
handle (B) and wheel wrench (C).
Attach the jack handle to the jack. Turn the jack handle
to the right to raise the lift head.
5-24
ProCarManuals.com

The spare tire is mounted on your tailgate. Pull the cover
off of the spare tire. Insert
your key into
the wheel lock on the spare tire and
pull the wheel lock off.
5-25
ProCarManuals.com

Remove wheel nuts with the wheel wrench.
Remove the spare tire
from the mounting bracket and
place it near your flat tire.
Attach the
jack handle to the jack bolt. Turn the jack
handle clockwise. That will raise the lift head a little.
. Using the wheel wrench, loosen all the wheel nuts.
Don’t remove them yet.
5-26
ProCarManuals.com

4.7l'
(1 20 mm)
L
2. Position the jack and raise the jack lift head until it
fits firmly onto the bosses nearest the flat tire.
(Under the vehicle near each wheel, there are bosses
in the vehicle's rocker flange.)
CAUTION:
Getting under a vehicle.when it is jacked up is
dangerous. If the vehicle slips off the jack, you
could be badly injured or killed. Never get under
a vehicle when it is supported only by a jack.
1 NOTICE: I
Raising your vehicle with the jack improperly
positioned will damage the vehicle or
may allow
the vehicle to
fall off the jack. Be sure to fit the
jack lift head into the proper location before
raising your vehicle.
, 5-27
ProCarManuals.com