oil pressure CHEVROLET TRACKER 1996 Owners Manual

Vehicle Symbols
These are some of the symbols you may find on your vehicle.
For example,
these symbols
are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
ACIbTELi CAUSE
BURNS
AVOID
SPARKS OR
FLAMES
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols are important
for you and
your passengers
whenever your
vehicle
is
driven:
FASTEN
SEAT
BELTS
These symbols
have
to do with
your lights:
SIGNALS e e3
TURN
PARKING
0
LAMPS pq
RUNNING 0
DAYTIME *
LAMPS '**
FOG LAMPS $0
These symbols
are on some
of
your controls:
WINDSHIELD
WIPER
WINDSHIELD DEFROSTER
VENTILATING
&?
FAN
These symbols are used
on
warning and
indicator lights:
ENGINE t
COOLANT - t-
TEMP -
CHARGING BAllERY
SYSTEM
BRAKE
(0)
R
COOLANT
ENGINE OIL
w,
PRESSURE
ANTI-LOCK
(@)
BRAKES
Here are some
other symbols
you may see:
FUSE *
P
LIGHTER
HORN
)tr
SPEAKER
b
FUEL B
vi
ProCarManuals.com

Have you recently changed brands of fuel?
If so, be sure to fuel your vehicle with quality fuel (see
“Fuel” in the Index). Poor fuel quality
will cause your
engine not to mn
as efficiently as designed. You may
notice this as stalling after start-up, stalling when you
put the vehicle into gear, misfiring, hesitation on
acceleration or stumbling on acceleration. (These
conditions may go away once the engine is warmed up.)
This will be detected by the system and cause the light
to turn on.
Oil Pressure Light
If you have a problem with
your oil, this light may stay
on after you start your
engine, or come
on when
you are driving.
If you experience this condition, change the fuel brand
you use. It will require at least one full tank of the
proper fuel to turn the light off.
If none of the above steps have made the light turn off, your engine properly lubricated and cool. The engine
have your dealer or qualified service center check the could be low on oil, or have some other oil related
vehicle. Your dealer has the proper test equipment and problem. Have it fixed right away.
diagnostic
tools to fix any mechanical or electrical
problems that may have developed. This indicates
that there
is not enough pressure to keep
2-67
ProCarManuals.com

The oil light could also come on in three other situations.
When the ignition is on but the engine is not running,
&e light. wLU come on as a test to show you it is
working, but the light will go out when
you turn the
engine to START.
If it doesn’t come on with the
ignition on, you may have a problem with the fuse
or
bulb. Have it fixed right away.
light
may blink on and off. This is normal.
Sometimes when the engine is idling at a stop, the
If you make a hard stop, the light may come on for a
moment. This is normal.
Don’t keep driving if the oil pressure is low. If
you
do, your engine can become so hot that it
catches
fire. You or others could be burned.
Check your oil as soon
as possible and have your
vehicle serviced.
NOTICE:
Damage to your engine from neglected oil
problems
can be costly and is not covered by
your warranty.
Power Indicator Light (Option)
POWER
- This light comes on
when the power mode
selector switch is turned to
P (power) with the ignition
switch
in the.ON position.
-
2-68
ProCarManuals.com

Reduce your speed according to your speedometer, not
to your sense of motion. After driving for any distance
at higher speeds, you may tend to think
you are going
slower than
you actually are.
Before Leaving on a Long Trip
Make sure you’re ready. Try to be well rested. If you
must start when you’re not fresh
-- such as after a day’s
work
-- don’t plan to make too many miles that first part
of the journey. Wear comfortable clothing and shoes
you
can easily drive in.
Is your vehicle ready for a long trip? If you keep it
serviced and maintained, it’s ready to go. If it needs
service, have
it done before starting out. Of course,
you’ll find experienced
and able service experts in Geo
dealerships all across North America. They’ll be ready
and willing to help if you need it. Here are
some things you can check before a trip:
a
0
0
a
a
0
Windshield Washer Fluid: Is the reservoir full?
Are all windows clean inside and outside?
Wiper Blades: Are they in good shape?
Fuel, Engine Oil, Other Fluids: Have you checked
all levels?
Lamps: Are they all working? Are the lenses clean?
Tires: They are vitally important to a safe,
trouble-free trip.
Is the tread good enough for
long-distance driving? Are the tires all inflated to the
recommended pressure?
Weather Forecasts: What’s the weather outlook
along your
route?’Should you delay your trip a short
time to avoid a major storm system?
Maps: Do you have up-to-date maps?
4-36
ProCarManuals.com

When you decide it’s safe to lift the hood, here’s what
you’ll
see:
c
A. Radiator Pressure Cap
B. Electric Engine Fan
C. Coolant Recovery Tank
A CAUTION:
An electric fan under the hood can start up even
when the engine is not running and can injure
you. Keep hands, clothing and tools away from
any underhood electric fan. Don’t reach through
the grille to release the underhood lever.
If the coolant inside the coolant recovery tank is boiling,
don’t do anything
else until it cools down.
5-14
ProCarManuals.com

Before closing the hood, be sure all the filler
caps are on.
Then lift the hood to relieve pressure on the hood prop.
Remove the hood prop from the slot in the hood and
return the prop
to its retainer. Then let the hood down
and close
it firmly.
Engine Oil
If the engine oil
pressure light on the
instrument panel comes
on, it means
you need
to check
your engine oil level
right away.
For more information,
see “Engine Oil Pressure Light”
in the Index. You should check your engine oil level
regularly; this is an added reminder. It’s a good
idea
to check your engine oil every time you
get fuel.
In order to get an accurate reading, the oil must
be warm and the vehicle must be on level ground.
Turn off the engine and
give the oil a few minutes
drain back into the oil
pan. If you don’t, the oil
dipstick might not show
the actual level.
to
6-9
ProCarManuals.com

Using Foam-Type Cleaner on Fabric
1. Vacuum and brush the area to remove any
loose dirt.
2. Always clean a whole trim panel or section. Mask
3. Mix Multi-Purpose Powdered Cleaner following
surrounding trim along stitch
or welt lines.
the directions on the container label.
4. Use suds only and apply with a clean sponge.
5. Don’t saturate the material.
6. Don’t rub it roughly.
7. As soon as you’ve cleaned the section, use a sponge
8. Rinse the section with a clean, wet sponge.
9. Wipe off what’s left with a slightly damp paper
to remove the suds.
towel or cloth.
10. Then dry it immediately with a blow dryer.
11. Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean
off better with just
water and mild soap.
If you need to use a solvent:
Gently scrape excess soil from the trim material with
a clean, dull knife or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth). Cleaning should start at the outside of
the stain, “feathering” toward the center. Keep
changing to a clean section of the cloth.
When you clean a stain from fabric, immediately
dry the area with a blow dryer to help prevent
a
cleaning ring.
Fabric Protection
Your Geo has upholstery that has been treated with
Scotchgard” Fabric Protector, a 3M product.
It protects
fabrics by repelling oil and water, which are the carriers
of most stains. Even with this protection, you still need
to clean your upholstery often to keep it looking new.
Further information on cleaning
is available by calling
1-800-433-3296 (in Minnesota, 1-800-642-6167).
6-49
ProCarManuals.com

Capacities and Specifications
Engine
Type ....................... . . L4
Compression Ratio ........ . . 9.5:l
Firing Order .......................... 1-3-4-2
Horsepower
.............................. 95
Fuel Delivery .................... Fuel Injection
Piston Displacement
............... 97 CID (I .6L)
Valve Arrangement ............ ~n-~ead T? Type
AC Belt Tension ....... Deflect Belt 0.24-0.3 inch
(6-9 mm) @ 22 lbs. (10 kg) Pressure
Fan Belt Tension
Inspection
........... Deflect Belt 0.24-0.32 inch
Replacement
.......... Deflect Belt 0.20-0.28 inch
(4-8 mm)'@ 22 lbs. (10 kg) Pressure
(5-7 mm) @ 22 lbs. (10 kg) Pressure
Specification
........... , . 180°F (82°C)
Thermostat Temperature,
Replacement Parts
Air Cleaner Filter ................. 13780-58B20
GM Part No. 96068629 or equivalent
Engine Oil Filter
.......... GM Part No. 25014441
GM Part No. 96058022 or equivalent
PCV Valve .... GM Part No. 96058079 or equivalent
Radiator Pressure Cap
............ 13 psi (90 kPa)
0.028-0.032 inch gap
(0.7 to 9.8 mm)
Battery ............................. 26R-50s
Fuel Filter
..................... AC Type GF571
Spark Plug ................... AC Type R43XLS
ProCarManuals.com

)p/City Maintenance Schedule I
27,000 Miles (45 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
0 Inspect the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessary.
DATE
SERVICED BY: ACTUAL MILEAGE
30,000 Miles (50 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
I7 Inspect engine accessory drive belts (or
every
24 months, whichever occurs first).
An Emission Control Service.
I7 Drain, flush and refill cooling system (or
every 30 months, whichever occurs first).
See “Engine Coolant”
in the Index for what
to use. Inspect hoses. Clean radiator, condenser, pressure cap and neck. Pressure
test the cooling system
and pressure cap.
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or at each brake relining, whichever
occurs first).
(Continued)
7-13
ProCarManuals.com

1 Short Trip/City Maintenance Schedule ~-1
57,000 Miles (95 000 km)
0 Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
0 Inspect ,the locking front hubs (if equipped)
for correct operation (or every
3 months,
whichever occurs first). Repair or replace
if necessary.
60,000 Miles (100 000 km)
c] Change engine oil and filter (or every
3 months, whichever occurs first).
An Emission Control Service.
0 Clean and repack the front wheel bearings
(or
at each brake relining, whichever
occurs first).
0 Replace spark plugs.
Inspect engine accessory drive belts (or
An Emission Control Service.
every 24 months, whichever occurs first).
0 Drain, flush and refill. cooling system (or
every 30 months, whichever occurs first).
See “Engine Coolant” in the Index for
what
to use. Inspect hoses. Clean radiator,
condenser, pressure cap and neck. Pressure
test the cooling system and pressure
cap.
An Emission Control Service.
An Emission Control Service.
7-20
ProCarManuals.com