CHEVROLET TRACKER 1997 Owners Manual

Battery
Every new Geo has a Delco Freedom@ battery. You
never have
to add water to one of these. When it’s time
for a new battery, we recommend a Delco Freedom
battery. Get
one that has the replacement number shown
on the original battery’s label.
Vehicle Storage
If you’re not going to drive your vehicle for 25 days
or more, take
off the black, negative (-) cable from
the battery. This will help keep your battery from
running down.
A CAUTION:
Also, for your audio system, see “Theft-Deterrent
Feature”
in the Index.
Bulb Replacement
See “Replacement Bulbs” in the Index to check the size
and type
of bulb you need to use.
Batteries have acid that can burn you and gas
that can explode. You can be badly hurt if you
aren’t careful. See “Jump Starting” in the Index
for tips on working around a battery without
getting hurt.
Contact your dealer to learn how to prepare your vehicle
for longer storage periods.
I ,.I CAUTIdN:
Halogen bulbs have pressurized gas inside and
can burst
if you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions on the bulb package.
6-33
I
ProCarManuals.com

Headlamps
To replace the headlamp bulb:
1. Open the hood.
2. Push in on both sides of the electrical connector. Pull
up and rearward, to disconnect it from the bulb. The
plastic clip on the electrical connector may need
to
be lifted gently with a screwdriver.
3. Turn the lock ring counterclockwise to release
the bulb.
6-34
ProCarManuals.com

4. Pull the lock ring and the headlamp bulb straight out.
Save the lock ring, and use it with the new bulb.
5. Reverse the steps with a new bulb.
Front Parking and Turn Signal Lamps
To replace the parking and turn signal bulb:
I. Open the hood.
2. Turn the bulb socket counterclockwise and pull it out
of the lamp housing.
6-35
I
ProCarManuals.com

Sidemarker Lamps
To replace the sidemarker bulb:
1. Push the sidemarker housing toward the back
of the
vehicle to release the clip and pull out the front edge.
The housing should pull away from the vehicle.
3. Push the bulb in, turn it counterclockwise and pull
it out.
4. Reverse the steps with a new bulb.
2. Turn the socket counterclockwise and pull it out of
the housing.
6-36
ProCarManuals.com

3. Pull the bulb out of the socket.
4. Reverse the steps with a new bulb.
Rear Sidemarker Lamps
To replace the rear sidemarker bulb:
1.
2.
3.
4.
5.
Remove the screw (hardtop only).
Pull the sidemarker lamp housing out at the
back edge.
Turn the socket toward the rear of the vehicle and
pull it out.
Pull the bulb out
of the socket.
Reverse the steps with a new bulb.
6-37
ProCarManuals.com

Rear Combination Lamps
To remove the rear combination bulbs:
1. Remove the two screws from the combination lamps.
6-38
ProCarManuals.com

2. Disconnect the bulb from its socket by twisting and
then pulling the bulb out.
3. Reverse the steps with a new bulb.
Center High-Mounted Stoplamp, Four
Door Models
1. Open the rear door.
2. Remove the two clips and the center high-mounted
3. Remove the bulb socket from the lens and remove
stoplamp housing
from the lamp.
the bulb from the bulb socket.
4. With a new bulb, reverse the steps.
Center High-Mounted Stodamp,
Convertible Models
1. Remove the two screw and the center high-mounted
stoplamp lens from the housing.
2. Remove the bulb socket from the lens and remove
the bulb from the bulb socket.
3. With a new bulb, reverse the steps.
Dome Lamp
1. Gently pry the dome lamp lens from the lamp
2. Remove the old bulb and replace with a new bulb.
3. Snap the dome lamp lens back into the dome
assembly with
a flat-bladed
screwdriver.
lamp assembly.
6-39
ProCarManuals.com

Tires
Your new Geo comes with high-quality tires made by a
leading tire manufacturer.
If you ever have questions
about your tire warranty and where to obtain service, see
your Geo Warranty booklet for details.
A CAUTION:
I
Poorly maintained and improperly used tires
are dangerous.
0 Overloading your tires can cause
overheating as a result of too much friction.
You could have an air-out and a serious
accident. See “Loading Your Vehicle” in
the Index.
0 Underinflated tires pose the same danger as
overloaded tires. The resulting accident
could cause serious injury. Check all tires
frequently to maintain the recommended
pressure. Tire pressure should be checked
when your tires are cold.
cut, punctured or broken by a sudden
impact
-- such as when you hit a pothole.
Keep tires at the recommended pressure.
Worn, old tires can cause accidents. If your
tread is badly worn, or if your tires have
been damaged, replace them.
0 Overinflated tires are more likely to be
ProCarManuals.com

Inflation -- Tire Pressure
The Tire-Loading Information label, which is on the
driver’s door lock pillar, shows
the correct inflation
pressures for your tires when they’re cold. “Cold”
means your vehicle has been sitting for at least
three hours or driven
no more than 1 mile ( 1.6 km).
I NOTICE:
Don’t let anyone tell you that underinflation or
overinflation is all right. It’s not.
If your tires
don’t have enough air (underinflation), you can
get the following:
Too much flexing
Too much heat
Tire overloading
Bad wear
Bad handling
Bad fuel economy.
NOTICE: (Continued) NOTICE:
(Continued)
If your tires have too much air (overinflation),
you can get the following:
Unusual wear
Bad handling
Rough ride
Needless damage from road hazards.
When to Check
Check your tires once a month or more. Also, check
the tire pressure of the spare tire.
How to Check
Use a good quality pocket-type gage to check tire
pressure. You can’t tell
if your tires are properly inflated
simply by looking at them. Radial tires may look
properly inflated even when they’re underinflated.
Be sure to put the valve caps back on the valve stems.
They help prevent leaks by keeping out dirt and moisture.
6-4 1
ProCarManuals.com

Tire Inspection and Rotation
Tires should be rotated every 6,000 to 8,000 miles
(10 000 to 13 000 km). Any time you notice unusual
wear, rotate your tires as soon as possible and check
wheel alignment. Also check for damaged tires or
wheels. See “When It’s Time for New Tires” and
“Wheel Replacement” later in this section for
more information.
The purpose
of regular rotation is to achieve more
uniform wear for all tires
on the vehicle. The first
rotation
is the most important. See “Scheduled
Maintenance Services’’ in the Index for scheduled
rotation intervals.
+
Q
I
After the tires have been rotated, adjust the front and
rear inflation pressures as shown on the Tire-Loading
Information label. Make certain that all wheel nuts
are properly tightened. See “Wheel Nut Torque” in
the Index.
6-42
ProCarManuals.com