window CHEVROLET TRACKER 2002 2.G User Guide

2-39 Windshield Washer
To wash your windshield, pull the stalk with the wiper
symbol on it toward you one time. When you release
the stalk, the washers will stop. The wiper will continue
wiping for approximately three cycles and will either
stop or will resume the speed you were using before.
See ªWindshield Washer Fluidº in the Index.
CAUTION:
In freezing weather, don't use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
Rear Window Wiper/Washer (If Equipped)
To turn on your rear wiper,
push the upper button.
Push the same button
again to turn it off.
To spray washer fluid on the rear window, push the
lower button about halfway down. Washer fluid will
spray as long as you hold this button. To wash and
wipe at the same time, push the button all the way in.
The washer and wiper will run as long as you hold this
button. To add washer fluid, see ªWindshield Washer
Fluidº in the Index.

2-51
3. Loosen the lower rear corners of the convertible top.
4. Remove the rear window. See ªRemoving and
Installing Your Rear Windowº later in this section.5. Carefully lift the panel out of the cargo area.
6. Put the knobs back into the mounting holes for
storage while the panel is out of the vehicle.
CAUTION:
An improperly stored cargo cover could be thrown
about the vehicle during a collision or sudden
maneuver. You or others could be injured. If you
remove the cover, always store it outside of the
vehicle. When you put it back, always be sure that
it is securely reattached.

2-56
Convertible Top (If Equipped)
Your convertible top features a sunroof, a removable
rear window and removable side windows.
NOTICE:

Never raise or lower the top while the vehicle
is moving, or drive with any part of the top
unfastened or partially removed. The wind
could get under it and cause damage.

Do not take your vehicle through an
automatic car wash. It could damage
your convertible top.

Don't try to lower or raise the convertible top
or tap or beat on the plastic windows if your
vehicle is out in cold weather, 41F (5C) or
below. The cold can cause cracks and other
damage to the windows and to the top as it is
being lowered or raised.
NOTICE: (Continued)
NOTICE: (Continued)

Don't lower the top if it is damp or wet.
After the top is down, the trapped water
can cause stains, mildew and damage to the
inside of your car. Be sure to dry off the top
before you lower it.

Don't lower the convertible top if the rear
flap or side windows are dirty. Dirt could
scratch the side windows.

The convertible top isn't designed to carry
weight. Never let anyone sit on the top, and
don't put anything on top of it when it is up,
or it could be damaged.

2-59 Removing and Installing Your Rear Window
The rear window on your vehicle is removable. This allows
you to open the back opening all the way or to replace
the window if it becomes deteriorated. To remove the
rear window do the following:
1. Open the rear gate all the way.
2. Unfasten the canvas flaps at the lower corners of the
rear window to uncover the zipper pull.
3. Unzip the rear window.
4. Hang the rear window down so it hangs outside
of the vehicle.
5. Pull the rear window frame bar rearward
(see illustration above). Then slide the bar to
the left to remove the window.
Reverse the steps to install the rear window. Make sure
that all the Velcro

strips and flaps are correctly
fastened and overlapped. Make sure that the window is
completely closed before driving.

2-60 Removing and Installing the Side Window
To remove the side window do the following:
1. Release the tension in the canvas top support arms.
Unfasten the Velcro strips on the top and rear quarter
of the side window.
2. Unzip the zipper almost all the way, leaving about
3 inches (8 cm) of it still zipped and unfasten the
Velcro strips on the inside of the window.3. Release the plastic strip sewn along the bottom
edge of the window by gently pulling down and out.
Then release the plastic along the front edge of the
window by pulling it forward and out. It may help
to rock the window back and forth to remove it.
4. Unfasten the plastic clip, which is part of the canvas
top, at the top front corner of each side window.
Then unzip the zipper the rest of the way and remove
the side window.

2-61
To install the side window:
1. Make sure the plastic clip at the top front corner of
the canvas top is unfastened.2. Then start by zipping the zipper about 3 inches
(8 cm), to hold the window in place. When zipping,
place the rear bottom corner of the window inside
the rear part of the vehicle body to help support the
window while you engage the zipper end.
3. Install the plastic strip into the window channel
before completely zipping the window. There is a
locating pin in the front upper corner to assist in
aligning the window.
4. Pull rearward on the rear edge of the window to
make sure the window is secure and finish zipping
the window.

2-62
5. After completing installation, make sure that the
front and bottom ends are securely hooked and the
rear top end of the window is under the canvas top.
6. Refasten the plastic clip at the top front corner of
the side window. Restore the tension to the canvas
top support arms.
Lowering and Raising the Canvas Top
1. Remove the side windows of the canvas top as
shown previously. Remember to release the tension
in the canvas top support arms first.
2. Open the rear window and hang it down inside
the luggage compartment (or over the top of the
vehicle's trunk).
3. Unfasten the snaps that secure the canvas top to the
roof. The snaps are located on both sides of the dome
lamp. Reattach the snaps which hold the sunroof
canvas in place.

2-65
The main components of your instrument panel are the following:
A. Side Defroster Vent
B. Air Vents
C. Turn Signal/Multifunction Lever
D. Instrument Panel Cluster
E. Windshield Wiper/Washer Lever
F. Hazard Button
G. Rear Window Defogger Button (If Equipped)
H. Cruise Control Button (If Equipped)
I. Comfort Controls
J. Rear Window Wiper/Washer Button (If Equipped)
K. CoinholderL. Power Remote Control Mirrors (If Equipped)
M. Instrument Panel Brightness Thumbwheel
N. Hood Release
O. Instrument Panel Fuse Block
P. Ignition Switch
Q. Cigarette Lighter/Accessory Power Outlet
R. Power Mode Selector Switch (If Equipped)
S. Shift Lever
T. Ashtray
U. Audio System
V. Vent Shut
-off Thumbwheel

3-
3-1
Section 3 Comfort Controls and Audio Systems
In this section, you'll find out how to operate the comfort control and audio systems offered with your vehicle.
Be sure to read about the particular systems supplied with your vehicle.
3
-2 Comfort Controls
3
-2 Climate Control System
3
-3 Air Conditioner Controls
3
-4 Heating
3
-4 Defogging and Defrosting
3
-5 Rear Window Defogger (If Equipped)
3
-6 Ventilation System
3
-7 Audio Systems3
-7 Setting the Clock
3
-7AM-FM Stereo with Compact Disc Player
3
-12 Understanding Radio Reception
3
-12 Tips About Your Audio System
3
-13 Care of Your Compact Discs
3
-13 Care of Your Compact Disc Player
3
-13 Fixed Mast Antenna

3-2
Comfort Controls
With this system, you can control the heating, cooling
and ventilation in your vehicle.
Your vehicle also has the flow
-through ventilation
system described later in this section.
Climate Control System
Airflow Lever
(Vent): This position directs the airflow through the
instrument panel vents.
(Bi-level): This position directs air through the
instrument panel vents and toward the floor.
(Floor): This position directs air toward the floor
and through the right and left side vents. The side vents
can be shut off by closing the thumbwheel to allow for
more air to be directed toward the floor.
(Defog): This position directs air toward the floor,
the windshield and side windows. The air also comes
from both vents at the ends of the instrument panel
if the thumbwheel below them is in the open position.
The air conditioning compressor will run automatically
in this setting without pressing A/C.
(Defrost): This position directs air to the
windshield and side windows. The air also comes
from both vents at the ends of the instrument panel
if the thumbwheel below them is in the open position.
The air conditioning compressor will run automatically
in this setting without pressing A/C.
For maximum defrosting and defogging, adjust the
temperature control lever to the hot end, move the
air intake lever to outside air and shut off airflow to
the outside instrument panel vents by closing the
thumbwheels to increase air through the side
defroster vents.