ECO mode CHRYSLER 200 2014 1.G Warranty Booklet

•4-Wheel Drive (4x4)(If equipped)– Transfer case and all internal parts; transfer case control
module and shift mode motor assembly; axle housing and all internal parts; axle shafts; axle shaft
bearings; driveshaft assemblies (front and rear); driveshaft centre bearings; universal joints and
yokes; disconnect housing assembly; seals and gaskets for listed components only.
•All-Wheel Drive (AWD)(If equipped)– Power transfer unit and all internal parts; driveshaft and
axle shaft assemblies; constant velocity joints and boots; axle housing and all internal parts;
differential carrier assembly and all internal parts; output ball bearing; output flange; end cover;
viscous converter clutch; overrunning clutch; vacuum motor; torque tube; pinion spacer and shim;
seals and gaskets for these parts only.
CORROSION WARRANTY
For 3 years, regardless of distance driven,your Corrosion Warranty covers any body sheet metal
panel which develops a hole caused by corrosion.
In addition, outer body panels are covered against holes caused by corrosion up to5 years or 160,000
kilometres,whichever occurs first. An outer body panel is a sheet metal panel which can be seen
while walking around the vehicle, and which is painted body colour.
This warranty applies only to holes caused by corrosion. Cosmetic or surface corrosion (resulting
from stone chips or scratches in the paint, for example) will not be repaired under this warranty.
If corrosion damage is obviously neglected and allowed to worsen until a hole develops, this warranty
will not cover the repair.
EMISSION WARRANTIES
Chrysler Canada warrants that your new vehicle was designed, built and equipped to conform at the
time of sale with applicable federal and provincial emissions standards, and that the vehicle is, at the
time of sale, free from defects in material and workmanship which would cause it to fail to conform
to the applicable emission standards within the warranty periods specified. A covered defect is one
which causes your vehicle to fail to meet applicable emission control regulations.
To keep your vehicle operating properly and in conformance with emission regulations, see the
Scheduled Maintenanceinstructions in your Owner’s Manual and herein. Only Chrysler parts
should be used for maintenance and repair of your vehicle’s emission control systems.
You should keep any receipts for maintenance service and pass them on to the next owner of your
vehicle, in case questions arise concerning maintenance. Chrysler Canada has the right to deny
warranty coverage if your vehicle has not been properly maintained, or if repairs are needed because
parts other than Chrysler parts were used; however, denial will not be based on the lack of
maintenance records alone.
Warranty service must be performed by an authorized Chrysler or Dodge Retailer.
If emergency warranty service is required and an authorized retailer is not available, contact Chrysler
Canada Customer Assistance (page 9) and request emission warranty service help.
EMISSION DEFECT WARRANTY
The 3/60 Basic Warranty covers all emission control components for3 years or 60,000 kilometres,
whichever occurs first. The Emission Defect Warranty provides longer coverage for specified
components.
The Defect Warranty covers the following major emission control parts, if so equipped, for8 years
or 130,000-kilometres,whichever occurs first:
•catalytic converter
•powertrain control module
To receive this coverage the vehicles onboard diagnostic system must indicate a failed emission
component.
5