roof CHRYSLER 200 2015 2.G Owner's Manual

SpecificationsFuel (Gasoline) ........................ .652
Oil................................. .652
Speed Control (Cruise Control) ................178
Speedometer ............................ .324
Starting .................................27
Cold Weather ......................... .449
Engine Fails to Start .....................450
Remote ...............................27
Starting and Operating .....................448
Starting Procedures ....................... .448
Steering Column Controls ...................... .165
Column Lock ......................... .176
Tilt Column .......................... .176
Wheel, Heated ........................ .177
Wheel, Tilt ........................... .176
Steering Wheel Audio Controls ...............398
Steering Wheel Mounted Sound System Controls . . .398 Storage
............................... .636
Storage, Vehicle .......................... .421
Storing Your Vehicle ...................... .636
Stuck, Freeing ........................... .580
Sunglasses Storage ....................... .279
Sun Roof .............................. .290
Sun Visor Extension ...................... .133
Supplemental Restraint System - Airbag ..........61
Synthetic Engine Oil ...................... .597
System, Remote Starting .....................27
Tachometer ............................. .331
Telescoping Steering Column .................176
Temperature Control, Automatic (ATC) ..........419
Temperature Gauge, Engine Coolant ............331
Tilt Steering Column ...................... .176
Time Delay, Headlight ..................... .161
Tip Start ............................... .449
Tire and Loading Information Placard ...........499
10
INDEX 691

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.