radiator cap CHRYSLER 200 2015 2.G Owners Manual

CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the temperature gauge reads “H,”
pull over and stop the vehicle. Idle the vehicle with
the air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H,” turn the engine off immediately and call for
service.
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
WHEEL AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to ensure
that the wheel is properly mounted to the vehicle. Any
time a wheel has been removed and reinstalled on the
vehicle the lug nuts/bolts should be torqued using a
properly calibrated torque wrench.
Torque Specifications
Lug Nut/Bolt Torque **Lug Nut/Bolt SizeLug Nut/
Bolt
Socket Size
100 Ft-Lbs (135 N·m) M12 x 1.25 19 mm
**Use only Chrysler recommended lug nuts/bolts and
clean or remove any dirt or oil before tightening.
Inspect the wheel mounting surface prior to mounting
the tire and remove any corrosion or loose particles.
550 WHAT TO DO IN EMERGENCIES

To minimize the possibility of catalytic converter damage:
•Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
• Do not try to start the engine by pushing or towing the
vehicle.
• Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
Cooling System
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
(Continued)
WARNING! (Continued)
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
to cool. Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
Engine Coolant Checks
Check the engine coolant (antifreeze) protection every 12
months (before the onset of freezing weather, where
applicable). If the engine coolant (antifreeze) is dirty, the
system should be drained, flushed, and refilled with
fresh OAT coolant (conforming to MS-12106) by an
authorized dealer. Check the front of the A/C condenser
for any accumulation of bugs, leaves, etc. If dirty, clean by
gently spraying water from a garden hose vertically
down the face of the condenser.
7
MAINTAINING YOUR VEHICLE 609

Check the engine cooling system hoses for brittle rubber,
cracking, tears, cuts, and tightness of the connection at
the coolant recovery bottle and radiator. Inspect the
entire system for leaks.
With the engine at normal operating temperature (but
not running), check the cooling system pressure cap for
proper vacuum sealing by draining a small amount of
engine coolant (antifreeze) from the radiator drain cock.
If the cap is sealing properly, the engine coolant (anti-
freeze) will begin to drain from the coolant recovery
bottle. DO NOT REMOVE THE COOLANT PRESSURE
CAP WHEN THE COOLING SYSTEM IS HOT.Cooling System — Drain, Flush And Refill
NOTE:Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could lead
to severe internal engine damage. If any coolant is
needed to be added to the system please contact your
local authorized dealer.
If the engine coolant (antifreeze) is dirty or contains visible
sediment, have an authorized dealer clean and flush with
OAT coolant (antifreeze) (conforming to MS-12106).
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
Selection Of Coolant
Refer to “Fluids, Lubricants, and Genuine Parts” in
“Maintaining Your Vehicle” for further information.
610 MAINTAINING YOUR VEHICLE

Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of engine
coolant (antifreeze), and to ensure that engine coolant
(antifreeze) will return to the radiator from the coolant
recovery tank.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.
WARNING!
•Do not open hot engine cooling system. Never add
engine coolant (antifreeze) when the engine is
overheated. Do not loosen or remove the cap to cool
an overheated engine. Heat causes pressure to
build up in the cooling system. To prevent scalding
or injury, do not remove the pressure cap while the
system is hot or under pressure.
(Continued)
WARNING! (Continued)
•Do not use a pressure cap other than the one
specified for your vehicle. Personal injury or en-
gine damage may result.
Disposal Of Used Engine Coolant
Used ethylene glycol-based engine coolant (antifreeze) is
a regulated substance requiring proper disposal. Check
with your local authorities to determine the disposal
rules for your community. To prevent ingestion by ani-
mals or children, do not store ethylene glycol-based
engine coolant in open containers or allow it to remain in
puddles on the ground. If ingested by a child or pet, seek
emergency assistance immediately. Clean up any ground
spills immediately.
7
MAINTAINING YOUR VEHICLE 613

Coolant Level
The coolant bottle provides a quick visual method for
determining that the coolant level is adequate. With the
engine OFF and cold, the level of the engine coolant
(antifreeze) in the bottle should be between the ranges
indicated on the bottle.
The radiator normally remains completely full, so there is
no need to remove the radiator/coolant pressure cap
unless checking for engine coolant (antifreeze) freeze
point or replacing coolant. Advise your service attendant
of this. As long as the engine operating temperature is
satisfactory, the coolant bottle need only be checked once
a month.
When additional engine coolant (antifreeze) is needed to
maintain the proper level, only OAT coolant that meets
the requirements of Chrysler Material Standard MS-
12106 should be added to the coolant bottle. Do not
overfill.
Points To Remember
NOTE:When the vehicle is stopped after a few miles/
kilometers of operation, you may observe vapor coming
from the front of the engine compartment. This is nor-
mally a result of moisture from rain, snow, or high
humidity accumulating on the radiator and being vapor-
ized when the thermostat opens, allowing hot engine
coolant (antifreeze) to enter the radiator.
If an examination of your engine compartment shows no
evidence of radiator or hose leaks, the vehicle may be
safely driven. The vapor will soon dissipate.
• Do not overfill the coolant expansion bottle.
• Check the coolant freeze point in the radiator and in
the coolant expansion bottle. If engine coolant (anti-
freeze) needs to be added, the contents of the coolant
expansion bottle must also be protected against freez-
ing.
614 MAINTAINING YOUR VEHICLE

•If frequent engine coolant (antifreeze) additions are
required, the cooling system should be pressure tested
for leaks.
•
Maintain engine coolant (antifreeze) concentration at a
minimum of 50% OAT coolant (conforming to MS-12106)
and distilled water for proper corrosion protection of
your engine which contains aluminum components.
• Make sure that the coolant expansion bottle overflow
hoses are not kinked or obstructed.
• Keep the front of the radiator clean. If your vehicle is
equipped with air conditioning, keep the front of the
condenser clean.
• Do not change the thermostat for Summer or Winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory engine coolant (antifreeze)
performance, poor gas mileage, and increased emis-
sions.
Brake System
In order to assure brake system performance, all brake
system components should be inspected periodically.
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
WARNING!
Riding the brakes can lead to brake failure and
possibly a collision. Driving with your foot resting or
riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You would not have your full
braking capacity in an emergency.
Brake Master Cylinder
The fluid in the master cylinder should be checked when
performing under hood services or immediately if the
“Brake Warning Light” is illuminated.
7
MAINTAINING YOUR VEHICLE 615

Belts, Seat...............................111
Body Mechanism Lubrication .................605
B-Pillar Location ......................... .499
Brake Assist System ...................... .486
Brake Control System, Electronic ..............482
Brake Fluid ............................ .655
Brake System ........................... .481
Anti-Lock (ABS) ....................... .481
Fluid Check .......................... .615
Master Cylinder ....................... .615
Warning Light ........................ .323
Brake/Transmission Interlock .................459
Brightness, Interior Lights ...................168
Bulb Replacement ........................ .637
Bulbs, Light .............................113
Camera, Rear ........................... .274
Capacities, Fluid ......................... .651Caps, Filler
Fuel ................................ .539
Oil (Engine) .......................... .589
Radiator (Coolant Pressure) ................613
Carbon Monoxide Warning ..................110
Cargo Area Features ...................... .310
Cargo Compartment ...................... .310
Car Washes ............................ .620
Cellular Phone .......................... .399
Certification Label ........................ .542
Chains, Tire ............................ .516
Changing A Flat Tire ...................... .562
Chart, Tire Sizing ........................ .494
Check Engine Light (Malfunction Indicator Light) . .592
Checking Your Vehicle For Safety ..............109
Checks, Safety .......................... .109
Child Restraint ............................86
Child Restraints Booster Seats ...........................91
676 INDEX

Center Seat LATCH..................... .100
Child Restraints .........................86
Child Seat Installation ....................103
How To Stow An Unused ALR Seat Belt .......101
Infants And Child Restraints ................89
Install A LATCH-compatible Child Restraint . . . .100
Installing Child Restraints Using The Vehicle
Seat Belt ............................. .102
LATCH Positions ........................95
Locating The LATCH Anchorages ............98
Lower Anchors And Tethers For Children .......94
Older Children And Child Restraints ..........89
Seating Positions ........................93
Using The Top Tether Anchorage ............106
Child Safety Locks .........................34
Clean Air Gasoline ....................... .531
Cleaning Wheels .............................. .621
Climate Control ......................... .400Coin Holder
............................ .306
Cold Weather Operation ....................449
Compact Spare Tire ........................511
Console, Floor .......................... .306
Console, Overhead ....................... .277
Contract, Service ......................... .667
Coolant Pressure Cap (Radiator Cap) ...........613
Cooling System .......................... .609
Adding Coolant (Antifreeze) ...............611
Coolant Capacity ...................... .651
Coolant Level ......................... .614
Disposal of Used Coolant .................613
Drain, Flush, and Refill ...................610
Inspection ........................... .609
Points to Remember .....................614
Pressure Cap ......................... .613
Radiator Cap ......................... .613
Selection of Coolant (Antifreeze) .............610
Corrosion Protection ...................... .619
10
INDEX 677

Synthetic............................ .597
Viscosity ............................ .597
Oil Filter, Change ........................ .598
Oil Filter, Selection ....................... .598
Onboard Diagnostic System ..................591
Opener, Garage Door (HomeLink®) ............281
Operating Precautions ..................... .591
Operator Manual (Owner’s Manual) .............4
Outside Rearview Mirrors ...................129
Overhead Console ........................ .277
Overheating, Engine ...................... .331
Owner’s Manual (Operator Manual) .............4
Paint Care ............................. .619
Panic Alarm ..............................24
Parking Brake ........................... .475
ParkSense® System, Rear ....................221
Passing Light ........................... .166
Pets .................................. .108Placard, Tire and Loading Information
..........500
Power Brakes .............................. .481
Deck Lid Release ........................45
Door Locks ............................32
Mirrors ............................. .131
Outlet (Auxiliary Electrical Outlet) ...........299
Sunroof ............................. .290
Windows ..............................41
Pregnant Women and Seat Belts ................57
Preparation for Jacking .....................565
Pretensioners Seat Belts ..............................57
Radial Ply Tires ......................... .507
Radiator Cap (Coolant Pressure Cap) ...........613
Radio Operation ......................... .399
Radio Remote Controls .....................398
Radio (Sound Systems) .....................397
10
INDEX 687