charging CHRYSLER 200 2016 2.G Owners Manual

Charging System Warning Light
Red TelltaleLight What It Means
Charging System Warning Light
This light shows the status of the electrical charging system. If the light stays on or comes
on while driving, turn off some of the vehicle’s nonessential electrical devices or increase
engine speed (if at idle). If the charging system light remains on, it means that the vehicle is
experiencing a problem with the charging system. Obtain SERVICE IMMEDIATELY. See an
authorized dealer.
If jump starting is required, refer to “Jump Starting Procedures” in “What To Do In Emer-
gencies.”
4
UNDERSTANDING YOUR INSTRUMENT PANEL 327

3. If using another vehicle to jump-start the battery, parkthe vehicle within the jumper cables reach, set the
parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
Jump-Starting Procedure
WARNING!
Failure to follow this jump-starting procedure could
result in personal injury or property damage due to
battery explosion.
CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive (+)end of the jumper cable to the
positive (+)post of the discharged vehicle.
2. Connect the opposite end of the positive (+)jumper
cable to the positive (+)post of the booster battery.
3. Connect the negative (-)end of the jumper cable to the
negative (-)post of the booster battery.
4. Connect the opposite end of the negative (-)jumper
cable to a good engine ground (exposed metal part of
the discharged vehicle’s engine) away from the battery
and the fuel injection system.
574 WHAT TO DO IN EMERGENCIES

WARNING!
Do not connect the jumper cable to the negative (-)
post of the discharged battery. The resulting electri-
cal spark could cause the battery to explode and
could result in personal injury. Only use the specific
ground point, do not use any other exposed metal
parts.
5. Start the engine in the vehicle that has the booster battery, let the engine idle a few minutes, and then
start the engine in the vehicle with the discharged
battery. 6. Once the engine is started, remove the jumper cables
in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative (-)end of the jumper cable
from the engine ground of the vehicle with the dis-
charged battery.
2. Disconnect the opposite end of the negative (-)jumper
cable from the negative (-)post of the booster battery.
3. Disconnect the positive (+)end of the jumper cable
from the positive (+)post of the booster battery.
4. Disconnect the opposite end of the positive (+)jumper
cable from the positive (+)post of the vehicle with the
discharged battery.
If frequent jump-starting is required to start your vehicle
you should have the battery and charging system in-
spected at your authorized dealer.
6
WHAT TO DO IN EMERGENCIES 575

AlarmArm The System ........................19
Disarm The System .......................20
Rearming The System .....................19
Tamper Alert ...........................21
Vehicle Security Alarm ....................19
Alarm, Panic .............................24
Alarm (Security Alarm) .....................325
All Wheel Drive (AWD) .....................464
Alterations/Modifications, Vehicle ...............7
Antifreeze (Engine Coolant) ...............610, 653
Disposal ............................. .613
Anti-Lock Brake System (ABS) ................475
Anti-Lock Warning Light ....................341
Appearance Care ........................ .618
Assist, Hill Start ......................... .478
Auto Down Power Windows ..................42
Automatic Door Locks ......................34
Automatic Headlights ..................... .160Automatic High Beams
.....................161
Automatic Temperature Control (ATC) ..........416
Automatic Transaxle ...................... .451
Automatic Transmission .................453, 618
Adding Fluid ...................... .618, 657
Fluid And Filter Changes ..................618
Fluid Change ......................... .618
Fluid Level Check ...................616, 617
Fluid Type ........................ .616, 657
Special Additives ...................... .617
Autostick .............................. .461
Auto Unlock, Doors ........................34
Auto Up Power Windows ....................43
Axle Lubrication ......................... .657
Battery ............................ .327, 599
Charging System Light ...................327
Keyless Transmitter Replacement (RKE) ........25
Remote Battery Replacement ................25
10
INDEX 679