lane assist CHRYSLER 200 CONVERTIBLE 2011 1.G Owners Manual

▫Headlights With Wipers (Available With
Automatic Headlights Only) ............ 159
▫ Headlight Time Delay — If Equipped ...... 159
▫ Instrument Panel Dimmer .............. 160
▫ Fog Lights — If Equipped .............. 160
▫ Daytime Running Lights — If Equipped .... 161
▫ Turn Signals ........................ 162
▫ Lane Change Assist ................... 162
▫ High/Low Beam Switch ............... 162
▫ Flash-To-Pass ....................... 162
▫ Interior Lights ...................... 163
▫ Battery Saver Feature ................. 163 
Windshield Wipers And Washers .......... 164
▫ Intermittent Wiper System .............. 165
▫ Mist Feature ........................ 166
▫ Headlights With Wipers
(Available With Auto Headlights Only) ..... 167
▫ Windshield Washers .................. 167
 Tilt/Telescoping Steering Column .......... 168
 Electronic Speed Control — If Equipped ..... 169
▫ To Activate ......................... 170
▫ To Set A Desired Speed ................ 170
▫ To Deactivate ....................... 170
▫ To Resume Speed .................... 171
▫ To Vary The Speed Setting .............. 171
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 87

Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you, to switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the headlights to turn on at high beam and
remain on until the lever is released.
NOTE:If the multifunction lever is held in the Flash-
To-Pass position for more than 15 seconds, the high
beams will shut off. If this occurs, wait 30 seconds before
activating the Flash-To-Pass function again.
Turn Signal Control
162 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Key, Sentry (Immobilizer)................... 14
Keyless Entry System ...................... 20
Keys ................................. 12
Knee Bolster ............................ 56
Lane Change and Turn Signals .........162,203,450
Lane Change Assist ...................... 162
Lap/Shoulder Belts ....................... 42
LATCH
(Lower Anchors and Tether for CHildren) .....71,73
Latch Plate ............................. 43
Latches ................................ 83
Hood ............................. 155
Lead Free Gasoline ...................... 353
Leaks, Fluid ............................ 83
Life of Tires ............................ 340
Light Bulbs .......................... 83,446
Lights .............................. 83,157
Airbag .................... 61,62,66,81,195Automatic Headlights
................. 158
Back-Up ........................... 450
Battery Saver ....................... 163
Brake Assist Warning .................. 321
Brake Warning ...................... 197
Bulb Replacement .................... 447
Courtesy/Reading .................... 163
Daytime Running .................... 161
Dimmer Switch, Headlight ...........157,162
Electronic Stability Program (ESP) Indicator . . 321
Engine Temperature Warning ............ 196
Exterior ............................ 83
Fog ......................... 160,203,449
Headlight Switch .................. 157,158
Headlights ......................... 158
Headlights On Reminder ............... 158
Headlights On With Wipers ..........159,167
High Beam ......................... 162
High Beam Indicator .................. 208
10
INDEX 491