overheating CHRYSLER 200 CONVERTIBLE 2013 1.G User Guide

CAUTION!
•When “rocking” a stuck vehicle by shifting be-
tween DRIVE and REVERSE, do not spin the
wheels faster than 15 mph (24 km/h), or drivetrain
damage may result.
•Revving the engine or spinning the wheels too fast
may lead to transmission overheating and failure.
It can also damage the tires. Do not spin the wheels
above 30 mph (48 km/h) while in gear (no trans-
mission shifting occurring).
WARNING!
Fast spinning tires can be dangerous. Forces gener-
ated by excessive wheel speeds may cause damage, or
even failure, of the axle and tires. A tire could
(Continued)
WARNING! (Continued)
explode and injure someone. Do not spin your vehi-
cle’s wheels faster than 30 mph (48 km/h) or for
longer than 30 seconds continuously without stop-
ping when you are stuck and do not let anyone near
a spinning wheel, no matter what the speed.
SHIFT LEVER OVERRIDE
If a malfunction occurs and the shift lever cannot be
moved out of the PARK position, you can use the
following procedure to temporarily move the shift lever:
1. Turn the engine OFF.
2. Firmly apply the parking brake.
3. Remove the rubber cupholder liner. Squeeze one side
of the liner’s center to expose its edge and facilitate
removal.
416 WHAT TO DO IN EMERGENCIES

CAUTION!
•The catalytic converter requires the use of un-
leaded fuel only. Leaded gasoline will destroy the
effectiveness of the catalyst as an emissions control
device and may seriously reduce engine perfor-
mance and cause serious damage to the engine.
•Damage to the catalytic converter can result if your
vehicle is not kept in proper operating condition.
In the event of engine malfunction, particularly
involving engine misfire or other apparent loss of
performance, have your vehicle serviced promptly.
Continued operation of your vehicle with a severe
malfunction could cause the converter to overheat,
resulting in possible damage to the converter and
vehicle.Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately.
440 MAINTAINING YOUR VEHICLE

Electronic Stability Control (ESC)..............336
Electronic Vehicle Information Center (EVIC)......236
Emergency, In Case of
Jacking..............................400
Jump Starting.........................410
Towing..............................417
Emission Control System Maintenance..........426
Engine.................................423
Air Cleaner...........................432
Block Heater..........................304
Break-In Recommendations................90
Checking Oil Level.....................429
Compartment.........................424
Compartment Identification...............424
Coolant (Antifreeze).....................442
Cooling..............................441
Exhaust Gas Caution.....................91
Fuel Requirements......................370
Jump Starting.........................410Oil .................................429
Oil Change Interval.....................227
Oil Filler Cap.........................423
Oil Selection..........................430
Oil Synthetic..........................431
Overheating..........................398
Starting..............................303
Temperature Gauge.....................220
Engine Oil Viscosity.......................431
Engine Oil Viscosity Chart...................431
Enhanced Accident Response Feature............64
Entry System, Illuminated....................21
Ethanol................................371
Event Data Recorder........................68
Exhaust Gas Caution........................91
Exhaust System...........................91
Extender, Seat Belt.........................56
Exterior Lights............................95
502 INDEX

Identification Logo......................430
Materials Added to.....................431
Recommendation.......................430
Synthetic.............................431
Viscosity.............................431
Oil Filter, Selection........................432
Oil Pressure Light.........................222
Onboard Diagnostic System..................425
Opener, Garage Door (HomeLink) ............192
Operating Precautions......................425
Operator Manual (Owner’s Manual).............4
Overheating, Engine.......................398
Owner’s Manual (Operator Manual).............4
Paint Care..............................453
Panic Alarm..............................26
Parking Brake............................328
Passenger Seat Back Tilt (Easy Entry System)......170
Passing Light............................181Personal Settings..........................246
Pets....................................90
Phone, Cellular...........................129
Phone, Hands-Free (Uconnect™)..............129
Placard, Tire and Loading Information..........346
Power
Accessory Delay........................12
Deck Lid Release........................38
Door Locks............................32
Mirrors..............................127
Outlet (Auxiliary Electrical Outlet)..........202
Seats................................166
Steering.............................327
Windows.............................34
Pregnant Women and Seat Belts................56
Preparation for Jacking.....................401
Pretensioners
Seat Belts.............................51
Programmable Electronic Features.............246
10
INDEX 509