garage door opener CHRYSLER 300 2008 1.G Owners Manual

CHRYSLER 300 2008 1.G Owners Manual 300 2008 1.G CHRYSLER CHRYSLER https://www.carmanualsonline.info/img/25/8415/w960_8415-0.png CHRYSLER 300 2008 1.G Owners Manual

Page 84 of 519

CHRYSLER 300 2008 1.G Owners Manual ▫To Accelerate For Passing...............151
Adaptive Cruise Control (ACC) —
If Equipped...........................152
▫Adaptive Cruise Control (ACC) Operation . . . 154
▫Activating Adaptive

Page 176 of 519

CHRYSLER 300 2008 1.G Owners Manual NOTE:
•Ensure that the rear bumper is free of dirt and debris
to keep the system operating properly.
•Jackhammers, large trucks, and other vibrations could
affect the performance of the system.
If

Page 177 of 519

CHRYSLER 300 2008 1.G Owners Manual These lights also turn on when a door is opened, or when
the unlock button on the remote keyless entry transmitter
is pressed, or when the dimmer control is turned fully
upward, past the second detent

Page 179 of 519

CHRYSLER 300 2008 1.G Owners Manual Then release both the HomeLinkand hand-held trans-
mitter buttons.
If the EVIC display states “DID NOT TRAIN” repeat Step
3. If the signal is too weak, replace the battery in the
original hand-he

Page 180 of 519

CHRYSLER 300 2008 1.G Owners Manual 5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.
This can usually be found where the hanging antenna
wire is attac

Page 181 of 519

CHRYSLER 300 2008 1.G Owners Manual 7. Return to the vehicle and press the programmed
HomeLinkbutton twice (holding the button for 2 sec-
onds each time). If the device is plugged in and activates,
programming is complete.
If the devic

Page 182 of 519

CHRYSLER 300 2008 1.G Owners Manual Then proceed with Step 4 under “Programming
HomeLink.” earlier in this section.
Using HomeLink
To operate, simply press and release the programmed
HomeLinkbutton. Activation will now occur for t

Page 183 of 519

CHRYSLER 300 2008 1.G Owners Manual Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the Learn Button on the G

Page 500 of 519

CHRYSLER 300 2008 1.G Owners Manual Selection of Coolant (Antifreeze)......436,473,475
Corrosion Protection..................... 446
Cruise Control (Speed Control)...........148,152
Cruise Light........................... 202
Cup Holder

Page 503 of 519

CHRYSLER 300 2008 1.G Owners Manual Cooling System....................... 436
Engine Oil........................421,422
Power Steering........................ 432
Transfer Case......................... 445
Fluids........................
Page:   1-10 11-20 next >