fuse CHRYSLER 300 2013 2.G Owner's Manual

Overheating, Engine.......................311
Owner’s Manual (Operator Manual) .............4
Paint Care ............................. .525
Panic Alarm ..............................23
Parking Brake ........................... .396
Park Sense System, Rear ....................247
Passing Light ........................... .203
Pedals, Adjustable ........................ .217
Pets ....................................94
Pets, Transporting ..........................94
Placard, Tire and Loading Information ..........415
Power Deck Lid Release ........................41
Distribution Center (Fuses) ................534
Door Locks ............................30
Mirrors ..............................111
Outlet (Auxiliary Electrical Outlet) ...........278
Seats ............................... .178Steering
............................. .395
Sunroof ............................. .271
Tilt/Telescoping Steering Column ............213
Windows ..............................38
Power Steering Fluid ...................... .549
Pregnant Women and Seat Belts ................57
Preparation for Jacking .....................474
Pretensioners Seat Belts ..............................55
Programming Transmitters (Remote Keyless Entry) . .21
Radial Ply Tires ......................... .421
Radiator Cap (Coolant Pressure Cap) ...........517
Radio Operation ......................... .346
Radio Remote Controls .....................344
Rain Sensitive Wiper System .................211
Rear Axle (Differential) .....................524
Rear Camera ........................... .257
Rear Cupholder ......................... .284
582 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehicle’s
electronic system to provide immunity to radio frequency signals.
Mobile two-way radios and telephone equipment must be installed
properly by trained personnel. The following must be observed
during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The negative
power connection should be made to body sheet metal adjacent to
the negative battery connection. This connection should not be
fused.
Antennas for two-way radios should be mounted on the roof or the
rear area of the vehicle. Care should be used in mounting antennas
with magnet bases. Magnets may affect the accuracy or operation
of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed away
from the vehicle wiring when possible. Use only fully shielded
coaxial cable.
Carefully match the antenna and cable to the radio to ensure a low
Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than normal
may require special precautions.
All installations should be checked for possible interference be-
tween the communications equipment and the vehicle’s electronic
systems.