radio CHRYSLER 300 2016 2.G Service Manual

Service TPMS Warning
If a system fault is detected, the TPM Telltale Light will
flash on and off for 75 seconds and then remain on solid.
The system fault will also sound a chime. In addition, the
DID will display aSERVICE TPM SYSTEM message for
a minimum of five seconds and then display dashes (- -)
in place of the pressure value to indicate which sensor is
not being received.
If the ignition switch is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the TPM Telltale Light will no longer
flash, and the SERVICE TPM SYSTEM message will no
longer display, and a pressure value will display in place
of the dashes. A system fault can occur due to any of the
following:
1. Signal interference due to electronic devices or driving next to facilities emitting the same radio frequencies as
the TPM sensors. 2. Installing aftermarket window tinting that contains
materials that may block radio wave signals.
3. Accumulation of snow or ice around the wheels or wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
Vehicles With Compact Spare
1. The compact spare tire does not have a TPM sensor. Therefore, the TPMS will not monitor the pressure in
the compact spare tire.
2. If you install the compact spare tire in place of a road tire that has a pressure below the low-pressure warn-
ing limit, upon the next ignition switch cycle, the TPM
Telltale Light will remain ON and a chime will sound.
In addition, the graphic in the DID will still display a
pressure value in a different color.
448 STARTING AND OPERATING

WARNING!
•Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is ON. You can be injured by
moving fan blades.
• Remove any metal jewelry such as rings, watch
bands and bracelets that could make an inadvertent
electrical contact. You could be seriously injured.
• Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
1. Set the parking brake, shift the automatic transmission into PARK and cycle the ignition to OFF.
2. Turn off the heater, radio, and all unnecessary electri- cal accessories. 3. If using another vehicle to jump-start the battery, park
the vehicle within the jumper cables reach, set the
parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
Jump-Starting Procedure
WARNING!
Failure to follow this jump-starting procedure could
result in personal injury or property damage due to
battery explosion.
6
WHAT TO DO IN EMERGENCIES 493

access this information to assist with the diagnosis and
service of your vehicle and emissions system.
WARNING!
•ONLY an authorized service technician should con-
nect equipment to the OBD II connection port in
order to diagnose or service your vehicle.
• If unauthorized equipment is connected to the
OBD II connection port, such as a driver-behavior
tracking device, it may:
• Be possible that vehicle systems, including
safety related systems, could be impaired or a
loss of vehicle control could occur that may result
in an accident involving serious injury or death.
• Access, or allow others to access, information
stored in your vehicle systems, including per-
sonal information. For further information, refer to “Privacy Practices” and
“Uconnect CyberSecurity” in “ All About Uconnect Ac-
cess” in your Owner ’s Manual Radio Supplement and
“Cybersecurity” in “Understanding Your Instrument
Panel” in your Owner ’s Manual on the DVD.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not
on when the engine is running, and that the OBD II
system is ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may notbe ready if your vehicle was recently
7
MAINTAINING YOUR VEHICLE 511

cleaner. Use caution when cleaning the inside rear win-
dow equipped with electric defrosters or windows
equipped with radio antennas. Do not use scrapers or
other sharp instrument that may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or cloth that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft cloth. A mild soap solution maybe used, but do not use high alcohol content or
abrasive cleaners. If soap is used, wipe clean with a
clean damp cloth.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use MOPAR Total Clean, a mild
soap solution, or lukewarm water. Do not remove the
belts from the vehicle to wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
WARNING!
A frayed or torn belt could rip apart in a collision and
leave you with no protection. Inspect the belt system
periodically, checking for cuts, frays, or loose parts.
Damaged parts must be replaced immediately. Do
not disassemble or modify the system. Seat belt
(Continued)
7
MAINTAINING YOUR VEHICLE 545

CavityCartridge Fuse Mini-FuseDescription
27 – 25 Amp Clear Amplifier – If Equipped
31 –25 Amp Breaker Power Seats – If Equipped
32 – 15 Amp BlueHVAC Module/Cluster
33 – 15 Amp BlueIgnition Switch/RF Hub
Module/Steering Column
Lock (300) – If Equipped
34 – 10 Amp RedSteering Column Module/
Clock (300)
35 – 5 Amp TanBattery Sensor
36 – 15 Amp BlueElectronic Exhaust Valve – If
Equipped
37 – 20 Amp Yellow Radio
38 – 20 Amp Yellow Power Outlet Inside Arm
Rest/Console Media Hub
40 – –Fuse – Spare
556 MAINTAINING YOUR VEHICLE

Malfunction Indicator Light (Check Engine) . . .284, 511
Manual Park Release...................... .497
Manual, Service ......................... .588
Master Cylinder (Brakes) ....................535
Memory Feature (Memory Seat) ...............146
Memory Seat ........................... .146
Memory Seats And Radio ...................146
Methanol .............................. .451
Mirrors ................................112
Electric Powered ....................... .121
Electric Remote ........................ .121
Exterior Folding ........................119
Heated .............................. .122
Outside ..............................118
Rearview .............................112
Vanity .............................. .122
Modifications/Alterations, Vehicle ...............7
Monitor, Tire Pressure System ................443
MOPAR Parts ........................ .513, 587MTBE/ETBE
........................... .451
Multi-Function Control Lever .................157
New Vehicle Break-In Period ..................99
Occupant Restraints ........................47
Octane Rating, Gasoline (Fuel) ......450, 568, 569, 570
Oil, Engine .................303, 514, 568, 569, 570
Capacity ............................ .566
Change Interval ....................... .516
Checking ......................... .514, 515
Dipstick .......................... .514, 515
Disposal ............................. .518
Filter ..................... .518, 568, 569, 570
Filter Disposal ........................ .518
Identification Logo ..................... .516
Materials Added To ..................... .518
Pressure Warning Light ...................278
Recommendation ....................516, 566
606 INDEX

Forward............................. .135
Power Lumbar ........................ .136
Rearward ............................ .135
Recline .............................. .136
Tilt ................................ .136
Up ................................ .135
Power Steering Fluid ...................... .568
Pregnant Women And Seat Belts ...............57
Preparation For Jacking .....................484
Pretensioners Seat Belts ..............................58
Programmable Features .....................314
Programming Transmitters (Remote Keyless Entry) . .22
Radial Ply Tires ......................... .431
Radiator Cap (Coolant Pressure Cap) ...........532
Radio Frequency General Information ............16, 19, 27, 31, 41
Radio Operation ......................... .337Radio Remote Controls
.....................336
Radio (Sound Systems) .....................334
Rain Sensitive Wiper System .................166
Rear Axle (Differential) .....................539
Rear Camera ........................... .229
Rear Cupholder ......................... .253
Rear ParkSense System .....................215
Rear Seat, Folding ........................ .144
Rear Wheel Drive Towing ............................. .502
Rear Window Defroster .....................261
Rear Window Features .....................261
Recorder, Event Data .......................76
Recreational Towing ...................... .476
Reformulated Gasoline .....................451
Refrigerant ............................. .522
Release, Hood ........................... .150
Reminder, Lights On ...................... .156
Reminder, Seat Belt .........................49
608 INDEX

Remote ControlStarting System .........................27
Remote Keyless Entry (RKE) ..................22
Arm The Alarm .........................20
Lock The Doors .........................24
Panic Alarm ............................24
Programming Additional Key Fobs .........18, 25
Programming Additional Transmitters .......18, 25
Remote Battery Replacement ................25
Transmitter Battery Replacement .............25
Unlatch The Trunk .......................24
Unlock The Doors .......................23
Remote Sound System (Radio) Controls .........336
Remote Starting Exit Remote Start Mode ...................30
How To Use Remote Start ..................28
To Exit Remote Start Mode And Drive The
Vehicle ...............................30
Uconnect Customer Programmable Features . . . .330 Uconnect Settings
...................... .330
Remote Starting System ......................27
Remote Trunk Release .......................45
Replacement Bulbs ....................... .560
Replacement Keys .........................18
Replacement Parts ........................ .513
Replacement Tires ........................ .439
Reporting Safety Defects ....................587
Restraint, Head ...................... .141, 143
Restraints, Child ...........................77
Restraints, Occupant ........................47
Rocking Vehicle When Stuck .................495
Rotation, Tires .......................... .442
RWD Towing ............................. .502
Safety Checks Inside Vehicle .................101
Safety Checks Outside Vehicle ................103
Safety Defects, Reporting ....................587
10
INDEX 609

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.