brake light CHRYSLER 300 2019 Vehicle Warranty

•Misapplication, improper maintenance, racing, underinflation, overin-
flation or other abuse;
• Operation without a properly functioning low pressure warning
system, for Comp T/A® ZR SSS tires;
• Uneven or rapid wear which is caused by mechanical irregularity in
the vehicle such as wheel misalignment, (a measured tread difference
of 2/32 nds of an inch (1.6 mm) or more across the tread on the same
tire);
• Accident, fire, chemical corrosion, tire alteration or vandalism;
• Flat spotting caused by improper storage or brake lock;
• The adding of liquid, solid or gaseous materials other than air, nitrogen
or carbon dioxide (for example, waterbase sealers or balancing
substances);
• Ozone or weather checking.
HOW REPLACEMENT CHARGES ARE CALCULATED
Passenger And Light Truck Tires Workmanship/Materials
A tire which becomes unserviceable due to a condition covered by this
workmanship and materials limited warranty will be replaced with a
comparable new BFGoodrich brand tire, free of charge, when 2/32 nds of
an inch (1.6 mm) or less of the original tread is worn, (or 25% or less,
whichever is more beneficial to you) and within 12 months of the date of
purchase. The cost of mounting and balancing the tire is included. Yo u
pay the cost of any other service charges and applicable taxes.
When more than 2/32 nds of an inch (1.6 mm) of the original tread has
been worn (or more than 25%, whichever is more beneficial to you) or
after 12 months from the date of purchase, you must pay the cost of a
comparable new BFGoodrich brand passenger or light truck replacement
tire on a pro rated basis. The retailer shall determine the charge by
multiplying the percentage of the original usable tread worn by the
current selling price at the adjustment location or the price on the current
BFGoodrich brand Base Price List, whichever is lower. This list is based
on a predetermined price intended to fairly represent the actual selling
price of the tire.
You pay the cost of mounting, balancing, and or any other service
charges and applicable taxes.
BFGOODRICH TIRES
28

STORING YOUR TIRES
When storing your tires for any extended period of time, be sure to
thoroughly clean your tires with a tire brush, soap, and water to remove
any dirt, salt, and brake dust from the tires. If you are storing your tires
still mounted on the wheels, use a wheel brush and approved wheel
cleaner to clean your wheels. Then dry the wheels and tires with a towel
and allow them to fully dry. DO NOT apply any tire dressings while
storing your tires. Tire compounds are made to resist weather cracking
and ozone damage. Place each clean and dry tire in an airtight plastic bag
and seal the bag with tape to help reduce oil evaporation. Store your tires
out of direct sunlight and somewhere that is well shielded from the
elements, like a climate-controlled room or dry basement. Storing the
tires in a garage or shed usually exposes the tires to a wide range of
temperatures as well as precipitation and humidity. Keep the tires away
from sources that emit ozone like electric motors that use contact brushes,
furnaces, sump pumps, etc. Although tires will still age regardless of how
they are stored, these precautions will help slow the aging process and
reduce the damage to your tires.
SPEED LIMITS
WARNING!
Operating your vehicle in excess of the posted speed limit or the
maximum speed allotted by driving conditions has the potential to
be dangerous. Higher driving speeds create excessive heat buildup
in a tire, leading to a possible tire failure.
TIRE SPINNING
WARNING!
Spinning a tire to get a stuck vehicle out of mud, ice, snow, sand, or
wet grass can be potentially dangerous. A spinning tire at a
speedometer reading above 55 km/h (35 mph) can be capable of
disintegrating a tire with explosive force. In some circumstances, a
tire may be spinning at twice the speed displayed on the
speedometer. This can cause serious injury or death to you, a
passenger, or bystander. Never spin a tire above 55 km/h (35 mph).
FALKEN TIRE CORPORATION
101

WARNING!(Continued)
Pull over to a safe area as soon as possible and inspect the tires for
signs of bulges, blisters, or separations. Seek roadside assistance or
change the damaged tire with your spare tire.
If you experience a blowout or a sudden tire failure, the following
information should be helpful:
• When the tire failure occurs, you may hear a loud noise, or feel a
vibration, and/or the vehicle may pull toward the side of the failed
tire. Do not abruptly brake or turn.
• Maintain steady pressure on the accelerator pedal.
• Hold the steering wheel firmly and steer to maintain your lane
position.
• Find a safe place to pull off the road and allow the vehicle to gradually
decelerate. Apply light braking as required to stop safely.
• Gradually pull over to the shoulder and come to a stop. Look for a
damaged tire on your vehicle.
• Seek roadside assistance or change the damaged tire with your spare
tire.
• Have all of your tires and the vehicle thoroughly inspected by a tire
professional.
TIRE ROTATION
The purpose for rotating tires is to achieve more uniform wear for all tires
on a vehicle. Your tires should be thoroughly examined on a lift by a tire
dealer for any abnormalities. If tires show uneven treadwear, ask the
service person to check and/or correct any vehicle wheel alignment or
other mechanical problem before rotation.
The following rotation patterns are acceptable. Please refer to your
vehicle Owner ’s Manual for rotation advice.
TOYO TIRES – LIMITED WARRANTY
241