oil temperature CHRYSLER 300 C 2009 1.G Owners Manual
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2009, Model line: 300 C, Model: CHRYSLER 300 C 2009 1.GPages: 537, PDF Size: 8.46 MB
Page 214 of 537

NOTE:If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
On vehicles equipped with a Premium Instrument Clus-
ter, this display shows the Electronic Vehicle Information
Center (EVIC) messages when the appropriate conditions
exist.
Lo tirE
When the appropriate condition exists the odometer
display will toggle between Lo and tirE for three cycles.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“Check Gascap” message will display in the EVIC.
Tighten the fuel filler cap properly and press the TRIP
ODOMETER button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
Refer to “Electronic Vehicle Information Center (EVIC)”
in this section for more information.
7. Tachometer
The red segments indicate the maximum permissible
engine revolutions per minute (RPM x 1000) for each gear
range. Ease up on the accelerator before reaching the red
area.
8. Engine Temperature Warning Light
This light will turn on and a single chime will
sound to warn of an overheated engine condition.
When this light turns on, the engine temperature
is critically hot. If the light turns on while driving, safely
pull over and stop the vehicle. The vehicle should be
turned OFF immediately and serviced as soon as pos-
sible. (Refer to “If Your Engine Overheats” in Section 6
for more information).
212 UNDERSTANDING YOUR INSTRUMENT PANEL
Page 218 of 537

or when towing a trailer. It should not be allowed to
exceed the upper limits of the normal operating range.
CAUTION!
Driving with a hot engine cooling system could
damage your vehicle. If the temperature gauge reads
“H,” pull over and stop the vehicle. Idle the vehicle
with the air conditioner turned off until the pointer
drops back into the normal range. If the pointer
remains on the “H,” and you hear continuous chimes,
turn the engine OFF immediately and call for service.
WARNING!
A hot engine cooling system is dangerous. You or
others could be badly burned by steam or boiling
coolant. You may want to call a service center if your
vehicle overheats. If you decide to look under the
hood yourself, refer to Section 7 and follow the
warnings under the Cooling System Pressure Cap
paragraph.
15. Trip Odometer Button
Trip Odometer Button — Base Cluster
The wordTRIPwill appear when this button is pressed.
Push in and hold the button for two seconds when the
trip odometer displays to reset it to 0 miles (km). A
second press of the button will display the outside
temperature in the odometer.
216 UNDERSTANDING YOUR INSTRUMENT PANEL
Page 323 of 537

WARNING!
Unintended movement of a vehicle could injure
those in and near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a vehicle, you should always
shift the transmission into PARK, remove the key
from the ignition, and apply the parking brake. Once
the key is removed from the ignition, the transmis-
sion shift lever is locked in the PARK position,
securing the vehicle against unwanted movement.
Furthermore, you should never leave unattended
children inside a vehicle.
Over-Temperature Mode
The transmission electronics constantly monitor the
transmission oil temperature. If the transmission exceeds
normal operating temperature, the transmission will
change the way it shifts to help control the condition.This may result in a slightly different feeling or response
during normal operation in DRIVE position. After the
transmission cools down, it will return to normal
operation.
Brake/Transmission Shift Interlock System
This vehicle is equipped with a Brake Transmission Shift
Interlock System (BTSI) that holds the shift lever in the
PARK position when the ignition switch is in the LOCK
position. To move the shift lever out of the PARK
position, the ignition switch must be turned to the
ON/RUN position, and the brake pedal must be
depressed.
Brake/Transmission Interlock Manual Override
There is an override for the BTSI that allows you to move
the shift lever out of the PARK position if an electrical
system malfunction occurs (i.e., dead battery). To access
the override, remove the rubber tray from the storage bin
STARTING AND OPERATING 321
5
Page 407 of 537

IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways — slow down.
•In city traffic — while stopped, put transmission in
NEUTRAL, but do not increase engine idle speed.
NOTE:There are steps that you can take to slow down
an impending overheat condition. If your air conditioner
is on, turn it off. The air conditioning system adds heat to
the engine cooling system and turning off the A/C
removes this heat. You can also turn the temperature
control to maximum heat, the mode control to floor, and
the fan control to high. This allows the heater core to act
as a supplement to the radiator and aids in removing heat
from the engine cooling system.
CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the temperature gauge reads “H,”
pull over and stop the vehicle. Idle the vehicle with
the air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H,” turn the engine off immediately and call for
service.
WARNING!
A hot engine cooling system is dangerous. You or
others could be badly burned by steam or boiling
coolant. You may want to call a service center if your
vehicle overheats. If you decide to look under the
hood yourself, refer to Section 7 and follow the
warnings under the “Cooling System Pressure Cap”
paragraph.
WHAT TO DO IN EMERGENCIES 405
6
Page 437 of 537

NOTE: Under no circumstances should oil change
intervals exceed 6,000 miles (10 000 km) or six months,
whichever occurs first.
Engine Oil Selection
For best performance and maximum protection under all
types of operating conditions, the manufacturer only
recommends engine oils that are API Certified and meet
the requirements of Chrysler Material Standard MS-6395.
American Petroleum Institute (API) Engine Oil
Identification Symbol
This symbol means that the oil has
been certified by the American
Petroleum Institute (API). The
manufacturer only recommends
API Certified engine oils.
Engine Oil Viscosity (SAE Grade) — 2.7L and 5.7L
Engines
SAE 5W-20 engine oil is recommended for all operating
temperatures. This engine oil improves low temperature
starting and vehicle fuel economy.
The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to “Engine Compart-
ment” in this section.
NOTE:Vehicles equipped with a 5.7L engine must use
SAE 5W-20 oil. Failure to do so may result in improper
operation of the Multi-Displacement System (MDS). Re-
fer to “Multi-Displacement System” in Section 5 for more
details.
Lubricants which do not have both, the engine oil certi-
fication mark and the correct SAE viscosity grade num-
ber should not be used.
MAINTAINING YOUR VEHICLE 435
7
Page 438 of 537

Engine Oil Viscosity (SAE Grade) — 3.5L Engine
SAE 10W-30 engine oil is recommended for all operating
temperatures.
The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to “Engine Compart-
ment” in this section.
Lubricants which do not have both, the engine oil certi-
fication mark and the correct SAE viscosity grade num-
ber should not be used.
Synthetic Engine Oils
You may use synthetic engine oils provided the recom-
mended oil quality requirements are met, and the recom-
mended maintenance intervals for oil and filter changes
are followed.
Materials Added to Engine Oil
Do not add any supplemental materials, other than leak
detection dyes, to your engine oil. Engine oil is an
engineered product and its performance may be im-
paired by supplemental additives.
Disposing of Used Engine Oil and Oil Filters
Care should be taken in disposing of used engine oil and
oil filters from your vehicle. Used oil and oil filters,
indiscriminately discarded, can present a problem to the
environment. Contact your authorized dealer, service
station, or governmental agency for advice on how and
where used oil and oil filters can be safely discarded in
your area.
436 MAINTAINING YOUR VEHICLE
Page 444 of 537

Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
Windshield Washers/Headlight Washers — If
Equipped
The windshield washer and the headlight washer (if
equipped) share the same fluid reservoir. The fluid
reservoir is located in the front of the engine compart-
ment. Be sure to check the fluid level in the reservoir at
regular intervals. Fill the reservoir with windshield
washer solvent (not radiator antifreeze) and operate the
system for a few seconds to flush out the residual water.When refilling the washer fluid reservoir, apply some
washer fluid to a cloth or towel and wipe the wiper
blades clean. This will help blade performance.
To prevent freeze-up of your windshield washer system
in cold weather, select a solution or mixture that meets or
exceeds the temperature range of your climate. This
rating information can be found on most washer fluid
containers.
The fluid reservoir will hold nearly 1 gal (4 L) of washer
fluid when the message “Low Washer Fluid” appears in
the Electronic Vehicle Information Center (EVIC) (if
equipped).
442 MAINTAINING YOUR VEHICLE
Page 515 of 537

Auto Down Power Windows................ 38
Auto Unlock, Doors....................... 32
Auto Up Power Windows.................. 39
Automatic Dimming Mirror................. 90
Automatic Door Locks...................31,32
Automatic Headlights.................... 140
Automatic Oil Change Indicator........... 211,227
Automatic Temperature Control (ATC)......... 301
Automatic Transaxle
Special Additives...................... 453
Automatic Transmission...........323,328,452,453
Adding Fluid......................453,482
Autostick............................ 332
Fluid and Filter Changes................. 453
Fluid Change......................... 453
Fluid Level Check...................... 452
Fluid Type........................... 482
Gear Ranges.......................323,328
Overdrive........................... 325Shifting..........................323,328
Special Additives...................... 453
Torque Converter...................... 326
Automatic Transmission Limp Home
Mode...........................327,331,332
Autostick............................. 332
Axle Fluid............................. 482
Axle Lubrication (Axle Fluid)............... 482
Battery............................... 438
Emergency Starting..................... 417
Jump Starting......................... 417
Keyless Transmitter Replacement (RKE)....... 25
Location..........................418,438
Belts, Seat............................44,80
Body Mechanism Lubrication............... 441
B-Pillar Location........................ 353
Brake Assist System...................... 344
Brake Control System, Electronic............. 343
INDEX 513
10
Page 519 of 537

Electronic Throttle Control Warning Light...... 218
Electronic Vehicle Information Center (EVIC).... 221
Emergency Deck Lid Release................ 43
Emergency, In Case of
Freeing Vehicle When Stuck............... 420
Hazard Warning Flasher................. 404
Jacking............................. 406
Jump Starting......................... 417
Overheating.......................... 405
Towing............................. 421
Emergency Trunk Release................... 43
Emission Control System Maintenance......431,484
Engine..........................427,428,429
Air Cleaner.......................... 437
Block Heater......................... 318
Break-In Recommendations................ 78
Checking Oil Level..................433,434
Compartment...................427,428,429
Coolant (Antifreeze).................445,481Cooling............................. 445
Exhaust Gas Caution..................79,383
Fails to Start.......................... 316
Flooded, Starting...................... 316
Fuel Requirements..................... 379
Jump Starting......................... 417
Multi-Displacement..................... 339
Oil ...........................433,479,481
Oil Change Interval............... 211,227,434
Oil Filler Cap......................435,436
Oil Filter............................ 437
Oil Filter Disposal...................... 436
Oil Selection.......................435,479
Oil Synthetic......................... 436
Overheating.......................... 405
Starting............................. 313
Temperature Gauge..................... 215
Engine Oil Viscosity...................435,436
Enhanced Accident Response Feature.......... 65
INDEX 517
10
Page 524 of 537

Lights..............................81,139
Airbag........................61,66,80,213
Anti-Lock........................... 213
Automatic Headlights................... 140
Brake Assist Warning................... 347
Brake Warning........................ 214
Bulb Replacement...................467,469
Courtesy/Reading...................145,184
Cruise.............................. 210
Daytime Running...................... 143
Dimmer Switch, Headlight.............144,145
Electronic Stability Program (ESP) Indicator . . . 347
Electronic Throttle Control Warning......... 218
Engine Temperature Warning.............. 212
Exterior.............................. 81
Fog .............................143,210
Hazard Warning Flasher................. 404
Headlight Switch...................... 139
Headlights........................139,471Headlights On Reminder................. 143
Headlights On With Wipers............141,148
High Beam........................145,217
High Beam Indicator.................... 217
High Beam/Low Beam Select............. 145
Illuminated Entry....................... 20
Instrument Cluster..................139,210
Intensity Control....................... 146
Interior..........................146,184
License............................. 478
Lights On Reminder.................... 143
Low Fuel............................ 210
LowTire ............................ 218
Malfunction Indicator (Check Engine)........ 220
Map Reading......................145,184
Oil Pressure.......................... 221
Parade Mode (Daytime Brightness).......... 146
Passing............................. 145
Reading..........................145,184
522 INDEX