hood release CHRYSLER 300 M 2004 1.G Owners Manual

WARNING!
The cargo area in the rear of the vehicle (with the
rear seatbacks in the locked-up or folded down
position) should not be used as a play area by
children when the vehicle is in motion. They could
be seriously injured in an accident. Children should
be seated and using the proper restraint system.
TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
up on the hood release lever located under the left side of
the instrument panel.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 63
3

Drive Shaft Universal Joints
Your vehicle has four constant velocity universal joints.
Periodic lubrication of these joints is not required. How-
ever, the joint boots should be inspected for external
leakage or damage when other maintenance is per-
formed.
If leakage or damage is evident, replace the universal
joint boot and grease immediately.
Continued operation could result in failure of the univer-
sal joint due to water and dirt contamination of the
grease. This would require complete replacement of the
joint assembly.
Body Lubrication
Body and other operating mechanisms and linkages
should be inspected, cleaned, and lubricated, as required,
to maintain ease of operation and to provide protection
against rust and wear.
Before the application of any lubricant, the parts con-
cerned should be wiped clean to remove dust and grit;
after lubricating, excess oil or grease should be removed.
Hood Latch
When performing other under hood services, the hood
latch release mechanism and safety catch should be
inspected, cleaned, and lubricated.
It is important to maintain proper lubrication to insure
that the hood mechanisms work properly and safely.
Multi-Purpose Lubricant, NLGI Grade 2, should be ap-
plied sparingly to all pivot and sliding contact areas.
External Lock Cylinders
Lubricate the external lock cylinders twice a year, prefer-
ably in the fall and spring. Apply a small amount of
lubricant, such as Mopar Lock Cylinder Lubricant, di-
rectly into the lock cylinder (avoid excess lubricant).
Insert the key into the lock cylinder and rotate from the
unlocked to the locked position; without adding more
lubricant. Repeat this procedure three or four times. Wipe
all the lubricant off the key with a clean cloth, to avoid
soiling clothing.
If you use a lubricant that cannot be dispensed directly
into the lock cylinder, apply a small amount of the
lubricant to the key. Insert the key into the lock cylinder,
MAINTAINING YOUR VEHICLE 211
7

Heater............................... 146
High Beam Indicator.................... 114
Holder, Coin........................... 53
Holder, Cup........................... 53
Holder, Pencil.......................... 53
Homelink Transmitter..................75,80
Hood Release.......................... 63
Hook, Coat............................ 54
Hoses............................218,220
Ignition
Key ................................ 12
Lock............................... 13
Illuminated Entry....................... 14
Infant Restraint......................... 41
Instrument Cluster................... 112,113
Instrument Panel and Controls............. 111
Instrument Panel Cover.................. 226
Instrument Panel Lens Cleaning............ 227
Interior Fuses.......................... 228
Interior Lights.......................... 64
Introduction............................ 4Jack Operation......................... 184
Jump Starting......................... 189
Key, Programming....................... 11
Key, Sentry............................. 9
Key-In Reminder........................ 12
Keyless Entry System..................... 18
Keys.................................. 9
Knee Bolster........................... 33
Lap/Shoulder Belts...................... 28
LATCH
(Lower Anchors and Tether for CHildren)..... 44
Leaks, Fluid............................ 48
Light Bulbs........................... 230
Lights
Airbag.........................37,48,115
Anti-Lock........................... 116
Automatic Off......................64,65
Battery Saver.......................64,65
Brake Warning....................... 117
Check Engine........................ 115
Courtesy/Reading..................... 65
INDEX 271
10

Transmitter, Garage Door Opener..........75,80
Transmitter Programming................. 20
Transporting Pets........................ 46
Traveler Trip Computer................... 98
Tread Wear Indicators................... 171
Trip Computer.......................98,102
Trip Odometer......................103,115
Trip Odometer Reset Button............... 115
Trunk Release, Emergency................. 27
Trunk Release Remote Control.............. 26
Turn Signals.........................68,114
Underhood Fuses....................... 228
Uniform Tire Quality Grades.............. 263
Universal Joints........................ 211
Universal Transmitter..................75,80
Vacuum/Vapor Harnesses................ 218
Vehicle Identification Number............... 6
Vehicle Loading........................ 179
Vinyl Trim............................ 225Warning Flasher, Hazard................. 182
Warnings and Cautions.................... 6
Warranty Information.................179,258
Washers, Windshield.................... 213
Washing Vehicle........................ 224
Waxing and Polishing................... 224
Wind Buffeting......................... 87
Windows
Power.............................. 25
Windshield Washers...................69,213
Windshield Wipers.................67,69,212
Wipers, Intermittent...................... 69
INDEX 277
10