trunk CHRYSLER 300 SRT 2014 2.G Owner's Manual

CAUTION!
Do not use a portable battery booster pack or any
other booster source with a system voltage greater
than 12 Volts or damage to the battery, starter motor,
alternator or electrical system may occur.
WARNING!
Do not attempt jump-starting if the battery is frozen.
It could rupture or explode and cause personal injury.
Preparations For Jump-Start
The battery is stored under an access cover in the trunk.
Remote battery posts are located on the right side of the
engine compartment for jump-starting.
Remote Battery Post Locations
1 — Remote Positive(+)Post
2 — Remote Negative (-)Post
472 WHAT TO DO IN EMERGENCIES

quality filters should be used to assure most efficient
service. MOPAR® engine oil filters are a high quality oil
filter and are recommended.
Engine Air Cleaner Filter
Refer to the “Maintenance Schedule” for the proper
maintenance intervals.
WARNING!
The air induction system (air cleaner, hoses, etc.) can
provide a measure of protection in the case of engine
backfire. Do not remove the air induction system (air
cleaner, hoses, etc.) unless such removal is necessary
for repair or maintenance. Make sure that no one is
near the engine compartment before starting the
vehicle with the air induction system (air cleaner,
hoses, etc.) removed. Failure to do so can result in
serious personal injury.
Engine Air Cleaner Filter Selection
The quality of replacement engine air cleaner filters
varies considerably. Only high quality filters should be
used to assure most efficient service. MOPAR® engine air
cleaner filters are a high quality filter and are recom-
mended.
Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic main-
tenance required.
NOTE: The battery is stored under an access cover in
the trunk. Remote battery terminals are located in the
engine compartment for jump starting. Refer to “Jump-
Starting Procedures” in “What To Do In Emergencies”
for further information.
490 MAINTAINING YOUR VEHICLE

Washing
•Wash your vehicle regularly. Always wash your ve-
hicle in the shade using MOPAR® Car Wash, or a mild
car wash soap, and rinse the panels completely with
clear water.
• If insects, tar, or other similar deposits have accumu-
lated on your vehicle, use MOPAR® Super Kleen Bug
and Tar Remover to remove.
• Use a high quality cleaner wax, such as MOPAR®
Cleaner Wax to remove road film, stains and to protect
your paint finish. Take care never to scratch the paint.
• Avoid using abrasive compounds and power buffing
that may diminish the gloss or thin out the paint finish.
CAUTION!
• Do not use abrasive or strong cleaning materials
such as steel wool or scouring powder that will
scratch metal and painted surfaces.
•
Use of power washers exceeding 1,200 psi (8 274 kPa)
can result in damage or removal of paint and decals.
Special Care
• If you drive on salted or dusty roads or if you drive
near the ocean, hose off the undercarriage at least once
a month.
• It is important that the drain holes in the lower edges
of the doors, rocker panels, and trunk be kept clear and
open.
• If you detect any stone chips or scratches in the paint,
touch them up immediately. The cost of such repairs is
considered the responsibility of the owner.
512 MAINTAINING YOUR VEHICLE

Rear Power Distribution Center (Fuses)
There is also a power distribution center located in the
trunk under the spare tire access panel. This center
contains fuses and relays.
CAUTION!
•When installing the power distribution center
cover, it is important to ensure the cover is properly
positioned and fully latched. Failure to do so may
allow water to get into the power distribution
center and possibly result in an electrical system
failure.
• When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
Rear Power Distribution Center
522 MAINTAINING YOUR VEHICLE

REPLACEMENT BULBS
All of the interior bulbs are glass wedge base or glass
cartridge types. Aluminum base bulbs are not approved
and should not be used for replacement.
Interior Bulbs
Bulb Number
Rear Courtesy/Reading
Lamps W5W
Rear Compartment
(Trunk) Lamp 562
Overhead Console Read-
ing Lamps 578
Visor Vanity Lamps A6220
Glove Box Lamp – If
Equipped 194
Door Courtesy 562
Bulb Number
Shift Indicator Lamp JKLE14140
Optional Door Map
Pocket/Cupholder LED (Serviced at
Authorized Dealer)
For lighted switches, see your authorized dealer for
replacement instructions.
Exterior Bulbs
Bulb Number
Low Beam/High Beam
(Bi-Halogen Headlamp) HIR2LL
Low Beam/High Beam
(Bi-Xenon Headlamp) D3S (Serviced at
Authorized Dealer)
Front Turn Signal Lamp PSY24WSV
Front Park Lamp LED (Serviced at Authorized Dealer)
528 MAINTAINING YOUR VEHICLE

CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
Front Turn Signal Lamps
1. Open the hood.
NOTE:Removal of the air cleaner filter housing may be
necessary prior to replacing bulbs in the headlamp
assembly on the driver side of the vehicle.
2. Reach behind the headlamp housing to access the turn signal (inboard) bulb cap.
3. Firmly grasp the cap and rotate it counterclockwise to unlock it. 4. Squeeze the two tabs on the side of the bulb socket and
pull straight out from the lamp assembly.
5. Disconnect the bulb from the wiring connector and install the replacement bulb.
6. Install the bulb and connector assembly straight into the lamp until it locks in place.
7. Install the turn signal bulb cap in the headlamp housing and rotate clockwise to lock in place.
Rear Backup Lamp And Turn Signal Lamps
1. Open the trunk.
2. Remove the trunk trim by removing the grocery hook(using a T-20 torque driver or similar tool), remove the
fastener, and pull back the weather strip.
3. Pull back the trunk liner to gain access to the tail lamp wing nuts.
7
MAINTAINING YOUR VEHICLE 531

4. Remove the three wing nuts from the back of the taillamp assembly.
5. Pull the tail lamp assembly away from the vehicle enough to access the electrical connector.
6. Push the electrical connector locking tab to the side.
7. Disconnect the electrical connector.
8. Continue removing lamp from vehicle in order to access the bulb(s).
9. Turn the appropriate bulb and socket assembly coun- terclockwise to remove it from the tail lamp assembly.
10. Disconnect the bulb from the socket assembly and install the replacement bulb. 11. Reinstall the bulb and socket assembly into the tail
lamp assembly, and then turn it clockwise.
12. Reinstall the tail lamp assembly, fasteners, electrical connector, and trunk trim.
13. Close the trunk.
License Lamp
1. Remove the screws securing the lamp to the rear fascia.
2. Remove the bulb and socket assembly.
3. Disconnect the bulb from the socket assembly and install the replacement bulb.
532 MAINTAINING YOUR VEHICLE

Emergency, In Case ofFreeing Vehicle When Stuck ................475
Hazard Warning Flasher ..................458
Jump Starting ......................... .471
Overheating .......................... .458
Emergency Trunk Release ....................44
Emission Control System Maintenance ..........484
Engine ................................ .483
Air Cleaner .......................... .490
Block Heater ......................... .376
Break-In Recommendations .................99
Checking Oil Level ..................... .487
Compartment ......................... .483
Coolant (Antifreeze) .....................500
Cooling ............................. .499
Exhaust Gas Caution .....................101
Fails to Start .......................... .374
Flooded, Starting ...................... .374
Fuel Requirements ..................... .445Jump Starting
......................... .471
Oil................................. .487
Oil Change Interval ..................... .323
Oil Filler Cap ......................... .489
Oil Selection .......................... .488
Oil Synthetic ......................... .489
Overheating .......................... .458
Starting ............................. .371
Temperature Gauge ..................... .312
Engine Oil Viscosity ...................... .489
Enhanced Accident Response Feature ............70
Entry System, Illuminated ....................21
Ethanol ............................... .446
Event Data Recorder ........................74
Exhaust Gas Caution ...................... .101
Exhaust System .......................... .101
Exterior Folding Mirrors ....................113
Exterior Lighting ......................... .195
10
INDEX 571

Programming Additional Transmitters.........18
Remote Battery Replacement ................24
Unlatch The Trunk .......................23
Unlock The Doors .......................22
Key-In Reminder ..........................15
Keyless Enter-N-Go ........................34
Keyless Enter-N-Go™ Enter The Trunk .........................23
Lock The Vehicle’s Doors ..................23
Passive Entry Programming .................34
Unlock From The Passenger Side .............22
Keyless Enter-N-Go™™ Keyless Enter-N-Go™™ ...................34
Passive Entry ...........................34
Unlock From The Driver’s Side ..............22
Keyless Entry System .......................21
Keyless Go ...............................12
Key, Replacement ..........................17
Keys ...................................12 Key, Sentry (Immobilizer)
....................16
Knee Bolster ..............................59
Lane Change and Turn Signals ................201
Lane Change Assist ....................... .202
Lap/Shoulder Belts .........................49
Latches ............................... .104
Hood ............................... .193
Latch Plate ...............................50
Lead Free Gasoline ....................... .445
Leaks, Fluid ............................ .104
Life of Tires ............................ .432
Light Bulbs ............................. .104
Lights ................................ .104
Airbag ................................67
Alarm .............................. .309
Anti-Lock ............................ .308
Automatic Headlights ....................196
Brake Assist Warning ....................410
10
INDEX 575

Remote ControlStarting System .........................26
Remote Keyless Entry (RKE) ..................21
FCC General Information ..................26
Lock The Doors .........................23
Panic Alarm ............................24
Programming Additional Key Fobs ...........18
Programming Additional Transmitters .........18
Remote Battery Replacement ................24
Transmitter Battery Replacement .............24
Unlatch The Trunk .......................23
Unlock The Doors .......................22
Remote Sound System (Radio) Controls .........352
Remote Starting EVIC Remote Start Abort Message ............28
Exit Remote Start Mode ...................29
How To Use Remote Start ..................27
To Exit Remote Start Mode And Drive The
Vehicle ...............................29 Uconnect® Customer Programmable Features . . .344
Uconnect® Settings
..................... .344
Remote Starting System ......................26
Remote Trunk Release .......................43
Replacement Bulbs ....................... .528
Replacement Keys .........................17
Replacement Parts ........................ .486
Replacement Tires ........................ .433
Reporting Safety Defects ....................561
Resetting Oil Change Indicator ................303
Restraint, Head .......................... .185
Restraints, Child ...........................75
Restraints, Occupant ........................45
Rocking Vehicle When Stuck .................475
Rotation, Tires .......................... .436
Safety Checks Inside Vehicle .................102
Safety Checks Outside Vehicle ................104
Safety Defects, Reporting ....................561
580 INDEX