battery CHRYSLER ASPEN 2009 2.G Service Manual

Minimum Requirements................. 355
Trailer and Tongue Weight................ 354
Wiring.............................. 359
Trailer Towing Guide..................... 354
Trailer Weight.......................... 354
Transaxle............................. 278
Automatic.........................12,278
Operation........................... 278
Transfer Case........................... 408
Fluid............................... 433
Transmission........................278,406
Automatic........................278,406
Fluid............................... 433
Maintenance.......................... 406
Transmitter Battery Service
(Remote Keyless Entry).................... 27
Transmitter, Garage Door Opener (HomeLinkt) . . 176
Transmitter Programming
(Remote Keyless Entry).................... 25Tread Wear Indicators.................... 321
Trip Odometer.......................... 209
Trip Odometer Reset Button................ 216
Turn Signals......................148,204,425
UCI Connector......................... 241
UConnectŸ (Hands-Free Phone).............. 88
Underhood Fuses........................ 417
Uniform Tire Quality Grades................ 456
Universal Consumer Interface (UCI) Connector . . . 241
Universal Transmitter..................... 176
Vanity Mirrors........................... 88
Variance, Compass....................... 174
Vehicle Identification Number (VIN)............ 7
Vehicle Information Center................. 167
Vehicle Loading......................312,346
Vehicle Modifications/Alterations.............. 8
Vehicle Storage......................... 423
476 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.