relay CHRYSLER CARAVAN 2000 Owner's Manual

TEST TC-17ACONTINUED - REPAIRING - TURBOCHARGER BOOST SENSOR SUPPLY HIGH
EXCEEDED
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-17A TURN IGNITION OFF.
CONTINUED FROM DISCONNECT THE
THE PREVIOUS BOOST PRESSURE
PAGE. SENSOR HARNESS
CONNECTOR.**
DISCONNECT THE ECM REMOVE THE DIESEL
HARNESS POWER RELAY.**
CONNECTORS.**
WITH A JUMPER WIRE, TURN IGNITION ON.
CONNECT DIESEL POWER
RELAY CONN. CAVITIES USE A VOLTMETER IN
30 AND 87 (IN PDC). THE FOLLOWING
FIG.1 STEP.
MEASURE THE BOOST REPAIR THE BOOST
PRESSURE SENSOR IS THE VOLTAGE YES PRESSURE SENSOR
5-VOLT SUPPLY ABOVE 1.0 VOLT? SUPPLY CIRCUIT FOR
CIRCUIT. A SHORT TO
FIG.2 VOLTAGE.*
NO
REPLACE THE ENGINE
CONTROL MODULE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
77
ProCarManuals.com

TEST TC-30AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO EARLY
Perform TEST DTC Before ProceedingT
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 8
ProCarManuals.com

TEST TC-30AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO EARLY
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TURN IGNITION ON.
START TEST ARE THERE OTHER YES DIAGNOSE OTHER
TC-30A. USING THE DRB, TROUBLE CODES SET. CODES BEFORE
CHECK FOR CONTINUING.
ADDITIONAL CODES.
NO
USING THE DRB,
ERASE CODES.
PERFORM SEVERAL TURN IGNITION ON.
IGNITION KEY CYCLES DOES THIS CODE YES CONTINUE TEST
PAUSING AT LEAST 10 USING THE DRB, APPEAR? TC-30A ON THE
SECONDS BETWEEN EACH READ CODES. NEXT PAGE.
CYCLE.
NO
AT THIS TIME THE USING THE
CONDITION TO SET SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
THE TROUBLE CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
11 9
ProCarManuals.com

TEST TC-30ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TO EARLY
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
120
ProCarManuals.com

TEST TC-30ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TO EARLY
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-30A KEY OFF.
CONTINUED FROM SUBSTITUTE THE
THE PREVIOUS DIESEL POWER RELAY
PAGE. WITH A KNOWN GOOD
RELAY.
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE NO REPLACE THE
FOR AT LEAST 10 USING THE DRB, APPEAR? INITIAL DIESEL
SECONDS BETWEEN READ CODES. POWER RELAY.*
EACH CYCLE.
YES
KEY OFF.
DISCONNECT THE ECM
REMOVE THE DIESEL HARNESS
POWER RELAY.** CONNECTORS.**
FIG.1
USING AN OHMMETER, WIGGLING THE WAS THE RESISTANCE REPAIR THE
MEASURE RESISTANCE WIRING AND ABOVE 5.0 OHMS AT YES INTERMITTENT OPEN
OF THE DIESEL POWER CONNECTORS BETWEEN ANY TIME WHILE IN THE DIESEL
RELAY CONTROL CKT THE ECM AND PDC. WIGGLING? POWER RELAY
WHILE... FIG.1 CONTROL CIRCUIT.*
NO
REINSTALL THE DIESEL
POWER RELAY.
RECONNECT THE ECM
HARNESS CONNECTORS.
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE YES REPLACE THE ENGINE
FOR AT LEAST 10 USING THE DRB, APPEAR? CONTROL MODULE.*
SECONDS BETWEEN READ CODES.
EACH CYCLE.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
121
ProCarManuals.com

TEST TC-31AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
122
ProCarManuals.com

TEST TC-31AREPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TURN IGNITION ON.
START TEST ARE THERE OTHER YES DIAGNOSE OTHER
TC-31A. USING THE DRB, TROUBLE CODES SET. CODES BEFORE
CHECK FOR CONTINUING.
ADDITIONAL CODES.
NO
USING THE DRB,
ERASE CODES.
PERFORM SEVERAL TURN IGNITION ON.
IGNITION KEY CYCLES DOES THIS CODE YES CONTINUE TEST
PAUSING AT LEAST 10 USING THE DRB, APPEAR? TC-31A ON THE
SECONDS BETWEEN EACH READ CODES. NEXT PAGE.
CYCLE.
NO
AT THIS TIME THE USING THE
CONDITION TO SET SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
THE TROUBLE CODE GUIDE, INSPECT THE FOUND? NECESSARY.*
IS NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
123
ProCarManuals.com

TEST TC-31ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
124
ProCarManuals.com

TEST TC-31ACONTINUED - REPAIRING - DIESEL POWER RELAY SHUTS OFF TOO LATE
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-31A KEY OFF.
CONTINUED FROM SUBSTITUTE THE
THE PREVIOUS DIESEL POWER RELAY
PAGE. WITH A KNOWN GOOD
RELAY. FIG.1
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE NO REPLACE THE
FOR AT LEAST 10 USING THE DRB, APPEAR? INITIAL DIESEL
SECONDS BETWEEN READ CODES. POWER RELAY.*
EACH CYCLE.
YES
KEY OFF.
DISCONNECT THE ECM
REMOVE THE DIESEL HARNESS
POWER RELAY.** CONNECTORS.**
FIG.1
USING AN OHMMETER, WIGGLING THE WAS THE RESISTANCE REPAIR THE
MEASURE RESISTANCE WIRING AND BELOW 5.0 OHMS AT YES INTERMITTENT SHORT
BETWEEN GROUND AND CONNECTORS BETWEEN ANY TIME WHILE TO GROUND IN THE
DIESEL POWER RELAY THE ECM AND PDC. WIGGLING? DIESEL POWER RELAY
CONTROL CKT WHILE... FIG.1 CONTROL CIRCUIT.*
NO
REINSTALL THE DIESEL
POWER RELAY.
RECONNECT THE ECM
HARNESS CONNECTORS.
PERFORM SEVERAL TURN IGNITION ON.
KEY CYCLES PAUSING DOES THIS CODE YES REPLACE THE ENGINE
FOR AT LEAST 10 USING THE DRB, APPEAR? CONTROL MODULE.*
SECONDS BETWEEN READ CODES.
EACH CYCLE.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
125
ProCarManuals.com

TEST TC-33ACONTINUED - REPAIRING - EGR OPEN CIRCUIT
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-33A TURN IGNITION OFF.
CONTINUED FROM DISCONNECT THE EGR
THE PREVIOUS SOLENOID HARNESS
PAGE. CONNECTOR.**
KEY ON. USING A
VOLTMETER, MEASURE IS THE VOLTAGE YES REPAIR THE OPEN
THE DIESEL POWER BELOW 10.0 VOLTS? DIESEL POWER RELAY
RELAY OUTPUT CKT. OUTPUT CKT.*
FIG.1
NO
TURN IGNITION OFF. USING AN OHMMETER, REPAIR THE SHORT
DISCONNECT THE ECM MEASURE THE EGR IS THE RESISTANCE YES TO GROUND OF THE
HARNESS SOLENOID CONTROL BELOW 5.0 OHMS? EGR SOLENOID
CONNECTORS.** CIRCUIT TO GROUND. CONTROL CKT.*
FIG.1
NO
USING AN OHMMETER,
MEASURE THE EGR IS THE RESISTANCE YES REPAIR THE OPEN
SOLENOID CONTROL ABOVE 5.0 OHMS? EGR SOLENOID
CIRCUIT. CONTROL CKT.*
FIG.2
NO
RECONNECT THE ECM
REPLACE THE EGR AND EGR SOLENOID DOES THE EGR CODE YES REPLACE THE ENGINE
SOLENOID. CONNECTORS. KEY RESET? CONTROL MODULE.*
ON. USING THE DRB,
CHECK FOR CODES.
NO
TEST COMPLETE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
129
ProCarManuals.com