belt CHRYSLER CROSSFIRE 2005 1.G Owner's Manual

If the ABS warning indicator light comes on while the
engine is running, it indicates that the ABS has detected
a malfunction and has switched off. In this case, the brake
system functions in the usual manner, but without an-
tilock assistance.
If the ABS light is on, have the system checked at your
authorized dealer as soon as possible.
13. Brake Assist Indicator Light
The indicator light for the Brake Assist Sys-
tem (BAS) is combined with the Electronic
Stability Program (ESP). This yellow indica-
tor light in the instrument cluster comes on with the
key in the ignition switch turned to the ON/RUN
position. The BAS/ESP warning indicator light also
comes on when a malfunction is detected in either the
Brake Assist System or the Electronic Stability Pro-
gram. It should go out with the engine running. If the
BAS/ESP indicator light comes on continuously, see
an authorized dealer as soon as possible.14. Seat Belt Indicator Light
With the key in the ignition, the light comes
on, and a warning sounds for a short time if
the driver’s seat belt is not fastened.
After starting the engine, the seat belt indicator light
blinks and a chime sounds periodically for up to 90
seconds to remind the driver and passenger to fasten the
seat belts. Fastening the seat belts will extinguish the
light and silence the chime.
The seat belt indicator light will remain lit until the seat
belts are fastened.
15. Charging System Indicator Light
Should the charging system indicator light
fail to come on prior to starting when the key
is in the ignition switch in the ON/RUN
position, or should it fail to go out after
starting or during operation, it indicates a malfunction
that must be repaired immediately at an authorized
dealer.
104 UNDERSTANDING YOUR INSTRUMENT PANEL

If the charging system indicator light comes on, or a loss
of power steering assistance is noticeable while the
engine is running, this may indicate that the accessory
drive belt has broken. Should this condition occur, the
belt must be replaced before continuing to operate the
vehicle.
CAUTION!
The accessory drive belt also drives the water pump.
Operating the vehicle with a failed belt can cause
engine overheating and possible severe engine dam-
age.
16. High Beam Indicator Light
This indicator will illuminate when the
headlights are in the high beam setting.
To activate the high beams, push the multifunction
control lever past the point of resistance, toward the
instrument panel.
17. Electronic Digital Clock
A digital readout in the instrument cluster shows the
time in hours and minutes whenever the ignition switch
is in the ON/RUN or ACC position.
When the ignition switch is in the OFF/LOCK position,
timekeeping is accurately maintained.
The display can be adjusted with the knob/button lo-
cated to the left of the clock.
18. Gear Indicator
For automatic transmission vehicles, the current gear
shift selector range is indicated in the gear range indica-
tor display.
19. Push Button for Time Setting
To adjust the time display, turn the key in the ignition
switch to the ON/RUN or ACC position. The knob/
button located just to the left of the clock is used to
change the time. Pull out the knob and turn it to the left
for hour adjustment; pull out the knob and turn it to the
right for minute adjustment.
UNDERSTANDING YOUR INSTRUMENT PANEL 105
4

3. Turn off the heater, radio and all unnecessary electrical
loads.
4. Connect one end of a jumper cable to the positive
jump-start attachment of the booster battery. Connect the
other end of the same cable to the positive jump-start
attachment of the discharged battery.
5. Connect the other cable, first to the negative jump-
start attachment of the booster battery and then to the
engine of the vehicle with the discharged battery. Make
sure you have good contact on the engine.6. Start the engine in the vehicle which has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
7. When removing the jumper cables, reverse the above
sequence exactly. Be careful of the moving belts and fans.
NOTE:If engine does not run after several unsuccessful
starting attempts, have it checked at the nearest autho-
rized dealer.
DRIVING ON SLIPPERY SURFACES
WARNING!
Rapid acceleration on slippery surfaces is danger-
ous. You could lose control of the vehicle and possi-
bly have an accident. Accelerate slowly and carefully
whenever there is likely to be poor traction (ice,
snow, rain, mud, loose sand, etc.).
WHAT TO DO IN EMERGENCIES 183
6

Drive Belts - Check Condition and Tension
At the distance shown in the maintenance schedules,
check all drive belts for condition and proper tension.
Improper belt tension can cause belt slippage and failure.
Inspect the drive belts for evidence of cuts, cracks, or
glazing and replace them if there is any sign of damage
which could result in belt failure. If adjustment is re-
quired, adjust the belts according to the specifications
and procedures shown in the Service Manual.
Special tools are required to properly measure tension
and to restore belt tension to factory specifications. Also,
check belt routing to make sure there is no interference
between the belts and other engine components.
Spark Plugs
Spark plugs must fire properly to assure engine perfor-
mance and emission control. New plugs should be in-
stalled at the distance specified in the appropriate main-
tenance chart. The entire set should be replaced if there is
any malfunction due to a faulty spark plug. Check the
specifications section for the proper type of spark plug
for use in your vehicle.
Engine Air Cleaner Filter
Under normal driving conditions, replace the air filter at
each interval called out by FSS.
WARNING!
The air cleaner can provide a measure of protection
in the case of engine backfire. Do not remove the air
cleaner unless such removal is necessary for repair or
maintenance. Make sure that no one is near the
engine compartment before starting the vehicle with
the air cleaner removed. Failure to do so can result in
serious personal injury.
Engine Fuel Filter
A plugged fuel filter can cause hard starting or limit the
speed at which a vehicle can be driven. Should an
excessive amount of dirt accumulate in the fuel tank,
frequent filter replacement may be necessary. See your
authorized dealer for service.
MAINTAINING YOUR VEHICLE 205
7

Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in the vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
•Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
•Dry with a soft tissue.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the
vehicle to wash them.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
CONVERTIBLE TOP CARE
CAUTION!
Due not use sharp-edged instruments to remove
snow or ice from the soft top.
NOTE:Place a suitable cover over the top if your are
going to park the vehicle outside for a extended period of
time.
Immediate removal of any contaminant is recommended.
Regular washing of the top will enhance its life and
appearance, and make successive cleanings easier. Do not
subject the top to excessive heat. Frequently vacuum the
top and cargo compartment divider.
226 MAINTAINING YOUR VEHICLE

SPECIFICATIONS
Engine Specifications
Engine Size 195.2 CID (3.2 Liters)
Mode of Operation 4–stroke engine, gasoline
injection
No. of Cylinders 6
Horsepower (SAE J 1349) 215 hp (160 kW) @ 5700
rpm
Bore 3.54 in. (89.90 mm)
Stroke 3.30 in. (84.00 mm)
Torque (SAE J 1349) 229 ft. lbs. (310 N·m) @
3000 rpm
Firing Order 1–4–3–6–2–5
Compression Ratio 10:1
Spark Plugs Bosch F 8 DPER/ NGK
PFR 5–11
Spark Plug Gap 0.039 in. (1.0 mm)
Tightening Torque 15-22 ft. lbs. (20-30 N·m)
Maximum Engine Speed 6000 rpm
Accessory Drive Belt 94.1 in. (2390 mm)Performance Specifications (approximate)
Maximum Speed 150 mph (242 km/h)
Acceleration 0–60 mph 6.5 seconds
1/4 mile time 14.9 seconds at 96 mph
(154 km/h)
Gear Ratios - 6-Speed Manual Transmission
First 4.459
Second 2.614
Third 1.723
Fourth 1.245
Fifth 1.000
Sixth 0.838
Reverse 4.062
Gear Ratios - 5-Speed Automatic Transmission
First 3.95
Second 2.423
Third 1.486
Fourth 1.00
Fifth 0.833
Reverse 3.147/1.93
MAINTAINING YOUR VEHICLE 241
7

SCOPE OF WORK FOR “B” SCHEDULE
MAINTENANCE SERVICE
Oil Change
•Change oil and replace filter
Maintenance
•Rotate tires
•Replace dust filter
•Lubricate hood hinges, latch, and secondary latch
•Reset FSS Display
Function Check
•Horn, hazard warning flashers, turn signals, and indi-
cator lamps
•Headlamps and exterior lighting
•Windshield wipers and washer system
•Check seat belts for damage and proper function
•Test hydraulic brakes and check parking brake func-
tionInspection
•Check front and rear brake pads for lining thickness
•Check condition of front and rear brake discs
•Check tires for damage and general condition
•Check tire inflation pressures and correct if necessary
•Check major underbody components for leakage or
damage (if there are signs of leakage, determine cause
and repair)
•Check condition of front axle ball joints and rubber
boots
•Check condition of steering components and rubber
boots
•Check underhood components for leakage or damage
(if there are signs of leakage determine cause and
repair)
•Check condition of accessory drive belt
•Check headlamp aiming, adjust if necessary
•Check windshield wiper blades, replace if necessary
MAINTENANCE SCHEDULES 251
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

ABS (Anti-Lock Brake) System............. 103
Adding Engine Coolant (Antifreeze)......... 215
Adding Fuel.......................... 166
Aiming Headlights...................... 238
Air Cleaner, Engine..................... 205
Air Conditioning....................121,208
Air Conditioning Filter................... 256
Air Conditioning Refrigerant.............. 209
Air Conditioning System................. 208
Air Pressure, Tires...................153,154
Airbag................................ 28
Airbag Deployment...................... 32
Airbag Light........................31,109
Airbag Maintenance...................... 38
Airbag On/Off Switch..................36,40
Alignment and Balance.................. 163
Antenna.............................. 120
Antifreeze (Engine Coolant)............... 243
Anti-Lock Warning Light................. 103
Appearance Care....................... 222
Ashtrays and Lighter..................... 63
Automatic Door Locks.................... 13
Automatic Transmission...............135,220Fluid and Filter Changes................ 221
Fluid Level Check..................... 220
Fluid Type.......................... 220
Special Additives..................... 221
Autostick............................. 139
Ball Joints............................ 210
Battery............................104,207
Saving Feature........................ 72
Belts, Drive........................... 205
Belts, Seat............................. 21
Body Mechanism Lubrication.............. 211
Brake Assist System...................... 85
Brake, Parking......................... 142
Brake System.......................144,217
Anti-Lock........................... 144
Hoses.............................. 218
Master Cylinder...................... 219
Break-In Recommendations, New Vehicle . . . 46,152
Bulbs, Light........................... 235
Capacities, Fluid....................... 241
Capacity, Cargo Weight.................. 168
274 INDEX

Disposal
Engine Oil.......................... 204
Door Locks, Automatic................... 13
Drive Belts............................ 205
Drive Shaft Universal Joints............... 210
Driving
On Slippery Surfaces................156,183
Electronic Speed Control.................. 88
Electronic Stability Program................ 86
Emergency, In Case of
Hazard Warning Flasher................ 172
Jump Starting........................ 181
Overheating......................... 172
Towing............................. 185
Emergency Trunk Release................. 19
Emission Control System Maintenance....199,249
Engine
Break-In Recommendations............... 46
Checking Oil Level.................... 201
Compartment........................ 197
Oil .............................201,243
Oil Change Interval................... 202Oil Selection......................... 204
Exhaust Gas Caution..................... 46
Exhaust System........................ 213
Exterior Lights......................... 235
Filters
Air Cleaner.......................... 205
Air Conditioning..................... 256
Engine Fuel......................... 205
Engine Oil.......................... 204
Fluid Capacities.....................241,243
Fluid Leaks............................ 47
Fluid Level Checks
Manual Transmission.................. 221
Four-Way Hazard Flasher................. 172
Freeing A Stuck Vehicle.................. 184
Fuel................................. 164
Adding............................. 166
Additives........................... 166
Filler Cap........................... 166
Filter.............................. 205
Octane Rating........................ 164
Fuses................................ 228
276 INDEX

Garage Door Opener..................... 92
GasCap .............................. 166
Gasoline............................. 243
Gasoline/Oxygenate Blends............... 165
Gear Ratios........................... 241
Glass Cleaning......................... 225
Glove Compartment..................... 65
Hazard Warning Flasher.................. 172
Headlights
Aiming............................. 238
Cleaning............................ 225
Dimmer Switch....................... 76
Heater............................... 121
Hood Latch Maintenance................. 211
Hood Release.......................... 70
Hoses............................... 217
Ignition
Key ................................. 9
Wiring System....................... 207
Illuminated Entry....................... 72
Infant Restraint......................... 39Inside Rearview Mirror................... 66
Instrument Cluster....................... 99
Instrument Panel and Controls.............. 98
Instrument Panel Cover.................. 225
Instrument Panel Lens Cleaning............ 226
Interior Appearance Care................. 224
Introduction............................ 4
Jack Location.......................... 178
Jack Operation......................... 174
Jump Starting......................... 181
Key-In Reminder........................ 10
Keyless Entry System..................... 14
Keys.................................. 9
Knee Bolster........................... 28
Lap/Shoulder Belts...................... 22
Light Bulbs........................... 235
Lights
Airbag...........................31,109
Anti-Lock Warning.................... 103
Back-Up............................ 237
INDEX 277
10