adding oil CHRYSLER CROSSFIRE 2006 1.G Owners Manual

The best time to check the engine oil level is about 5
minutes after a fully warmed engine is shut off, or before
starting the engine after it has sat overnight.
Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Maintain
the oil level between the MIN and MAX markings on the
dipstick. Adding 1 quart of oil when the reading is at the
MIN mark will result in a MAX reading on this engine.
210 MAINTAINING YOUR VEHICLE

Insert the key into the lock cylinder and rotate from the
unlocked to the locked position without adding more
lubricant. Repeat this procedure three or four times. Wipe
all the lubricant off the key with a clean cloth, to avoid
soiling clothing.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild non-abrasive cleaner, or use the washer solvent.
This will remove accumulations of salt or road film and
help reduce streaking, chatter, and smearing.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield. Avoid using the wiper blades to
remove frost or ice from the windshield. Make sure that
they are not frozen to the glass before turning them on to
avoid damaging the blade. Keep the blade rubber out of
contact with petroleum products such as engine oil,
gasoline, etc.
Windshield Wiper Blade Replacement
1. Lift the wiper arm away from the glass.
2. Rotate the blade 45 degrees to gain access to the
release tab.
3. Push the release tab as shown in the illustration and
slide the wiper blade assembly down along the arm.
Gently place the wiper arm on the windshield.
4. Install the new blade assembly onto the wiper arm tip
until it locks in place.
MAINTAINING YOUR VEHICLE 219
7

Disposal
Engine Oil.......................... 212
Door Locks, Automatic................... 13
Drive Belts............................ 213
Drive Shaft Universal Joints............... 218
Driving
On Slippery Surfaces.................. 189
Electronic Speed Control.................. 94
Electronic Stability Program................ 91
Emergency, In Case of
Hazard Warning Flasher................ 178
Jump Starting........................ 187
Overheating......................... 178
Towing............................. 191
Emergency Trunk Release................. 19
Emission Control System Maintenance....207,257
Engine
Break-In Recommendations............... 47
Checking Oil Level.................... 209
Compartment........................ 205
Oil .............................209,251
Oil Change Interval................... 211Oil Selection......................... 212
Exhaust Gas Caution..................... 47
Exhaust System........................ 221
Exterior Lights......................... 243
Filters
Air Cleaner.......................... 213
Air Conditioning..................... 264
Engine Fuel......................... 213
Engine Oil.......................... 212
Fluid Capacities.....................249,251
Fluid Leaks............................ 48
Fluid Level Checks
Manual Transmission.................. 229
Fluids, Lubricants and Genuine Parts........ 252
Four-Way Hazard Flasher................. 178
Freeing A Stuck Vehicle.................. 190
Fuel................................. 171
Adding............................. 173
Additives........................... 172
Filler Cap........................... 173
Filter.............................. 213
Octane Rating........................ 171
284 INDEX