radio CHRYSLER PT CRUISER 2005 1.G Owners Manual

NOTE:You may turn off this feature and unlock all
doors with one press of the button by following the
procedure shown in the Central Locking/Unlocking
paragraph.
To Lock The Doors:
Press and release the LOCK button to lock all doors and
liftgate. The park lights will flash and the horn will chirp
to acknowledge the signal.
Horn Chirp Feature
The horn chirp that signals that the doors have been
locked can be turned on or off by using the following
procedure:
1. Insert the key into the ignition switch and turn the
switch to the ON position.
2. Press and hold the Unlock button on the transmitter
for between four and ten seconds.3. Continue to hold the Unlock button and press the
Lock button.
4. Release both buttons.
A chime will sound to signify that the process is com-
plete.
Using The Panic Alarm:
To turn on the panic alarm feature, press and release the
PANIC button. When the panic alarm is on the headlights
and park lights will flash, the horn will pulse on and off
and the interior lights will turn on.
The panic alarm will stay on for 3 minutes unless you
press the PANIC button a second time, or until vehicle
speed reaches 15 mph (24 km/h).
NOTE:When you turn off the panic alarm by pressing
the PANIC button a second time, you may have to be
closer to the vehicle due to the radio frequency noises of
the system.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 23
2

To Program Transmitters
Up to four transmitters can be programmed to your
vehicle. Your new vehicle was shipped with two trans-
mitters. See your dealer for additional transmitters
Additional transmitters can be programmed to the sys-
tem by using the following procedure:
1. Insert the key into the ignition switch and turn the
switch to the ON position.
2. Press and hold the Unlock button on the transmitter
between four and ten seconds.
3. Continue to hold the Unlock button and press the
Panic button. A chime will sound to indicate that the
transmitter programming mode has been entered.
4. Press a button on all transmitters to be programmed to
the system, including any previously programmed trans-
mitters. A chime will sound when each transmitter has
been programmed.5. Turn the ignition switch off to exit the transmitter
programming mode.
General Information
This device complies with FCC rules part 15 and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:
•This device may not cause harmful interference.
•This device must accept any interference that may be
received, including interference that may cause undes-
ired operation.
If your transmitter fails to operate from a normal dis-
tance, check for these two conditions.
1. Weak batteries in transmitter. The expected life of
batteries is from one to two years.
2. Closeness to a radio transmitter such as a radio station
tower, airport transmitter, and some mobile or CB radios.
24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Illuminated Vanity Mirrors — If Equipped
An illuminated vanity mirror is on the sun visor. To use
the mirror, rotate the sun visor down and swing the
mirror cover upward. The lights turn on automatically.
Closing the mirror cover turns off the lights.
Sun Visor Sliding Feature
The sun visors may be pulled out to provide extended
coverage of the side glass.
HANDS–FREE COMMUNICATION (UConnect™) —
IF EQUIPPED
UConnect™ is a voice-activated, hands-free, in-vehicle
communications system. UConnect™; allows you to dial
your cellular phone using simple voice commands (e.g.,
“Call Mike Work” or “Dial 248-555-1212”). Your cellular
phone’s audio is transmitted through your vehicle’s
stereo system; the system will automatically mute your
radio before receiving or sending a call.
NOTE:The UConnect™ system use requires a cellular
phone equipped with the BluetoothHands-Free Profile,
version 0.96 or higher.
For UConnect Customer Support call 1-877-855-8400 or
visit the UConnect website (www.chrysler.com/
uconnect).
Illuminated Vanity Mirror
70 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

The UConnect™ system can be used with any Hands
Free Profile certified Bluetooth™ cellular phone. If your
cellular phone has a different profile (i.e. headset profile),
you will not be able to use any UConnect™ features.
The UConnect™ system is fully integrated into your
vehicle, including your vehicle’s stereo system. All voice
prompts as well as the other party’s voice in a conversa-
tion will be played over your vehicle’s stereo system. The
volume of the UConnect™ system can be controlled
through your normal stereo controls.
The radio display will be used for visual prompts from
the UConnect™ system such as caller ID.
Operation
Voice commands can be used in the operation of the
UConnect™ system and to navigate through the UCon-
nect™ menu structure. Voice commands should be given
after each UConnect™ system prompt. You will beprompted for a specific command and then guided
through the available options. There are two ways to give
commands to the UConnect™ system:
•You can sayDialat theReadyprompt. When
prompted for the phone number you wish to dial, say
the phone number (123 456 7890).
•Alternatively as you become familiar with the UCon-
nect™ system, you can combine the commands and
sayDial 123 456 7890.
Pairing a Cellular Phone to the UConnect™ System
To begin using your UConnect™ system, you must pair
your compatible Bluetooth™ enabled cellular phone. To
complete the registration process, you will need to refer-
ence your cellular phone owner’s manual.
•Press the ’Phone’ button to begin.
•After theReadyprompt, saySetup Phone Pairing.
72 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Interior light Defeat (OFF)
Rotate the dimmer control to the ex-
treme bottom “OFF” position. The in-
terior lights will remain off when the
doors are open.
Parade Mode (Daytime Brightness Feature)
Rotate the dimmer control to the first
detent (white semi-circle). This feature
brightens the odometer and radio dis-
play when the parking lights or head-
lights are on during daylight condi-
tions.
Multi-Function Control Lever
The Multi-Function Control Lever controls the operation
of the headlights, parking lights, turn signals, headlight
beam selection, instrument panel light dimming, interior
lights, the passing lights, and fog lights. The lever is
located on the left side of the steering column.
Headlights, Parking Lights, Instrument Panel
Lights
Turn the end of the Multi-Function Control Lever to the
first detent for parking light operation. Turn to the
second detent for headlight operation.
96 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Tilting the steering column while the vehicle is
moving is dangerous. Without a stable steering col-
umn, you could lose control of the vehicle and have
an accident. Adjust the column only while the ve-
hicle is stopped. Be sure it is locked before driving.
TRACTION CONTROL SWITCH — IF EQUIPPED
The TRAC indicator, located in the instrument cluster,
will flash when the Traction Control System is in use.
The TRAC OFF switch is located on the instrument panel
below the radio.
To turn the system OFF, press the TRAC OFF switch until
the TRAC OFF indicator in the instrument cluster lights
up.To turn the system back ON, press the switch a second
time until the TRAC OFF indicator turns OFF.
Traction Control Switch
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 101
3

UNDERSTANDING YOUR INSTRUMENT PANEL
CONTENTS

Instrument Panel Features.................133

Instrument Cluster......................134

Instrument Cluster—Turbo, With AutoStick....135

Instrument Cluster—Turbo, Without AutoStick . . 136

Instrument Cluster Descriptions............137

Electronic Digital Clock..................144
▫Clock Setting Procedure.................144

Radio General Information................144
▫Radio Broadcast Signals.................144▫Two Types Of Signals..................145
▫Electrical Disturbances..................145
▫AM Reception.......................145
▫FM Reception........................145

Sales Code RBB—AM/FM Stereo Radio With
Cassette Tape Player And CD Changer
Capability............................146
▫Radio Operation......................146
▫Mode Button........................148
▫Scan Button (Radio Mode)...............1484

▫Cassette Player Features................149
▫CD Changer Control Capability
— If Equipped.......................150

Sales Code RAZ—AM/ FM Stereo Radio With
Cassette Tape Player, CD Player And CD Changer
Controls.............................152
▫Operating Instructions — Radio...........152
▫Power Switch, Volume Control............153
▫Seek Button (Radio Mode)...............153
▫Tuning.............................153
▫Radio Data System (RDS)...............153
▫PTY (Program Type) Button..............154
▫Balance............................155
▫Fade..............................155▫Tone Control........................155
▫AM/FM Selection.....................156
▫Scan Button.........................156
▫To Set The Radio Push-Button Memory......156
▫To Change From Clock To Radio Mode......157
▫Operating Instructions — Tape Player.......157
▫Seek Button.........................157
▫Fast Forward (FF).....................157
▫Rewind (RW)........................157
▫Tape Eject...........................158
▫Scan Button.........................158
▫Changing Tape Direction................158
▫Metal Tape Selection...................158
130 UNDERSTANDING YOUR INSTRUMENT PANEL

▫Pinch Roller Release...................158
▫Noise Reduction......................158
▫Operating Instructions — CD Player........159
▫Inserting The Compact Disc..............159
▫Seek Button.........................160
▫EJT CD (Eject) Button..................160
▫FF/Tune/RW........................160
▫Program Button 4 (Random Play)..........160
▫Mode..............................161
▫Tape CD Button......................161
▫Time Button.........................161
▫Scan Button.........................161▫CD Changer Control Capability
— If Equipped.......................161

Sales Code RBK—AM/ FM Stereo Radio With
CD Player And CD Changer Controls........163
▫Radio Operation......................163
▫CD Player Operation...................165
▫CD Changer Control Capability
— If Equipped.......................167

Sales Code RBQ—AM/FM Stereo Radio With
6 - Disc CD Changer....................169
▫Radio Operation......................170
▫CD Player Operation...................172

Sales Code RB1—AM/FM Stereo Radio With
DVD/GPS Navigation System..............177
UNDERSTANDING YOUR INSTRUMENT PANEL 131
4

Satellite Radio — If Equipped..............177
▫System Activation.....................178
▫Electronic Serial Number/Sirius Identification
Number (ENS/SID)....................178
▫Selecting Satellite Mode In RBB, RAH And
RBK Radios.........................179
▫Selecting Satellite Mode In RBP, RBU, RAZ,
RB1 And RBQ Radios..................179
▫Selecting a Channel....................179
▫Storing And Selecting Pre-Set Channels......180
▫Using The PTY (Program Type) Button
(If Equipped)........................180
▫PTY ButtonScan.....................180
▫PTY ButtonSeek.....................180▫Satellite Antenna......................181
▫Reception Quality.....................181

Cassette Tape And Player Maintenance.......181

CD/DVD Disc Maintenance...............182

Radio Operation And Cellular Phones........183

Climate Controls.......................183
▫Air Conditioning.....................183
▫Operating Tips.......................188

Rear Window Features...................190
▫Electric Rear Window Defroster...........190
▫Rear Wiper/Washer Switch..............191
▫Adding Washer Fluid..................192
132 UNDERSTANDING YOUR INSTRUMENT PANEL