odometer CHRYSLER PT CRUISER 2007 1.G Owners Manual

5. Tachometer
The white area of the scale shows the permissible engine
revolutions-per-minute (rpm x 1000) for each gear range.
Before reaching the red area, ease up on the accelerator to
prevent engine damage.
6. Transmission Range Indicator
This display indicator shows the automatic transmission
gear selection.
7. Odometer/Trip Odometer
A vacuum fluorescent display indicates the total distance
the vehicle has been driven. Also, the cluster will display,
replacing the odometer/trip odometer, vehicle warning
messages such as: door/deck/hatch/gate ajar and loose
gas cap. Loose gas cap will be displayed from the
Odometer/Trip Odometer on all models.
NOTE:If vehicle is equipped with the optional Elec-
tronic Vehicle Information Center (EVIC) in the instru-
ment cluster, all warnings including “door”, “dECK”,“hATCh”, and “gATE” will only be displayed in the
EVIC display. For additional information, refer to “Elec-
tronic Vehicle Information Center — If Equipped” in
Section 3.
U.S. federal regulations require that upon transfer of
vehicle ownership, the seller certify to the purchaser the
correct mileage that the vehicle has been driven. There-
fore, if the odometer reading is changed during repair or
replacement, be sure to keep a record of the reading
before and after the service so that the correct mileage can
be determined.
8. Cruise Indicator — If Equipped
This indicator shows that the Speed Control
System is ON. (See page 187 for more informa-
tion.)
NOTE:The word “SET”will notilluminate when the
Speed Control System is on.
UNDERSTANDING YOUR INSTRUMENT PANEL 221
4

21. Oil Pressure Light
Shows low engine oil pressure. The light will come
on and remain on when the ignition switch is
turned from the OFF to the ON position, and the light
will turn off after the engine is started. If the bulb does
not come on during starting, have the system checked by
an authorized dealer.
If the light comes on and remains on while driving, stop
the vehicle and shut off the engine. DO NOT OPERATE
THE VEHICLE UNTIL THE CAUSE IS CORRECTED.
The light does not show the quantity of oil in the engine.
This can be determined using the procedure shown in
Section 7. (See page 363 for more information.)
22. High Beam Indicator
This light shows that the headlights are on high
beam. Pull the turn signal lever toward the steer-
ing wheel to switch the headlights from high or low
beam.23. Electronic Vehicle Information Center Display—If
Equipped
When the appropriate conditions exist, this display
shows the Electronic Vehicle Information Center (EVIC)
messages. (See page 227 for more information.)
24. Odometer/Trip Odometer Reset Knob
Press this button to change the display from odometer to
either of the two trip odometer settings. Trip A or Trip B
will appear when in the trip odometer mode. Push in and
hold the button for two seconds to reset the trip odometer
to 0 miles or kilometers. The odometer must be in trip
mode to reset.
25. Electronic Vehicle Information Center (EVIC)
Button—If Equipped
Pushing this button will switch between the different
EVIC functions. (See page 227 for more information.)
226 UNDERSTANDING YOUR INSTRUMENT PANEL

Display English or Metric
The EVIC, odometer, and navigation system units can be
changed between English and Metric.
Press and hold the EVIC button when in this display until
“US” or “METRIC” appears to make your selection.
Compass Variance
Compass Variance is the difference between magnetic
North and Geographic North. In some areas of the
country, the difference between magnetic and geographic
North is great enough to cause the compass to give false
readings. In order to ensure compass accuracy, the com-
pass variance should be properly set according to the
compass variance map zone that the vehicle is in.
NOTE:Magnetic materials should be kept away from
the Instrument Panel. This is where the compass sensor is
located.
234 UNDERSTANDING YOUR INSTRUMENT PANEL

TRACTION CONTROL — IF EQUIPPED
The Traction Control System will improve acceleration
and steering on slippery surfaces by reducing tire spin.
The system reduces wheel slip and maintains traction at
the driving (front) wheels by engaging the brake on the
wheel that is losing traction. When this occurs the TRAC
indicator light located above the instrument cluster
odometer will flash. The system operates at speeds below
35 mph (56 km/h).
A push-button at the center of the instrument panel,
below the radio, turns the Traction Control System ON or
OFF.The system is always in the “ON” mode unless:•The TCS OFF switch has been used to turn the system
off;
•There is a Anti-Lock Brake System malfunction;
•There is a Traction Control System malfunction;
•The system has been automatically deactivated to
prevent damage to the brake system due to overheated
brake temperatures.
NOTE:Extended heavy use of Traction Control may
cause the system to deactivate and turn on the TRAC
OFF Light located in the instrument cluster.
This is to prevent overheating of the brake system and is
a normal condition. The system will remain disabled for
about 4 minutes until the brakes have cooled. The system
will automatically reactivate and turn off the TRAC OFF
light.
If your vehicle becomes stuck in mud, ice, or snow, turn
the Traction Control System Off before attempting to
“rock” the vehicle free.
TCS OFF Switch
298 STARTING AND OPERATING

CAUTION!
Replacing original tires with tires of a different size
may result in false speedometer and odometer read-
ings.
Alignment And Balance
Poor suspension alignment may result in:
•Fast tire wear.
•Uneven tire wear, such as feathering and one-sided
wear.
•Vehicle pull to right or left.
Tires may also cause the vehicle to pull to the left or right.
Alignment will not correct this condition. See your dealer
for proper diagnosis.Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.
TIRE CHAINS
Due to limited clearance, tire chains are not recom-
mended.
CAUTION!
Damage to the vehicle may result if tire chains are
used.
316 STARTING AND OPERATING

NOTE:Tighten the gas cap about 1/4 turn until you
hear one click. This is an indication that cap is properly
tightened.
If the gas cap is not tighten properly, the Malfunction
Indicator Light will come on. Be sure the gas cap is
tightened every time the vehicle is refueled.
WARNING!
A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on the
ground while filling.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“gASCAP” message will be displayed in the Odometer/
Trip Odometer in the instrument cluster. Refer to “Instru-
ment Cluster Description” in Section 4 of this manual.
Tighten the fuel filler cap properly and press the
odometer/trip odometer reset button to turn the message
off. If the problem continues, the message will appear the
next time the vehicle is started. Refer to “Onboard
Diagnostic System — OBDII” in Section 7 of this manual
for more information.
STARTING AND OPERATING 325
5

gas cap is properly tightened. Press the odometer reset
button to turn the message off. If the problem persists,
the message will appear the next time the vehicle is
started. This might indicate a damaged cap. If the prob-
lem is detected twice in a row, the system will turn on the
Malfunction Indicator Light (MIL). Resolving the prob-
lem will turn the MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states, which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
MAINTAINING YOUR VEHICLE 361
7

Gasoline, Reformulated................... 320
Gauges
Coolant Temperature.................... 220
Fuel................................ 220
Odometer........................... 221
Tachometer.......................... 221
Gearshift.............................. 283
General Information...................... 17
General Maintenance..................... 363
Glass Cleaning.......................... 393
Gross Axle Weight Rating.................. 327
Gross Vehicle Weight Rating................ 326
Hands-Free Phone (UConnect™)............. 134
Hazard Warning Flasher................... 340
Head Restraints......................... 162
Headlights
Bulb Replacement...................... 401
Cleaning............................ 392High Beam........................182,226
High Beam/Low Beam Select Switch........ 182
Passing............................. 182
Switch .............................. 179
Heated Seats........................... 163
Hitches
TrailerTowing ........................ 329
HomeLink(Garage Door Opener) Transmitter . . . 190
Hood Release.......................... 176
Hoses................................ 382
Ignition............................... 13
Key ................................. 13
Wiring System (Spark Plug Wires).......... 368
Ignition Key Removal..................... 13
Immobilizer (Sentry Key)................. 15,36
Infant Restraint....................... 70,104
Information Center, Vehicle................. 227
Inside Rearview Mirror................... 131
448 INDEX

Schedule “B”......................... 411
Schedule “B”-All Engines................ 411
Maintenance Schedules.................... 408
Malfunction Indicator Light (Check Engine) . . 222,361
Manual Override, Convertible Top.........130,353
Manual, Service......................... 438
Manual Transaxle..................279,288,388
Downshifting......................... 291
Fluid Level Check...................... 388
Frequency of Fluid Change............... 389
Lubricant Selection..................... 388
Map/Reading Lights..................177,178
Master Cylinder (Brakes).................. 384
Mirrors ............................... 131
Electric Remote....................... 133
Outside............................. 132
Rearview............................ 131
Vanity .............................. 133
Modifications/Alterations, Vehicle............. 7Mopar Parts.........................362,437
Multi-Function Control Lever............... 178
New Vehicle Break-In Period................ 111
Occupant Classification System (OCS).......... 59
Occupant Restraints (Convertible)............. 79
Occupant Restraints (Sedan)................. 44
Octane Rating, Gasoline (Fuel).............. 318
Odometer............................. 221
Trip .............................221,226
Oil, Engine.........................363,404
Capacity............................ 404
Change Interval....................... 364
Checking............................ 363
Disposal............................ 367
Filter ............................... 367
Identification Logo..................... 366
Materials Added to..................... 367
INDEX 451
10

Sentry Key (Immobilizer)................. 15,36
Sentry Key Programming................... 17
Service and Maintenance.................. 408
Service Assistance....................... 434
Service Contract......................... 436
Service Manuals........................ 438
Setting the Clock..................236,240,248
Settings, Personal........................ 231
Severe Service.......................... 411
Shift Speeds, Manual Transaxle.............. 290
Shoulder Belts......................... 45,80
Side Airbag........................... 63,97
Side Window Demisters (Defrosters).......... 272
Slippery Surfaces, Driving On............... 349
Snow Tires............................ 317
Spare Tire........................ 311,312,343
Spark Plugs............................ 368
Speed Control (Cruise Control)...........187,221
Speedometer........................... 220Speedometer and Odometer................ 217
Starting............................... 278
Automatic Transmission................. 278
Engine Fails to Start.................... 280
Manual Transmission................... 279
Starting Procedures...................... 278
Steering
Power...........................297,373
TiltColumn .......................... 185
Wheel Lock........................... 18
Storage............................203,400
Stuck, Freeing.......................... 350
Sun Roof.............................. 197
Sun Visor Extension...................... 134
Supplemental Restraint System - Airbag...... 54,88
Synthetic Engine Oil...................... 366
Tachometer............................ 221
Temperature Gauge, Engine Coolant.......220,341
INDEX 455
10