garage door opener CHRYSLER PT CRUISER 2008 1.G Owners Manual

▫Lights-On Reminder ...................187
▫ Fog Lights — If Equipped ...............188
▫ Turn Signals .........................188
▫ Highbeam/Lowbeam Select Switch .........189
▫ Passing Light ........................190
 Windshield Wipers And Washers ...........190
▫ Windshield Washers ...................191
▫ Mist Feature .........................191
▫ Windshield Wiper Operation .............192
▫ Intermittent Wiper System ...............192
 Tilt Steering Column ....................193
 Electronic Speed Control — If Equipped ......194
▫ To Activate ..........................194 ▫
To Set At A Desired Speed ...............195
▫ To Deactivate ........................195
▫ To Resume Speed .....................195
▫ To Vary The Speed Setting ...............195
▫ Manual Transaxle .....................196
▫ To Accelerate For Passing ...............196
 Garage Door Opener — If Equipped .........197
▫ Programming HomeLink ...............198
▫ Gate Operator/Canadian Programming .....201
▫ Using HomeLink .....................202
▫ Reprogramming A Single HomeLink
Button .............................202
▫ Security ............................202
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121
3

Vehicles equipped with four speed automatic transaxles
may experience a downshift to third gear while climbing
uphill or descending downhill. This downshift to third
gear is necessary to maintain vehicle set speed.
On steep hills a greater speed loss or gain may occur so
it may be preferable to drive without speed control.GARAGE DOOR OPENER — IF EQUIPPEDHomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting, or home security
systems. The HomeLink unit operates off your vehicle’s
battery.
The HomeLink buttons that are located in the headliner
or sun visor designate the three different HomeLink 
channels. NOTE:
HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
HomeLink Buttons
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 197
3

WARNING!
Your motorized door or gate will open and close
while you are training the Universal Transceiver. Do
not train the transceiver if people or pets are in the
path of the door or gate. Only use this transceiver
with a garage door opener that has a “stop and
reverse” feature as required by Federal safety stan-
dards. This includes most garage door opener models
manufactured after 1982. Do not use a garage door
opener without these safety features. Call toll-free
1–800–355–3515 or, on the Internet at
www.HomeLink.com for safety information or
assistance.
WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.PROGRAMMING HOMELINK
Before You BeginIf you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
198 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLinkbutton you wish to program.
Place the hand-held transmitter 1–3 in (3-8 cm) away
from the HomeLink button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink button and the hand-held transmitter button
until the HomeLink indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
and hand-held transmitter buttons.
Watch for the HomeLink indicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open and close while you train. NOTE:
•
Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
•
After training a HomeLink
channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to the heading “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.UNDERSTANDING THE FEATURES OF YOUR VEHICLE 199
3

If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, continue with program-
ming for a Rolling Code.
5.PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
6. Firmly press and release the “Learn” or “Training”
button. The name and color of the button may vary by
manufacturer.
Training The Garage Door Opener
1 — Door Opener 2 — Training Button
200 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

NOTE:There are 30 seconds in which to initiate the next
step after the “Learn” button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
GATE OPERATOR/CANADIAN PROGRAMMINGCanadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink UNDERSTANDING THE FEATURES OF YOUR VEHICLE 201
3

has successfully accepted the frequency signal. The
indicator light will flash slowly and then rapidly when
fully trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink” earlier in this section.USING HOMELINKTo operate, simply press and release the programmed
HomeLinkbutton. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
Security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.
REPROGRAMMING A SINGLE HOMELINK 
BUTTONTo re-program a channel that has been previously
trained, follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming Homelink Step 2 and follow all remaining steps.SECURITYIt is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
202 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

The HomeLinkUniversal Transceiver is disabled when
the Vehicle Security Alarm is active.TROUBLESHOOTING TIPSIf you are having trouble programming HomeLink, here
are some of the most common solutions:•
Replace the battery in the original transmitter.
•
Press the “Learn” button on the Garage Door Opener
to complete the training for a Rolling Code.
•
Did you unplug the device for training, and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
GENERAL INFORMATIONThis device complies with FCC rules Part 15 and Industry
Canada RSS-210. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference that may be
received including interference that may cause undesired
operation
NOTE: The transmitter has been tested and it complies
with FCC and IC rules. Changes or modifications not
expressly approved by the party responsible for compli-
ance could void the user ’s authority to operate the
device.
The term IC before the certification/registration number
only signifies that Industry Canada technical specifica-
tions were met.UNDERSTANDING THE FEATURES OF YOUR VEHICLE 203
3

Door Opener, Garage..................... 197
Downshifting .......................... 304
Drive Belts ............................ 388
Driver’s Seat Back Tilt .................... 167
Driving On Slippery Surfaces .................... 369
Electric Rear Window Defrost ............... 217
Electric Remote Mirrors ................... 137
Electrical Power Outlets ................... 206
Electronic Speed Control (Cruise Control) ...... 194
Electronic Vehicle Information Center
(EVIC) .......................... 234,235,240
Emergency Deck Lid Release Latch (Convertible) . . 41
Emergency, In Case of Jacking ............................. 360
Jump Starting ......................... 367
Towing ............................. 371
Emergency Seat Back Release (Sedan) .......... 40Emission Control System Maintenance
......381,434
Engine .......................... 1 15,378,379
Break-In Recommendations ............... 115
Checking Oil Level ..................... 384
Coolant (Antifreeze) .................... 398
Cooling ............................. 398
Exhaust Gas Caution .................... 339
Fuel Requirements ..................... 337
Jump Starting ......................... 367
Oil ........................... 384,429,430
Oil Change Interval .................... 385
Oil Filler Cap ................... 378,379,387
Oil Filter ............................ 430
Oil Selection .......................... 386
Oil Synthetic ......................... 387
Operation ............................ 115
Overheating .......................... 358
Temperature Gauge ..................... 226
Timing Belt .......................... 390474 INDEX

Ethanol............................. 337
Filler Cap (Gas Cap) ................. 226,340
Filler Door (Gas Cap) ................... 226
Filter ............................... 391
Gasoline ............................ 337
Gauge .............................. 226
Hoses .............................. 404
Light ............................... 233
Materials Added ....................... 338
Methanol ............................ 337
Octane Rating ........................ 337
Requirements ......................... 337
Tank Capacity ........................ 429
Fuel System Caution ..................... 341
Fueling ............................... 340
Fuses ................................ 419
Garage Door Opener (HomeLink) ........... 197
Gas Cap (Fuel Filler Cap) ............340,342,381Gasoline, Clean Air
...................... 337
Gasoline (Fuel) ....................... 337,429
Gasoline, Reformulated ................... 337
Gauges Coolant Temperature .................... 226
Fuel ................................ 226
Odometer ........................... 229
Tachometer .......................... 227
Gearshift .............................. 297
General Information ................. 18,163,336
General Maintenance ..................... 384
Glass Cleaning .......................... 415
Gross Axle Weight Rating .................. 344
Gross Vehicle Weight Rating ................ 343
Hands-Free Phone (UConnect™) ............. 138
Hazard Warning Flasher ................... 358
Head Restraints ......................... 169476 INDEX