jump start CHRYSLER PT CRUISER 2008 1.G Owners Manual
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2008, Model line: PT CRUISER, Model: CHRYSLER PT CRUISER 2008 1.GPages: 491, PDF Size: 7.08 MB
Page 294 of 491
MANUAL TRANSAXLEBefore starting the engine fully apply the parking brake,
press the clutch pedal to the floor and shift the gear
selector lever in NEUTRAL.
NOTE:The engine will not start unless the clutch pedal
is pressed to the floor.NORMAL STARTINGNormal starting of either a cold or a warm engine does
not require pumping or depressing the accelerator pedal.
Simply turn the ignition switch to the START position
and release when the engine starts. If the engine has not
started within three seconds, slightly depress the accel-
erator pedal while continuing to crank. If the engine fails
to start within 15 seconds, turn the ignition switch to the
OFF position, wait 10 to 15 seconds, then repeat the
“NORMAL STARTING” procedure above.
WARNING!
Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
axle cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle.
If the vehicle has a discharged battery, booster cables
may be used to obtain a start from another vehicle.
This type of start can be dangerous if done improp-
erly, so follow the procedure carefully. See Section 6
of this manual for jump starting instructions.EXTREMELY COLD WEATHER (BELOW 20°F or
29°C)To insure reliable starting at these temperatures, use of an
externally powered electric engine block heater (available
from your authorized dealer) is recommended.
292 STARTING AND OPERATING
Page 359 of 491
WHAT TO DO IN EMERGENCIES
CONTENTSHazard Warning Flasher ..................358
If Your Engine Overheats .................358
Jacking And Tire Changing ................360
▫ Jack Location ........................361
▫ Spare Tire Stowage ....................361
▫ Preparations For Jacking ................362
▫ Jacking Instructions ....................363
Jump-Starting Procedures Due To A Low
Battery ..............................367
Driving On Slippery Surfaces ..............369
▫ Acceleration .........................369
▫ Traction ............................370
Freeing A Stuck Vehicle ..................370
Towing A Disabled Vehicle ................371
▫ With Ignition Key .....................371
▫ Without The Ignition Key ...............372
Convertible Top Manual Override ...........373
6
Page 369 of 491
8. Remove the wheel blocks and lower the jack until it is
free. Stow the lug wrench, and jack in their designated
location. Secure all parts using the means provided.
WARNING!
A loose tire or jack thrown forward in a collision or
hard stop could endanger the occupants of the ve-
hicle. Always stow the jack parts and the spare tire in
the places provided. Have the deflated (flat) tire
repaired or replaced immediately.
9. Place the deflated (flat) tire in the cargo area, have the
tire repaired or replaced as soon as possible.
10. Check the tire pressure as soon as possible. Correct
pressure as required.
JUMP-STARTING PROCEDURES DUE TO A LOW
BATTERY
WARNING!
Take care to avoid the radiator cooling fan whenever
the hood is raised. It can start anytime the ignition
switch is on. You can be hurt by the fan.
WHAT TO DO IN EMERGENCIES 367
6
Page 370 of 491
WARNING!
Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
axle cannot be started this way. Unburned fuel could
enter the catalytic converter and once the engine has
started, ignite and damage the converter and vehicle.
If the vehicle has a discharged battery, booster cables
may be used to obtain a start from another vehicle.
This type of start can be dangerous if done improp-
erly, so follow this procedure carefully.
1. Wear eye protection and remove any metal jewelry
such as watch bands or bracelets that might make an
inadvertent electrical contact. 2. When boosting from a battery in another vehicle, park
that vehicle within booster cable reach but without
letting the vehicles touch. Set parking brake, place auto-
matic transaxle in PARK (manual transaxle in NEU-
TRAL) and turn ignition to OFF for both vehicles.
3. Turn off the heater, radio and all unnecessary electrical
loads.
4. Connect one end of a jumper cable to the positive
terminal of the booster battery. Connect the other end of
the jumper cable to the positive terminal of the dis-
charged battery.368 WHAT TO DO IN EMERGENCIES
Page 371 of 491
WARNING!
Battery fluid is a corrosive acid solution; do not allow
battery fluid to contact eyes, skin or clothing. Don’t
lean over battery when attaching clamps or allow the
clamps to touch each other. If acid splashes in eyes or
on skin, flush the contaminated area immediately
with large quantities of water.
A battery generates hydrogen gas which is flam-
mable and explosive. Keep flame or spark away from
the vent holes. Do not use a booster battery or any
other booster source with an output that exceeds 12
volts.
5. Connect the other cable, first to the negative terminal
of the booster battery and then to the negative terminal of
the discharged battery. Make sure you have a good
contact. 6. If the vehicle is equipped with Sentry Key Immobi-
lizer, turn the ignition switch to the ON position for 3
seconds before moving the ignition switch to the START
position.
7. Start the engine in the vehicle that has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
8. When removing the jumper cables, reverse the se-
quence exactly. Be careful of the moving belts and fan.
DRIVING ON SLIPPERY SURFACES
ACCELERATIONRapid acceleration on snow covered, wet, or other slip-
pery surfaces may cause the front wheels to pull errati-
cally to the right or left. This phenomenon occurs when
there is a difference in the surface traction under the front
(driving) wheels.
WHAT TO DO IN EMERGENCIES 369
6
Page 476 of 491
Door Opener, Garage..................... 197
Downshifting .......................... 304
Drive Belts ............................ 388
Driver’s Seat Back Tilt .................... 167
Driving On Slippery Surfaces .................... 369
Electric Rear Window Defrost ............... 217
Electric Remote Mirrors ................... 137
Electrical Power Outlets ................... 206
Electronic Speed Control (Cruise Control) ...... 194
Electronic Vehicle Information Center
(EVIC) .......................... 234,235,240
Emergency Deck Lid Release Latch (Convertible) . . 41
Emergency, In Case of Jacking ............................. 360
Jump Starting ......................... 367
Towing ............................. 371
Emergency Seat Back Release (Sedan) .......... 40Emission Control System Maintenance
......381,434
Engine .......................... 1 15,378,379
Break-In Recommendations ............... 115
Checking Oil Level ..................... 384
Coolant (Antifreeze) .................... 398
Cooling ............................. 398
Exhaust Gas Caution .................... 339
Fuel Requirements ..................... 337
Jump Starting ......................... 367
Oil ........................... 384,429,430
Oil Change Interval .................... 385
Oil Filler Cap ................... 378,379,387
Oil Filter ............................ 430
Oil Selection .......................... 386
Oil Synthetic ......................... 387
Operation ............................ 115
Overheating .......................... 358
Temperature Gauge ..................... 226
Timing Belt .......................... 390474 INDEX
Page 479 of 491
HeadlightsBulb Replacement ...................... 425
Cleaning ............................ 415
High Beam ........................ 189,234
High Beam/Low Beam Select Switch ........ 189
Passing ............................. 190
Switch .............................. 186
Heated Seats ........................... 169
Hitches Trailer Towing ........................ 345
HomeLink (Garage Door Opener) Transmitter . . . 197
Hood Release .......................... 183
Hoses ............................. 403,404
Ignition ............................... 13
Key ................................. 13
Wiring System (Spark Plug Wires) .......... 388
Ignition Key Removal ..................... 13
Immobilizer (Sentry Key) .................15,37Infant Restraint
....................... 73,107
Information Center, Vehicle ................. 240
Inside Rearview Mirror ................... 135
Instrument Cluster .................... 223,226
Instrument Panel and Controls .............. 222
Instrument Panel Cover ................413,415
Instrument Panel Lens Cleaning ............. 416
Integrated Power Module (Fuses) ............ 419
Interior Appearance Care .................. 413
Intermittent Wipers (Delay Wipers) ........... 192
Introduction ............................. 4
Jack Location ........................... 361
Jack Operation ....................... 360,363
Jacking Instructions ...................... 363
Jump Starting .......................... 367
Key, Programming ........................ 17
Key, Replacement ........................ 16
INDEX 477
10