oil viscosity CHRYSLER PT CRUISER 2008 1.G Owners Manual

ENGINE BREAK-IN RECOMMENDATIONSA long break-in period is not required for the engine in
your vehicle.
Drive moderately during the first 300 mi (500 km). After
the initial 60 mi (100 km), speeds up to 50 or 55 mph (80
or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration, within the
limits of local traffic laws, contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detri-
mental and should be avoided.
The engine oil installed in the engine at the factory is a
high-quality energy-conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur. For
the recommended viscosity and quality grades, refer to
“Maintenance Procedures” in Section 7 of this manual.
NON-DETERGENT OR STRAIGHT MINERAL OILS
MUST NEVER BE USED.A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should be
considered as a normal part of the break-in and not
interpreted as an indication of difficulty.
SAFETY TIPS
Exhaust Gas
WARNING!
Exhaust gases can injure or kill. They contain carbon
monoxide (CO) which is colorless and odorless.
Breathing it can make you unconscious and can
eventually poison you. To avoid breathing (CO)
follow the safety tips below.
Do not run the engine in a closed garage or in confined
areas any longer than needed to move your vehicle in or
out of the area.THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 115
2

Engine Oil Viscosity (SAE Grade) — 2.4L and 2.4L
Turbo EnginesSAE 5W-30 engine oil is recommended for all operating
temperatures. This engine oil improves low temperature
starting and vehicle fuel economy.
The engine oil filler cap also shows the recommended
engine oil viscosity for your engine. For information on
engine oil filler cap location, refer to the “Engine Com-
partment” illustration in this section.
Lubricants which do not have both, the engine oil certi-
fication mark and the correct SAE viscosity grade num-
ber should not be used.Synthetic Engine OilsYou may use synthetic engine oils provided the recom-
mended oil quality requirements are met, and the recom-
mended maintenance intervals for oil and filter changes
are followed.
Materials Added To Engine OilsThe manufacture strongly recommends against the addi-
tion of any additives (other than leak detection dyes) to
the engine oil. Engine oil is an engineered product and
it’s performance may be impaired by supplemental ad-
ditives.Disposing of Used Engine OilCare should be taken in disposing of used engine oil from
your vehicle. Used oil, indiscriminately discarded, can
present a problem to the environment. Contact your
dealer, service station, or governmental agency for advice
on how and where used oil can be safely discarded in
your area.Engine Oil FilterThe engine oil filter should be replaced at every engine
oil change.
MAINTAINING YOUR VEHICLE 387
7

Mini-Trip Computer...................... 235
Mirrors ............................... 135
Electric Remote ....................... 137
Outside ............................. 136
Rearview ............................ 135
Vanity .............................. 138
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 332
Mopar Parts ......................... 383,464
MTBE/ETBE ........................... 337
Multi-Function Control Lever ............... 186
New Vehicle Break-In Period ................ 115
Occupant Classification System (OCS) .......... 60
Occupant Restraints (Convertible) ............. 81
Occupant Restraints (Sedan) ................. 44
Octane Rating, Gasoline (Fuel) .............. 337
Odometer ............................. 229
Trip ............................. 229,230Oil, Engine
......................... 384,429
Capacity ............................ 429
Change Interval ....................... 385
Checking ............................ 384
Disposal ............................ 387
Filter ............................... 387
Identification Logo ..................... 386
Materials Added to ..................... 387
Quality ............................. 386
Recommendation ................... 386,429
Synthetic ............................ 387
Viscosity ............................ 387
Oil Filter, Selection ....................... 388
Oil Pressure Light ....................... 234
Onboard Diagnostic System ..............380,381
Opener, Garage Door (HomeLink ) ........... 197
Operator Manual (Owner’s Manual) ............ 4
Outside Air Intake ....................... 284
Overdrive ............................. 298480 INDEX