wipers CHRYSLER PT CRUISER 2008 1.G Owners Manual

▫Lights-On Reminder ...................187
▫ Fog Lights — If Equipped ...............188
▫ Turn Signals .........................188
▫ Highbeam/Lowbeam Select Switch .........189
▫ Passing Light ........................190
 Windshield Wipers And Washers ...........190
▫ Windshield Washers ...................191
▫ Mist Feature .........................191
▫ Windshield Wiper Operation .............192
▫ Intermittent Wiper System ...............192
 Tilt Steering Column ....................193
 Electronic Speed Control — If Equipped ......194
▫ To Activate ..........................194 ▫
To Set At A Desired Speed ...............195
▫ To Deactivate ........................195
▫ To Resume Speed .....................195
▫ To Vary The Speed Setting ...............195
▫ Manual Transaxle .....................196
▫ To Accelerate For Passing ...............196
 Garage Door Opener — If Equipped .........197
▫ Programming HomeLink ...............198
▫ Gate Operator/Canadian Programming .....201
▫ Using HomeLink .....................202
▫ Reprogramming A Single HomeLink
Button .............................202
▫ Security ............................202
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121
3

Passing LightYou can signal another vehicle with your headlights by
lightly pulling the Multi-Function Control Lever toward
you. This will cause the headlights to turn on at high
beam and remain on until the lever is released.
NOTE:If the Multi-Function Control Lever is held in
the flash to pass position for more than 15 seconds, the
high beams will shut off. If this occurs, wait 30 seconds
for the next flash to pass operation.WINDSHIELD WIPERS AND WASHERS
The wipers and washers are operated by a switch
on the control lever. The lever is located on the
right side of the steering column. Rotate the
control to select the desired wiper speed.
Wiper/Washer Switch
190 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Windshield WashersTo use the washer, pull the control lever toward you and
hold while spray is desired. If the lever is pulled while in
the delay range, the wiper will operate in low speed for
two wipe cycles after the lever is released, and then
resume the intermittent interval previously selected.
If the lever is pulled while in the OFF position, the wipers
will operate for two wipe cycles, then turn OFF.
Mist FeaturePush down on the wiper control lever to activate a single
wipe to clear the windshield of road mist or spray from
a passing vehicle. As long as the lever is held down, the
wipers will continue to operate.
Mist Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 191
3

CAUTION!
In cold weather, always turn off the wiper switch and
allow the wipers to return to the park position before
turning off the engine. If the wiper switch is left on
and the wipers freeze to the windshield, damage to
the wiper motor may occur when the vehicle is
restarted.Windshield Wiper OperationRotate the control to the second detent for Low speed
wiper operation, or to the third detent for High speed
operation
Intermittent Wiper SystemThe intermittent feature of this system was designed for
use when weather conditions make a single wiping cycle,
with a variable pause between cycles, desirable. For
maximum delay between cycles, rotate the control knob
into the upper end of the delay range.
The delay interval decreases as you rotate the knob until
it enters the LO continual speed position.
WARNING!
Sudden loss of visibility through the windshield
could lead to an accident. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with defroster before and during wind-
shield washer use.
192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

NOTE:If the front wiper is operating when the ignition
is turned off, the wiper will automatically return to the
Park position. When the vehicle is restarted, the wipers
will resume operation.TILT STEERING COLUMNTo tilt the column, push down on the lever below the
multifunction control lever and move the steering wheel
up or down, as desired. Pull the lever back up to lock the
column firmly in place.
Tilt Steering Column Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 193
3

wash pump will continue to operate as long as the button
is pressed. Upon release, the wipers will cycle two times
before returning to the set position.If the rear wiper is operating when the ignition is turned
OFF, the wiper will automatically return to the “Park”
position if power accessory delay is active. Power acces-
sory delay can be cancelled by opening the door, if this
happens the rear wiper will stop at its current position
and will not go to park.
Adding Washer FluidThe fluid reservoir for the windshield washers and the
rear window washer (if equipped) is shared. It is located
in the rear of the engine compartment on the passenger
side and should be checked for fluid level at regular
intervals. Fill the reservoir with windshield washer sol-
vent (not radiator antifreeze) and operate the system for
a few seconds to flush out the residual water.
06 Rear Wiper Switch
218 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

when exiting the vehicle. Press and hold the EVIC button
when in this display until 0, 30, 60, or 90 appears to make
your selection.Headlamps On With Wipers (Available with Auto
Headlights Only)When ON is selected and the headlight switch is in the
AUTO position, the headlights will turn on approxi-
mately 10 seconds after the wipers are turned on. The
headlights will also turn off when the wipers are turned
off if they were turned on by this feature. Press and hold
the EVIC button when in this display until ON or OFF
appears to make your selection.
NOTE:Turning the headlights on during the daytime
causes the instrument panel lights to dim. To increase the
brightness, refer to “Lights” in this section.Delay Power Off to Accessories Until ExitWhen this feature is selected, the power window
switches, radio, hands–free system, DVD video system, power sunroof, and power outlets will remain active for
up to 60 minutes after the ignition switch has been turned
off. Opening a vehicle door will cancel this feature. Press
and hold the EVIC button when in this display until
“Off”, “45 sec.”, “5 min.”, or “10 min.” appears to make
your selection.
Turn Headlamps on with Remote Key UnlockWhen this feature is selected the headlamps will activate
and remain on for up to 90 seconds when the doors are
unlocked using the remote keyless entry transmitter.
Press and hold the EVIC button when in this display until
“OFF”, “30 sec.”, “60 sec.”, or “90 sec.” appears to make
your selection.Confirmation of Voice Commands — If EquippedWhen ON is selected all voice commands from the
U-Connect™ system are confirmed. Press and hold the
EVIC button when in this display until ON or OFF
appears to make your selection.
246 UNDERSTANDING YOUR INSTRUMENT PANEL

All Transaxles
CAUTION!
If the vehicle being towed requires steering, the
ignition switch must be in the ACC position, not in
the LOCK positions.
Do not attempt to use sling type equipment when
towing. When securing vehicle to flat bed truck, do
not attach to front or rear suspension components.
Damage to your vehicle may result from improper
towing.
If it is necessary to use the accessories while being towed
(wipers, defrosters, etc.), the key must be in the ON
position, not the ACC position. Make certain the trans-
axle remains in NEUTRAL.
Without The Ignition KeySpecial care must be taken when the vehicle is towed
with the ignition in the LOCK position. A dolly should be
used under the front wheels if the rear wheels are raised.
Proper towing equipment is necessary to prevent dam-
age to the vehicle.Towing This Vehicle Behind Another Vehicle (Flat
Towing With All Four Wheels On The Ground)If your vehicle is equipped with a manual transaxle, it
may be towed in a forward direction, at any legal
highway speed, for any distance, if the transaxle is in
NEUTRAL.
If the ignition key is not available, vehicles with auto-
matic transaxles can not be flat towed at any time.
372 WHAT TO DO IN EMERGENCIES

amount of a high quality lubricant such as MoparLock
Cylinder Lubricant directly into the lock cylinder.WINDSHIELD WIPER BLADESClean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild non abrasive cleaner or use the washer solvent. This
will remove accumulations of salt, waxes or road film
and help reduce streaking and smearing.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield. Avoid using the wiper blades to
remove frost or ice from the windshield. make sure that
they are not frozen to the glass before turning them on to
avoid damaging the blade. Keep the blade rubber out of
contact with petroleum products such as engine oil,
gasoline, etc.
Windshield Wiper Blade Replacement1. Lift the wiper arm away from the glass.
2. Push the release tab shown in the illustration and slide
the wiper blade assembly down along the arm. Gently
place the wiper arm on the windshield.
3. Install the new blade assembly onto the wiper arm tip
until it locks in place.
NOTE: Always refer to the wiper blade packaging for
specific installation instructions. Many wiper blade re-
placements fit multiple vehicles.WINDSHIELD WASHER RESERVOIRNOTE: Always refer to the wiper blade packaging for
specific installation instructions. Many wiper blade re-
placements fit multiple vehicles.
The washer fluid reservoir is located in the rear of the
engine compartment on the passenger side and should be
396 MAINTAINING YOUR VEHICLE

Convertible Top Maintenance............... 416
Convertible Top Manual Override .........134,373
Cool Down, Turbo ....................... 293
Coolant (Antifreeze) ................... 429,430
Coolant Pressure Cap (Radiator Cap) .......... 400
Cooling System ......................... 398
Adding Coolant (Antifreeze) .............. 400
Coolant Level ...................... 398,401
Disposal of Used Coolant ................ 401
Drain, Flush, and Refill .................. 399
Inspection ........................... 401
Points to Remember .................... 402
Pressure Cap ......................... 400
Radiator Cap ......................... 400
Selection of Coolant (Antifreeze) ........... 399
Corrosion Protection ...................... 411
Crankcase Emission Control System .......... 390
Cruise Light ........................... 229
Cup Holder ............................ 208 Customer Assistance
..................... 461
Data Recorder, Event ................... 70,105
Dealer Service .......................... 383
Deck Lid (Convertible) ..................... 39
Deck Lid, Emergency Release Latch (Convertible) . . 41
Deck Lid, Power Release (Convertible) ......... 39
Defroster, Rear Window ................... 217
Defroster, Windshield .................. 1 16,279
Delay (Intermittent) Wipers ................. 192
Diagnostic System, Onboard ................ 380
Dimmer Switch, Headlight ................. 189
Dipsticks Automatic Transaxle .................... 408
Disposal Antifreeze (Engine Coolant) ............... 401
Engine Oil ........................... 387
Door Locks ............................. 19
Door Locks, Automatic .................... 21
INDEX 473
10