garage door opener CHRYSLER PT CRUISER 2010 1.G Owners Manual
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2010, Model line: PT CRUISER, Model: CHRYSLER PT CRUISER 2010 1.GPages: 368, PDF Size: 5.61 MB
Page 82 of 368
▫Using Electronic Speed Control On Hills .... 114
Garage Door Opener — If Equipped ........ 115
▫ Programming HomeLink .............. 116
▫ Gate Operator/Canadian Programming .... 119
▫ Security ........................... 120
▫ Troubleshooting Tips .................. 120
▫ General Information .................. 120
Power Sunroof — If Equipped ............ 121
▫ Express-Open Feature ................. 122
▫ Wind Buffeting ...................... 123
▫ Sunroof Maintenance ................. 123
Electrical Power Outlets ................. 123
Storage ............................. 126 ▫
Center Console/Armrest Storage Bin ...... 126
▫ Storage Pockets ..................... 128
Console Features ...................... 128
Rear Shelf Panel — If Equipped ........... 129
▫ Position 1 (Top) ..................... 130
▫ Position 2 (Middle) ................... 130
▫ Position 3 (Floor) .................... 131
▫ Position 4 (Vertical) ................... 132
▫ Position 5 (Table) .................... 132
Rear Window Features .................. 134
▫ Rear Window Wiper/Washer ............ 134
▫ Rear Window Defroster ................ 135
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 81
Page 116 of 368
WARNING!
Electronic Speed Control can be dangerous where the
system cannot maintain a constant speed. Your ve-
hicle could go too fast for the conditions, and you
could lose control. An accident could be the result.
Do not use Electronic Speed Control in heavy traffic
or on roads that are winding, icy, snow-covered or
slippery.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting or home security
systems. The HomeLink unit operates off your vehicle’s
battery.
The HomeLink buttons that are located in the headliner
or sun visor designate the three different HomeLink
channels. NOTE:
HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.HomeLink Buttons
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115
Page 117 of 368
WARNING!
•Your motorized door or gate will open and close
while you are training the universal transceiver.
Do not train the transceiver if people, pets or other
objects are in the path of the door or gate. Only use
this transceiver with a garage door opener that has
a “stop and reverse” feature as required by Federal
safety standards. This includes most garage door
opener models manufactured after 1982. Do not
use a garage door opener without these safety
features. Call toll-free 1–800–355–3515 or, on the
Internet at www.HomeLink.com for safety infor-
mation or assistance.
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You Begin
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for up
to 20 seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
handheld transmitter of the device that is being copied to
HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
Begin Programming
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the handheld transmitter
away from the HomeLink button you wish to program.
116 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 118 of 368
Place the handheld transmitter 1 to 3 in (3 to 8 cm) away
from the HomeLinkbutton you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink button and the handheld transmitter button
until the HomeLink indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
and handheld transmitter buttons.
Watch for the HomeLink indicator to change flash rates.
When it changes, it is programmed. It may take up to
30 seconds or longer in rare cases. The garage door may
open and close while you train.
NOTE:
•Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
•After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to Step 5 “Pro-
gramming A Rolling Code System.”
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 117
Page 119 of 368
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.6. Firmly press and release the LEARN or TRAINING
button. The name and color of the button may vary by
manufacturer.
NOTE:
You have 30 seconds in which to initiate the next
step after the LEARN button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 120 of 368
Using HomeLink
To operate, press and release the programmed
HomeLinkbutton. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.
Reprogramming a Single HomeLink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.
Gate Operator/Canadian Programming
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3, with the following:
3. Continue to press and hold the HomeLink button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink has
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119
Page 121 of 368
successfully accepted the frequency signal. The indica-
tor light will flash slowly and then rapidly when fully
trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink,” earlier in this section.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLinkUniversal Transceiver is disabled when
the Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the LEARN button on the Garage Door Opener
to complete the training for a Rolling Code.
•Did you unplug the device for training, and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
General Information
This device complies with FCC rules Part 15 and Industry
Canada RSS-210. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 354 of 368
Customer Assistance..................... 341
Daytime Running Lights ................... 104
Dealer Service .......................... 280
Defroster, Rear Window ................... 135
Defroster, Windshield ................... 75,182
Delay (Intermittent) Wipers ................. 108
Diagnostic System, Onboard ................ 278
Dimmer Switch, Headlight ................. 103
Dipsticks Automatic Transaxle .................... 300
Power Steering ........................ 206
Disposal Antifreeze (Engine Coolant) ............... 296
Engine Oil ........................... 284
Door Locks ............................. 26
Door Locks, Automatic .................... 28
Door Opener, Garage ..................... 115 Driving
On Slippery Surfaces ................... 202
Through Flowing, Rising, or Shallow
Standing Water ........................ 203
Electric Remote Mirrors .................... 83
Electrical Power Outlets ................... 123
Electronic Speed Control (Cruise Control) ....... 112
Electronic Vehicle Information Center
(EVIC) ............................. 154,159
Emergency, In Case of Jacking ............................. 262
Jump Starting ......................... 268
Towing ............................. 273
Emergency Seat Back Release (Sedan) .......... 98
Emission Control System Maintenance ......278,320
Engine ............................... 277
Break-In Recommendations ................ 72
Checking Oil Level ..................... 281
10
INDEX 353
Page 356 of 368
Fog Lights.......................... 103,152
Folding Front Passenger Seat ................ 88
Folding Rear Seat ........................ 91
Folding Rear Seat (Sedan) .................. 91
Freeing A Stuck Vehicle ................... 272
Fuel .............................. 237,317
Adding ............................. 241
Additives ............................ 239
Capacity ............................ 316
Clean Air ............................ 237
Ethanol ............................. 238
Filler Cap (Gas Cap) ................. 143,242
Filler Door (Gas Cap) ................... 143
Gasoline ............................ 237
Gauge .............................. 143
Light ............................... 152
Materials Added ....................... 239
Methanol ............................ 238
Octane Rating ........................ 237 Requirements
......................... 237
Tank Capacity ........................ 316
Fuel System Caution ..................... 242
Fueling ............................... 241
Fuses ................................ 308
Garage Door Opener (HomeLink) ........... 115
Gas Cap (Fuel Filler Cap) ............242,243,278
Gasoline, Clean Air ...................... 237
Gasoline (Fuel) ....................... 237,316
Gasoline, Reformulated ................... 237
Gauges Coolant Temperature ................... 143
Fuel ............................... 143
Odometer ........................... 146
Tachometer .......................... 144
General Information .................. 18,25,237
General Maintenance ..................... 281
Glass Cleaning .......................... 306
10
INDEX 355
Page 357 of 368
Gross Axle Weight Rating.................. 246
Gross Vehicle Weight Rating .............244,246
Hazard Driving Through Flowing, Rising, or Shallow
Standing Water ........................ 203
Hazard Warning Flasher ................... 260
Head Restraints .......................... 89
Headlights Bulb Replacement ...................... 312
Cleaning ............................ 306
Dimmer Switch ....................... 103
On With Wipers ....................... 110
Switch .............................. 101
Heated Seats ............................ 90
Hitches Trailer Towing ........................ 248
HomeLink (Garage Door Opener) Transmitter . . . 115
Hood Release ........................... 99 Ignition
............................... 12
Key ................................ 12
Ignition Key Removal ..................... 12
Immobilizer (Sentry Key) .................15,19
Infant Restraint .......................... 64
Information Center, Vehicle ................. 159
Inside Rearview Mirror .................... 82
Instrument Cluster .................... 141,143
Instrument Panel and Controls .............. 140
Instrument Panel Cover ................304,307
Instrument Panel Lens Cleaning ............. 307
Integrated Power Module (Fuses) ............ 308
Interior Appearance Care .................. 305
Intermittent Wipers (Delay Wipers) ........... 108
Introduction ............................. 4
Jack Location ........................... 262
Jack Operation ....................... 262,265
Jacking Instructions ...................... 265
356 INDEX