turn signal CHRYSLER SEBRING 2010 3.G Owner's Manual

•An electronically actuated trailer brake controller is
required when towing a trailer with electronically
actuated brakes. When towing a trailer equipped with
a hydraulic surge actuated brake system, an electronic
brake controller is not required.
•Trailer brakes are recommended for trailers over
1,000 lbs (450 kg) and required for trailers in excess of
2,000 lbs (907 kg).
CAUTION!
If the trailer weighs more than 1,000 lbs (450 kg)
loaded, it should have its own brakes with adequate
braking capacity. Failure to do this could lead to
accelerated brake lining wear, higher brake pedal
effort, and longer stopping distances.
WARNING!
•Do not connect trailer brakes to your vehicle’s
hydraulic brake lines. It can overload your brake
system and cause it to fail. You might not have
brakes when you need them and could have an
accident.
•Towing any trailer will increase your stopping
distance. When towing, you should allow for ad-
ditional space between your vehicle and the ve-
hicle in front of you. Failure to do so could result
in an accident.
Towing Requirements – Trailer Lights and Wiring
Whenever you pull a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required for
motoring safety.
316 STARTING AND OPERATING

HAZARD WARNING FLASHER
The Hazard Warning flasher switch is located on the
instrument panel, below the radio.Press the switch to turn on the Hazard Warning
flasher. When the switch is activated, all directional
turn signals will flash on and off to warn oncoming
traffic of an emergency. Press the switch a second time to
turn off the Hazard Warning flasher.
This is an emergency warning system and should not be
used when the vehicle is in motion. Use it when your
vehicle is disabled and is creating a safety hazard for
other motorists.
If it is necessary to leave the vehicle to go for service, the
Hazard Warning flasher will continue to operate with the
ignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flasher
may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways — Slow down.
•In city traffic — While stopped, put transaxle in
NEUTRAL, but do not increase engine idle speed.
CAUTION!
Driving with a hot cooling system could damage
your vehicle. If temperature gauge reads “H”, pull
over and stop the vehicle with the engine at idle,
when safe. Turn the air conditioner off and wait until
the pointer drops back into the normal range. After
appropriate action has been taken, if the pointer
remains on the “H”, turn the engine off immediately,
and call for service.6
WHAT TO DO IN EMERGENCIES 321

▫Adding Washer Fluid ................. 358
▫ Exhaust System ..................... 358
▫ Cooling System ..................... 361
▫ Brake System ....................... 366
▫ Automatic Transmission ............... 368
▫ Appearance Care And Protection From
Corrosion .......................... 371
▫ Cleaning Center Console Cupholders ...... 376
 Fuses .............................. 377
▫ Totally Integrated Power Module (TIPM) . . . 377
 Vehicle Storage ....................... 382
 Replacement Bulbs .................... 382 
Bulb Replacement ..................... 383
▫ Headlamp ......................... 383
▫ Front Turn Signal/Parking Lamp ......... 385
▫ Front Fog Lamp ..................... 385
▫ Tail/Stop, Rear Turn Signal And Backup
Lamps ............................ 387
▫ License Plate Lamp ................... 390
▫ Center High-Mounted Stop Lamp
(CHMSL) .......................... 391
 Fluid Capacities ...................... 392
 Fluids, Lubricants, And Genuine Parts ....... 393
▫ Engine ............................ 393
▫ Chassis ........................... 394
340 MAINTAINING YOUR VEHICLE

LIGHT BULBS – ExteriorBulb No.
Low Beam Headlamp ..................... H11
High Beam Headlamp .................... 9005
Front Park/Turn Signal/Side Marker Lamp ....3757A
Front Fog Lamp ...................... PSX24W
Center High Mounted Stop
(CHMSL) Lamp ................... W16W (921)
Rear Tail/Stop Lamp ..................... 3157
Rear Turn Signal Lamp .................... 3157
Backup Lamp .......................... 3157
License Lamp .......................... W5W
Front Position Lamp ..................... W5W
BULB REPLACEMENT
Headlamp
1. Raise and prop open the hood. Locate the connector
behind the headlamp. NOTE:
It may be necessary to remove the air cleaner
filter housing and position the totally integrated power
module aside prior to replacing the low beam headlamp
on the driver’s side of the vehicle.
2. Reach into engine compartment and from behind the
lamp assembly and grasp the connector.
7
MAINTAINING YOUR VEHICLE 383

Front Turn Signal/Parking Lamp
1. Raise and prop open the hood.
2. Rotate the bulb’s electrical connector one-quarter turn
counterclockwise and remove it from the headlamp
housing.3. Remove the bulb from the connector socket and install
the replacement bulb.
4. Install the bulb and connector assembly into the
headlamp housing and rotate the connector one-quarter
turn clockwise to lock it in place.
Front Fog Lamp
NOTE:
Access to the lamps through the lower fascia
cutout is limited. We recommend you access the lamps by
turning the steering wheel to allow access and remove
the inner fender shield.
7
MAINTAINING YOUR VEHICLE 385

Tail/Stop, Rear Turn Signal and Backup Lamps
The taillamps are a two piece design. The turn signal,
brake and taillamps are located in the rear corner body
panel housing. The backup and taillamps are located in
the trunk lid housing.
Changing the Tail/Stop Lamp or Rear Turn Signal
Lamp
1. Open the trunk and gently pull back the trunk liner
behind the taillamp
7
MAINTAINING YOUR VEHICLE 387

2. Remove the two plastic wing nuts from the taillamp
housing.
3. Grasp the taillamp housing and pull it firmly outward
while pushing gently on the studs from inside to disen-
gage the housing from the vehicle.4. Rotate the applicable bulb’s electrical connector one-
quarter turn counterclockwise and remove it from the
taillamp housing.
5. Remove the bulb from the connector socket and install
the replacement bulb.
1 — Tail/Stop Lamp
2 — Turn Signal Lamp
388 MAINTAINING YOUR VEHICLE

Oil Selection....................... 349,392
Oil Synthetic ......................... 351
Overheating .......................... 321
Starting ............................. 238
Temperature Gauge .................... 145
Engine Oil Viscosity ...................... 350
Enhanced Accident Response Feature .......... 64
Entry System, Illuminated .................. 20
Ethanol ............................... 295
Exhaust Gas Caution ................... 81,298
Exhaust System ....................... 81,358
Extender, Seat Belt ........................ 52
Exterior Lights .......................... 84
Fabric Care ............................ 374
Filler Location Fuel .................... 145,303
Filters Air Cleaner .......................... 352
Air Conditioning .................... 230,355Automatic Transaxle
.................... 370
Engine Oil ........................ 351,393
Engine Oil Disposal .................... 351
Flashers .............................. 321
Hazard Warning ....................... 321
Turn Signal ........................... 84
Flash-To-Pass ........................... 108
Flexible Fuel Vehicles ..................... 299
Cruising Range ....................... 302
Engine Oil ........................... 302
Fuel Requirements .................. 299,301
Maintenance ....................... 299,303
Replacement Parts ..................... 303
Starting ............................. 302
Flooded Engine Starting ................... 239
Floor Console .......................... 135
Fluid Capacities ......................... 392
Fluid Leaks ............................. 84
10
INDEX 429

Ignition............................... 12
Key ................................ 12
Lock ................................ 12
Ignition Key Removal ..................... 12
Illuminated Entry ........................ 20
Immobilizer (Sentry Key) ................... 15
Infant Restraint ...................... 69,70,71
Information Center, Vehicle ................. 158
Inside Rearview Mirror .................... 89
Instrument Cluster .................... 144,145
Instrument Panel and Controls .............. 143
Instrument Panel Cover ................... 374
Instrument Panel Lens Cleaning ............. 376
Integrated Power Module (Fuses) ............ 377
Interior Appearance Care .................. 374
Interior Lights .......................... 111
Intermittent Wipers (Delay Wipers) ........... 113
Introduction ............................. 4 Jack Location
........................... 323
Jack Operation ....................... 323,324
Jacking Instructions ...................... 324
Jump Starting .......................... 329
Key, Programming ........................ 16
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 15
Key-In Reminder ......................... 14
Keyless Entry System ...................... 20
Keyless Entry System (Sedan) ................ 20
Keys ................................. 12
Knee Bolster ............................ 53
Lane Change and Turn Signals .............. 153
Lane Change Assist ...................... 108
Lap/Shoulder Belts ....................... 40
432 INDEX

Traction Control....................... 263
Turn Signal ................ 84,108,153,385,387
Voltage ............................. 146
Warning (Instrument Cluster Description) ..... 145
Loading Vehicle ...................... 305,307
Capacities ........................... 307
Tires ............................... 272
Locks Auto Unlock .......................... 31
Child Protection ........................ 32
Power Door ........................... 30
Low Tire Pressure System .................. 285
Lower Anchors and Tether for CHildren
(LATCH) .............................. 75
Lubrication, Body ....................... 356
Lumbar Support ......................... 96
Maintenance Free Battery .................. 352
Maintenance, General ..................... 347 Maintenance Procedures
................... 347
Maintenance Schedule .................... 396
Malfunction Indicator Light (Check Engine) . . 156,345
Manual, Service ......................... 419
Map/Reading Lights ..................... 111
Master Cylinder (Brakes) .................. 366
Methanol ............................. 295
Mini-Trip Computer ...................... 162
Mirrors ................................ 89
Automatic Dimming ..................... 90
Electric Powered ....................... 90
Outside .............................. 91
Rearview ............................. 89
Vanity ............................... 92
Modifications/Alterations, Vehicle ............. 7
Monitor, Tire Pressure System ............... 285
Mopar Parts ......................... 346,418
MTBE/ETBE ........................... 295
434 INDEX