coolant level CHRYSLER SEBRING CONVERTIBLE 2005 2.G Owners Manual

Fan Control
Use this control to regulate the amount of air forced
through the system in any mode you select. Turn the
control clockwise to increase fan speed.
In ambient temperatures below 21°C (70°F), fan opera-
tion is delayed when the engine is first started. The fan
will automatically start when the engine coolant is warm
enough to heat the air. This feature can be defeated by
turning the fan control.
AUTO Control
Press the top of the button to turn the ATC system On.
Press the lower portion of the button to turn the entire
system Off.
Comfort Control
Use this control to regulate the comfort inside the pas-
senger compartment. Press the top of the switch to raise
the temperature selection and the bottom of the switch to
lower it. The comfort setting range is from Low, 60,
61,....to 89,90, Hi, for automatic temperature control. You
can select a very hot or cold comfort setting by holding
the comfort control until it reaches its highest or lowest
levels.The system adjusts to bring the interior temperature to
the desired comfort level. All comfort settings are auto-
matic; even Hi and Low.
NOTE:You can change the display from U.S. to metric
units by pressing the Mix and Panel mode buttons
simultaneously or by pressing the English/Metric button
on the overhead console.
Air Conditioning Button
Press this button to turn on the air conditioning
compressor. A snow flake symbol in the display
shows that the compressor is on. Compressor
operation is automatic when you press the Auto button.
The compressor can operate at any temperature above
32°F(0°C).
With the compressor off and the temperature set at Lo, air
entering the vehicle will be slightly warmer than the air
outside the vehicle.
NOTE:The compressor will not engage until the engine
has been running for several seconds. Slight changes in
UNDERSTANDING YOUR INSTRUMENT PANEL 129
4

Adding Coolant
When adding coolant, or refilling the system, a minimum
solution of 50% recommended HOAT ethylene glycol
engine coolant (antifreeze) and distilled water should be
used. Use higher concentrations (not to exceed 70%) if
temperatures below
34°F(
37°C) are anticipated.
Please note that it is the owner’s responsibility to main-
tain the proper level of protection against freezing ac-
cording to the temperatures occurring in the area where
the vehicle is operated.
Coolant Pressure Cap
The cap must be fully tightened to prevent loss of
coolant, and to insure that coolant will return to the
radiator from the coolant reserve tank.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.
WARNING!
The warning words“DO NOT OPEN HOT”on the
cooling system pressure cap are a safety precaution.
Never add coolant when the engine is overheated.
Do not loosen or remove the cap to cool an over-
heated engine. Heat causes pressure to build up in
the cooling system. To prevent scalding or injury, do
not remove the pressure cap while the system is hot
or under pressure.
CAUTION!
Be sure to use only the cooling system pressure cap
specified for your vehicle. Use of any other pressure
cap may result in decreased engine cooling system
performance and/or damage to your vehicle.
222 MAINTAINING YOUR VEHICLE

Disposal Of Used Engine Coolant
Used ethylene glycol based engine coolant is a regulated
substance requiring proper disposal. Check with your
local authorities to determine the disposal rules for your
community. Do not store ethylene glycol based engine
coolant in open containers or allow it to remain in
puddles on the ground. Prevent ingestion by animals or
children. If ingested by a child, contact a physician
immediately.
Coolant Level
The coolant bottle provides a quick visual method for
determining that the coolant level is adequate. With the
engine off and cold, the coolant level should be between
the“MIN”and“MAX”marks on the side of the coolant
bottle. Some darkening of the coolant bottle will occur
over time. This is normal. If the coolant level is hard to
see, jostling the coolant bottle will make it easier to see.
There is no need to remove the radiator cap unless
checking for coolant freeze point, adding, or replacing
coolant. Advise your service attendant of this. As long as
the engine operating temperature is satisfactory, thecoolant bottle need only be checked once a month. Heater
performance may also be adversely affected by low
coolant levels.
When additional coolant is needed to maintain the
proper level, it should be added to the coolant bottle. Do
not overfill. Special procedures are required when filling
the engine cooling system of the 2.7L Engine. See your
authorized dealer for details.
Points to Remember
NOTE:
When the vehicle is stopped after a few miles of
operation, you may observe vapor coming from the front
of the engine compartment. This is normally a result of
moisture from rain, snow, or high humidity accumulat-
ing on the radiator and being vaporized when the
thermostat opens, allowing hot water to enter the radia-
tor.
If an examination of your engine compartment shows no
evidence of radiator or hose leaks, the vehicle may be
safely driven. The vapor will soon dissipate.
•Do not overfill the coolant bottle.
MAINTAINING YOUR VEHICLE 223
7

•Check coolant freeze point in the system.
•If frequent coolant additions are required, or if the
level in the bottle does not drop when the engine cools,
the cooling system should be pressure tested for leaks.
•Maintain coolant concentration at 50% HOAT ethylene
glycol engine coolant (minimum) and distilled water
for proper corrosion protection of your engine which
contains aluminum components.
•Make sure that the radiator and coolant bottle hoses
are not kinked or obstructed.
•Keep the front of the radiator clean. If your vehicle has
air conditioning, keep the front of the condenser clean,
also.
•Do not change the thermostat for summer or winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory cooling performance, poor gas
mileage, and increased emissions.
Hoses and Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, checking, tears, cuts, abrasions,
and excessive swelling indicate deterioration of the rub-
ber.
Pay particular attention to those hoses nearest to high
heat sources such as the exhaust manifold. Inspect hose
routing to be sure hoses do not touch any heat source or
moving component that may cause heat damage or
mechanical wear.
Insure nylon tubing in these areas has not melted or
collapsed. Inspect all hose connections such as clamps
and couplings to make sure they are secure and no leaks
are present. Components should be replaced immedi-
ately if there is any evidence of degradation that could
cause failure.
Brakes
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in section 8.
224 MAINTAINING YOUR VEHICLE

•If equipped for and operating with E-85 (ethanol)
fuel.
NOTE:IfANYof these apply to you then change your
engine oil every 3,000 miles (5,000 km) or 3 months,
whichever comes first and follow schedule B of the
“Maintenance Schedules”section of this manual.
NOTE:IfANYof these apply to you then flush and
replace the engine coolant every 100,000 miles (160,000
km) or 60 months, whichever comes first, and follow
schedule B of theMaintenance Schedulessection of this
manual.
NOTE:Most vehicles are operated under the conditions
listed for ScheduleB.
Second is Schedule“A”. It is for vehicles that are not
operated under any of the conditions listed under Sched-
uleB.
Use the schedule that best describes your driving condi-
tions. Where time and mileage are listed, follow the
interval that occurs first.
NOTE:Under no circumstances should oil change
intervals exceed 6 months or 6,000 miles, whichever
comes first.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
At Each Stop for Fuel
•
Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•
Check tire pressure and look for unusual wear or
damage.
MAINTENANCE SCHEDULES 251
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, and transaxle and add as needed.
•Check all lights and all other electrical items for correct
operation.
•Check rubber seals on each side of the radiator for
proper fit.
At Each Oil Change
•
Change the engine oil filter.
•Inspect the exhaust system.
•Inspect the brake linings, hoses and calipers.
•Inspect the CV joints and front and rear suspension
components.
•Check the automatic transmission fluid level.
•Check the brake master cylinder fluid level.
•Check the coolant level, hoses, and clamps.
NOTE:In 2.7L Engines equipped with Flex Fuel Engine
(FFV), change engine oil every 5 months or 5,000 miles,
whichever comes first. This applies to both Maintenance
Schedule A and B.
252 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

About Your Brakes...................... 153
ABS (Anti-Lock Brake) System............. 153
Adding Engine Coolant (Antifreeze)......... 222
Adding Fuel.......................... 177
Adding Washer Fluid.................... 218
Additives, Fuel........................ 176
Aiming Headlights...................... 245
Air Cleaner, Engine (Engine Air Cleaner Filter) . 211
Air Conditioner Maintenance.............. 214
Air Conditioning....................128,134
Air Conditioning Controls................ 128
Air Conditioning, Operating Tips........133,139
Air Conditioning Refrigerant.............. 215
Air Conditioning System..............134,214
Air Pressure, Tires...................... 165
Airbag................................ 30
Airbag Deployment....................32,34
Airbag Light.....................33,35,45,91
Airbag Maintenance...................... 35
Alarm Light............................ 96
Alarm, Panic........................... 17
Alarm System........................19,96
Alignment and Balance.................. 171Alterations/Modifications, Vehicle............ 6
Antifreeze (Engine Coolant).........221,222,246
Capacities........................... 246
Disposal............................ 223
Anti-Lock Brake System (ABS)............. 153
Anti-Lock Warning Light.................. 94
Anti-Theft Security Alarm................. 19
Appearance Care....................... 229
Automatic Dimming Mirror................ 59
Automatic Door Locks..................14,15
Automatic Headlights.................... 70
Automatic Temperature Control............ 128
Automatic Transaxle.........147,149,198,227,248
Adding Fluid........................ 248
Filter.............................. 229
Fluid and Filter Changes................ 229
Fluid Level Check..................... 228
Interlock System....................10,148
Reset Mode......................... 149
Selection Of Lubricant...............227,248
Shifting............................ 149
Special Additives..................... 229
Autostick............................. 173
278 INDEX

Charging System Light................... 92
Chart, Tire Sizing....................... 157
Check Engine Light (Malfunction
Indicator Light)........................ 204
Checking Your Vehicle For Safety............ 44
Child Restraint...................35,38,40,41
Child Restraint Tether Anchors............. 40
Cigar Lighter.......................... 100
Circuit Breakers.....................236,237
Clean Air Gasoline...................... 175
Cleaning
Glass.............................. 233
Headlights.......................... 233
Instrument Panel..................... 233
WoodTrim .......................... 233
Climate Control........................ 128
Clock................................ 100
Coin Holder........................... 57
Compact Disc Changer................... 121
Compact Disc Maintenance............... 126
Compact Disc Player.................102,107
Compact Spare Tire..................... 167
Compass.............................. 97Compass Calibration..................... 98
Console............................... 57
Console, Floor.......................... 57
Contract, Service....................... 270
Convertible............................ 49
Convertible Boot........................ 52
Convertible Top......................... 49
Convertible Top Maintenance.............. 234
Coolant Pressure Cap.................... 222
Cooling System........................ 220
Adding Coolant (Antifreeze)............. 222
Coolant Capacity..................... 246
Coolant Level.....................220,223
Disposal of Used Coolant............... 223
Drain, Flush, and Refill................. 221
Inspection........................... 220
Points to Remember................... 223
Pressure Cap........................ 222
Radiator Cap........................ 222
Rubber and Plastic Components.......... 224
Selection of Coolant.............221,246,247
Corrosion Protection.................... 229
Crankcase Emission Control System......... 213
280 INDEX

Cruise Control (Speed Control)............. 74
Cruise Light........................... 91
Customer Assistance.................... 268
Daytime Running Lights.................. 70
Dealer Service......................... 205
Defroster, Rear Window.................. 137
Defroster, Windshield...............45,131,136
Diagnostic System, Onboard............... 203
Dimmer Control........................ 68
Dimmer Switch, Headlight................. 71
Dipsticks
Automatic Transaxle................... 228
Disposal
Antifreeze (Engine Coolant)............. 223
Engine Oil.......................... 210
Door Ajar Warning...................... 14
Door Locks............................ 12
Door Locks, Automatic................... 14
Door Opener, Garage..................... 77
Drive Belts............................ 210
Driving
On Slippery Surfaces.................. 196Electrical Outlet, Auxiliary................. 82
Electrical Power Outlets................... 82
Electronic Speed Control.................. 74
Emergency Brake....................... 151
Emergency, In Case of
Freeing Vehicle When Stuck............. 197
Jacking............................. 188
Jump Starting........................ 193
Overheating......................... 186
Towing............................. 197
Emergency Trunk Release...............21,22
Emission Control System Maintenance....204,250
Engine............................201,202
Air Cleaner Filter..................... 211
Block Heater......................... 146
Break-In Recommendations............... 43
Checking Oil Level.................... 206
Compartment.....................201,202
Coolant (Antifreeze)................220,247
Cooling............................ 220
Exhaust Gas Caution.................. 177
Fails to Start......................... 146
Fuel Requirements.................174,246
INDEX 281
10