cooling CHRYSLER SEBRING SEDAN 2005 2.G User Guide

Adding Coolant
When adding coolant, or refilling the system, a minimum
solution of 50% recommended HOAT ethylene glycol
engine coolant (antifreeze) and distilled water should be
used. Use higher concentrations (not to exceed 70%) if
temperatures below
34°F(
37°C) are anticipated.
Please note that it is the owner’s responsibility to main-
tain the proper level of protection against freezing ac-
cording to the temperatures occurring in the area where
the vehicle is operated.
Coolant Pressure Cap
The cap must be fully tightened to prevent loss of
coolant, and to insure that coolant will return to the
radiator from the coolant reserve tank.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.
WARNING!
The warning words“DO NOT OPEN HOT”on the
cooling system pressure cap are a safety precaution.
Never add coolant when the engine is overheated.
Do not loosen or remove the cap to cool an over-
heated engine. Heat causes pressure to build up in
the cooling system. To prevent scalding or injury, do
not remove the pressure cap while the system is hot
or under pressure.
CAUTION!
Be sure to use only the cooling system pressure cap
specified for your vehicle. Use of any other pressure
cap may result in decreased engine cooling system
performance and/or damage to your vehicle.
222 MAINTAINING YOUR VEHICLE

Disposal Of Used Engine Coolant
Used ethylene glycol based engine coolant is a regulated
substance requiring proper disposal. Check with your
local authorities to determine the disposal rules for your
community. Do not store ethylene glycol based engine
coolant in open containers or allow it to remain in
puddles on the ground. Prevent ingestion by animals or
children. If ingested by a child, contact a physician
immediately.
Coolant Level
The coolant bottle provides a quick visual method for
determining that the coolant level is adequate. With the
engine off and cold, the coolant level should be between
the“MIN”and“MAX”marks on the side of the coolant
bottle. Some darkening of the coolant bottle will occur
over time. This is normal. If the coolant level is hard to
see, jostling the coolant bottle will make it easier to see.
There is no need to remove the radiator cap unless
checking for coolant freeze point, adding, or replacing
coolant. Advise your service attendant of this. As long as
the engine operating temperature is satisfactory, thecoolant bottle need only be checked once a month. Heater
performance may also be adversely affected by low
coolant levels.
When additional coolant is needed to maintain the
proper level, it should be added to the coolant bottle. Do
not overfill. Special procedures are required when filling
the engine cooling system of the 2.7L Engine. See your
authorized dealer for details.
Points to Remember
NOTE:
When the vehicle is stopped after a few miles of
operation, you may observe vapor coming from the front
of the engine compartment. This is normally a result of
moisture from rain, snow, or high humidity accumulat-
ing on the radiator and being vaporized when the
thermostat opens, allowing hot water to enter the radia-
tor.
If an examination of your engine compartment shows no
evidence of radiator or hose leaks, the vehicle may be
safely driven. The vapor will soon dissipate.
•Do not overfill the coolant bottle.
MAINTAINING YOUR VEHICLE 223
7

•Check coolant freeze point in the system.
•If frequent coolant additions are required, or if the
level in the bottle does not drop when the engine cools,
the cooling system should be pressure tested for leaks.
•Maintain coolant concentration at 50% HOAT ethylene
glycol engine coolant (minimum) and distilled water
for proper corrosion protection of your engine which
contains aluminum components.
•Make sure that the radiator and coolant bottle hoses
are not kinked or obstructed.
•Keep the front of the radiator clean. If your vehicle has
air conditioning, keep the front of the condenser clean,
also.
•Do not change the thermostat for summer or winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory cooling performance, poor gas
mileage, and increased emissions.
Hoses and Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, checking, tears, cuts, abrasions,
and excessive swelling indicate deterioration of the rub-
ber.
Pay particular attention to those hoses nearest to high
heat sources such as the exhaust manifold. Inspect hose
routing to be sure hoses do not touch any heat source or
moving component that may cause heat damage or
mechanical wear.
Insure nylon tubing in these areas has not melted or
collapsed. Inspect all hose connections such as clamps
and couplings to make sure they are secure and no leaks
are present. Components should be replaced immedi-
ately if there is any evidence of degradation that could
cause failure.
Brakes
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in section 8.
224 MAINTAINING YOUR VEHICLE

Headlight Aiming
The headlights on your new vehicle were aimed at the
factory. The factory setting was made at a no load setting.
A great increase in weight will change the aiming and it
may be necessary to readjust the headlights if carrying an
excessive amount of weight in the trunk, rear seats or
pulling a trailer. To readjust the headlights first mark the
position of the headlights on a wall prior to loading the
vehicle. Load the vehicle and then readjust the headlights
to the original position. If any further adjustments are
necessary contact your manufacturer’s dealer. A detailed
service procedure is contained in the manufacturer’s
Service Manual. Information on purchasing a Service
Manual can be found at the back of this Owner’s Manual.
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate)
2.4 and 2.7 Liter Engines (87
Octane)16 Gallons 61 Liters
Engine Oil-With Filter
2.4 and 2.7 Liter Engines (Re-
fer to the engine oil fill cap
for the correct SAE grade)5 qts. 4.7 Liters
Cooling System *
2.4 Liter Engines* (Mopar
Antifreeze/Coolant 5 Year/
100,000 Mile Formula)8 qts. 7.5 Liters
2.7 Liter Engines (Mopar
Antifreeze/Coolant 5 Year/
100,000 Mile Formula)9.5 qts. 9.0 Liters
* Includes 1 qt. for coolant tank.
MAINTAINING YOUR VEHICLE 243
7

Charging System Light................... 91
Chart, Tire Sizing....................... 157
Check Engine Light
(Malfunction Indicator Light).............. 204
Checking Your Vehicle For Safety............ 48
Child Restraint...................40,43,45,46
Child Restraint Tether Anchors............. 45
Child Safety Locks....................... 18
Cigar Lighter........................... 99
Circuit Breakers........................ 234
Clean Air Gasoline...................... 175
Cleaning
Glass.............................. 232
Headlights.......................... 232
Instrument Panel..................... 233
WoodTrim .......................... 233
Climate Control........................ 126
Clock................................. 99
Coin Holder........................... 54
Compact Disc Changer................... 120
Compact Disc Maintenance............... 125
Compact Disc Player.................101,106
Compact Spare Tire..................... 167Compass.............................. 95
Compass Calibration..................... 97
Console............................... 54
Console, Floor.......................... 54
Contract, Service....................... 270
Coolant Pressure Cap.................... 222
Cooling System........................ 220
Adding Coolant (Antifreeze)............. 222
Coolant Capacity..................... 243
Coolant Level.....................220,223
Disposal of Used Coolant............... 223
Drain, Flush, and Refill................. 221
Inspection........................... 220
Points to Remember................... 223
Pressure Cap........................ 222
Radiator Cap........................ 222
Rubber and Plastic Components.......... 224
Selection of Coolant.............221,243,244
Corrosion Protection.................... 229
Crankcase Emission Control System......... 212
Cruise Control (Speed Control)............. 71
Cruise Light........................... 90
Customer Assistance.................... 268
280 INDEX

Daytime Brightness, Interior Lights.......... 65
Daytime Running Lights.................. 67
Dealer Service......................... 205
Defroster, Rear Window.................. 136
Defroster, Windshield...............49,130,135
Diagnostic System, Onboard............... 203
Dimmer Control........................ 64
Dimmer Switch, Headlight................. 68
Dipsticks
Automatic Transaxle................... 228
Disposal
Antifreeze (Engine Coolant)............. 223
Engine Oil.......................... 210
Door Ajar Warning...................... 17
Door Locks............................ 15
Door Locks, Automatic................... 17
Door Opener, Garage..................... 74
Drive Belts............................ 210
Driving
On Slippery Surfaces.................. 195
Electrical Outlet, Auxiliary................. 81
Electrical Power Outlets................... 81Electronic Speed Control.................. 71
Emergency, In Case of
Freeing Vehicle When Stuck............. 196
Jacking............................. 187
Jump Starting........................ 192
Overheating......................... 186
Towing............................. 196
Emergency Trunk Release...............24,25
Emission Control System Maintenance....204,246
Engine............................201,202
Air Cleaner Filter..................... 211
Block Heater......................... 146
Break-In Recommendations............... 48
Checking Oil Level.................... 206
Compartment.....................201,202
Coolant (Antifreeze)................220,244
Cooling............................ 220
Exhaust Gas Caution.................. 177
Fails to Start......................... 146
Fuel Requirements.................174,243
Oil ..........................206,243,244
Oil Change Interval................... 207
Oil Selection......................208,243
INDEX 281
10

Oil Synthetic......................... 209
Overheating......................... 186
Partial Zero Emissions Vehicle for 2.4 Liter . . 246
Timing Belt.......................... 212
Engine Oil Viscosity..................... 243
Entry System, Illuminated................. 15
Exhaust Gas Caution...............48,177,219
Exhaust System........................ 219
Exterior Light Service.................... 237
Filters
Air Cleaner.......................... 211
Automatic Transaxle................... 228
Engine Fuel......................... 211
Engine Oil.......................210,244
Engine Oil Disposal................... 210
Flashers
Hazard Warning...................... 186
Turn Signal.......................... 91
Flash-To-Pass........................... 68
Flat Tire Changing...................... 187
Flexible Fuel Vehicles.................... 181
Cruising Range....................... 184Engine Oil.......................182,209
Fuel Requirements.................... 182
Maintenance......................... 184
Replacement Parts.................... 184
Starting............................ 184
Floor Console.......................... 54
Fluid, Brake........................... 244
Fluid Capacities........................ 243
Fluid Leaks............................ 49
Fluid Level Checks...................... 228
Automatic Transaxle................... 228
Capacities........................... 243
Cooling System....................... 220
Engine Oil.......................... 206
Power Steering....................... 215
Fluids............................... 244
Fog Light Service....................... 240
Fog Lights........................67,92,240
Folding Rear Seat....................... 62
Freeing A Stuck Vehicle.................. 196
Fuel................................. 174
Adding............................. 178
Additives........................... 176
282 INDEX